Axor Citterio 39451 7 Series User manual

INSTALLATION
ZH ⁄ 用户手册 ⁄ 组装说明 02
EN ⁄ Instructions for use ⁄ Assembly instructions 03
Lesezeichen
中文 02
English 03
AXOR Citterio
39451XX7

02
安装 (参见第页 04)
ZH
安全技巧
装配时为避免挤压和切割受伤，必须戴上手套。
本产品只允许作为洗浴、卫生和洁身之用。
不得让儿童和肢体、精神和⁄或意识有障碍的成人
在不受监管的情况下使用淋浴系统。受酒精或毒
品影响的人员不得使用淋浴系统。
必须避免让身体敏感部位 (如眼睛) 接触到莲蓬头
喷水。必须保持莲蓬头与人头之间有足够的距
离。
该产品不得作扶柄使用。必须安装单独的扶柄。
冷热水管间过大的压力差必须予以平衡。
安装提示
⁄ 安装前必须检查产品是否受到运输损害。 安装后
将不认可运输损害或表面损伤。
⁄ 管道和阀门必须根据通用标准进行安装、冲洗和
检查。
⁄ 请遵守当地国家现行的安装规定。
⁄ 必须装上花洒所附带的滤网密封垫，以过滤管道
里的杂质污物。杂质污物会影响花洒的功能和⁄或
损坏花洒的功能部件，由此而产生的产品损坏不
属于汉斯格雅的保修范围。
技术参数
工作压强： 最大 1 MPa
推荐工作压强： 0,1 - 0,5 MPa
测试压强： 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
热水温度： 最大 60°C
热力消毒: 70°C ⁄ 4 分钟
该产品专为饮用水设计！
符号说明
请勿使用含有乙酸的硅胶！
热水和冷水连接头已调换 (参见第页 11 )
保养