Avision FL-1312B User manual

Sheet-fed Scanner
User’s Manual
Regulatory model: FL-1312B
manual-en-250-0878-E-AD230v1
Avision Inc.

User’s Manual
ii
Trademarks
Microsoft is a U.S. registered trademark of Microsoft Corporation.
Windows, Windows Vista, Windows 7 and Windows 8 are either
registered trademarks or trademarks of Microsoft Corporation in the
United States and/or other countries.
Energy Star®is a registered trademark of the U.S. government.
IBM, IBM PC are registered trademarks of International Business
Machines Corp.
Other brands and product names herein are trademarks or
registered trademarks of their respective holders.
Copyright
All rights reserved. No part of this publication may be
reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language or computer language, in
any form or by any means, electronic, mechanical, magnetic,
optical, chemical, manual, or otherwise, without the prior written
permission of Avision Inc.
Material scanned by this product may be protected by
governmental laws and other regulations, such as copyright
laws, the customer is solely responsible for complying with all
such laws and regulations.
Warranty
The information contained in this document is subject to
change without notice.
Avision makes no warranty of any kind with regard to this
material, including, but not limited to, the implied warranties
of fitness for a particular purpose.
Avision shall not be liable for errors contained herein or for
incidental or consequential damages in connection with the
furnishing, performance, or use of this material.

User’s Manual
iii
Federal Communications Commission (FCC) compliance
information statement
Part 15
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.

User’s Manual
iv
European Union Regulatory Notice
Products bearing the CE marking comply with the following EU
Directives:
Low Voltage Directive 2006/95/EC
EMC Directive 2004/108/EC
Restriction of the use of certain hazardous substances (RoHS)
Directive 2011/65/EU
CE compliance of this product is valid if powered with the correct
CE-marked AC adapter provide by Avision.
This product satisfies the Class B limits of EN55022, EN55024,
safety requirements of EN 60950 and ROHS requirements of
EN50581.
*This machine is certified as Class 1 LED product.

User’s Manual
v
Disposal of Waste Equipment by Users in Private Union
This symbol on the product or on its packaging indicates that the
product can not be disposed of with your other household waste.
Instead it should be sent to appropriate facilities for recovery
and recycling in an effort to protect human health and the
environment. Fore more information about where you can drop
off your waste equipment for recycling, please contact your local
city office, your household waste disposal service or the shop
where you purchased the product.
As an ENERGY STAR®Partner, Avision Inc. has
determined that this product meets the ENERGY
STAR guidelines for energy efficiency.
System Requirements
CPU:
Intel®Core™ 2 Duo or higher
Memory:
32 bit: 2 GB
64 bit: 4 GB
Optical Drive:
DVD-ROM Drive
USB Port:
USB port 2.0 (compatible with USB 1.1)
Compatible
Operating
System:
Microsoft Windows XP(SP3), Windows Vista,
Windows 7, Windows 8.x (32-bit/64-bit)

User’s Manual
vi
Product Safety Guide
Please clearly read all these instructions, and follow all instructions
and warnings before installing and using the device.
The following indications are used in this document to obviate any
chance of accident or damage to you and/or the device.
WARNING
Indicates potentially hazardous situations, which
if instructions are not followed, could result in
death or serious injury.
CAUTION
Indicates a potentially hazardous situation
which, if instructions are not followed, may
result in minor or moderate injury or damage to
property.
WARNING
Use only the AC power adapter that came with your device.
Using any other AC power adapter could cause fire, electrical
shock, or injury.
Use only the AC power cord and USB cable that came with your
device and avoid abrasions, cuts, fraying, crimping, and kinking.
Using any other AC power cord and USB cable could cause fire,
electrical shock, or injury.
Do not place objects on top of the AC power cord, and do not
allow the AC power adapter or the AC power cord to be stepped
on or run over.
Place the device and its AC power adapter near an electrical
outlet where the AC power adapter can easily be unplugged.
If you use an extension cord with the device, make sure that
the total ampere rating of the devices plugged into the
extension cord does not exceed the cord's ampere rating.
Place the device close enough to the computer so that the
interface cable can easily reach between the device and the
computer.

User’s Manual
vii
Do not place or store the device or its AC power adapter:
Outdoors
Near excessive dirt or dust, water, or heat sources
In locations subject to shocks, vibrations, high
temperature or humidity, direct sunlight, strong light
sources, or rapid changes in temperature or humidity
Do not use the device with wet hands.
Never disassemble, modify, or attempt to repair the AC power
adapter, device, or device option by yourself, except as
specifically explained in the device's documentation. This could
cause fire, electrical shock, or injury.
Do not insert objects into any opening, as they may touch
dangerous voltage points or short-out components. Beware of
electrical shock hazards.
Unplug the device and the AC power adapter, and refer
servicing to qualified service personnel under the following
conditions:
The AC power adapter or plug is damaged.
Liquid has entered the device or the AC power adapter.
Object has entered the device or the AC power adapter.
The device or the AC power adapter has been dropped,
or the case has been damaged.
The device or the AC power adapter does not operate
normally (i.e. appearance of smoke, strange smell, odd
noise, etc.), or exhibits a distinct change in performance
Unplug the device and the AC power adapter before cleaning.

User’s Manual
viii
CAUTION:
Do not locate the device on rackety or aslope tables. Do not
locate the device on unstable surface. The device may fall down
and this may result in injury.
Do not place heavy objects on the unit. It may cause unbalance
and the device may fall down. This may result in injury.
Store the AC Power cord/USB cable bundled out of the reach of
children to avoid the risk of injury.
Keep plastic bags bundled out of the reach of children or throw
them away to avoid the danger of suffocation.
If you are not going to use the device for a long period, unplug
the AC power adapter from the electrical outlet.

User’s Manual
ix
Table of Contents
1. Introduction ............................................................1-1
1.1 Package Items ..............................................1-1
1.2 Front View....................................................1-3
1.3 Rear View ....................................................1-4
2. Scanner Installation.............................................2-1
2.1 Precautions ..................................................2-1
2.2 Installing the Scanner Driver and Connecting
the Cables....................................................2-2
2.2.1 Connecting to Power ..................................2-2
2.2.2 Turning on the Power.................................2-3
2.2.3 Installing the Scanner Driver ...................2-3
2.2.4 Connecting to Computer............................2-5
3. Completing Your First Scan ...............................3-1
3.1 Loading Your Paper .......................................3-1
3.1.1 Notice on Using the ADF............................3-1
3.1.2 Loading Your Document in the ADF
Paper Tray ....................................................3-2
3.1.3 Scanning a Stack of Document with
Various sizes and Weights ........................3-8
3.2 Verifying Your Scanner Installation ................ 3-10
3.3 A Glance of the Scanner Properties Dialog Box 3-14
4. Using the Scanner Properties Dialog Box.....4-1
4.1 Buttons on the Scanner Properties Dialog Box...4-2
4.2 Showing or Hiding Tabs .................................4-4
4.3 The Image Tab .............................................4-6
4.3.1 The Image Selection Box...........................4-7
4.3.2 Other Image Options................................4-11
4.3.3 Scanning color images.............................4-23
4.3.4 Scanning grayscale images ....................4-23
4.3.5 Scanning B&W images .............................4-23

User’s Manual
x
4.3.6 Editing Profiles...........................................4-24
4.4 The Compression Tab .................................. 4-27
4.5 The Color Dropout Tab ................................. 4-29
4.5.1 Color Dropout Selection...........................4-29
4.6 The Paper Tab ............................................ 4-35
4.6.1 Cropping......................................................4-36
4.6.2 Other Paper Selection ..............................4-42
4.7 The Multi-Feed Detection Tab ....................... 4-48
4.8 The Preview Tab ......................................... 4-52
4.9 The Enhancement Tab ................................. 4-53
4.10 The Rotation Tab ..................................... 4-59
4.11 The Separation Tab.................................. 4-64
4.12 The Setting Tab....................................... 4-68
4.13 The Imprinter Tab ................................... 4-71
4.14 The Information Tab ................................ 4-75
5. ISIS Interface Operation....................................5-1
6. Using the Buttons .................................................6-1
6.1 Installing Button Manager V2..........................6-1
6.2 Checking the Button Configurations before
Scanning......................................................6-2
6.3 Scanning From One Touch of the Buttons .........6-4
7. Maintenance............................................................7-1
7.1 Cleaning the ADF ..........................................7-1
7.2 Cleaning the Glass ........................................7-4
7.3 Replacing the ADF Reverse Roller ....................7-5
7.4 Replacing the ADF Rollers ..............................7-8
8. Troubleshooting.....................................................8-1
8.1 Clearing a Paper Jam .....................................8-1
8.2 Questions and Answers ..................................8-2
8.3 Technical Service ..........................................8-4
9. Specifications .........................................................9-1
Index .....................................................................................a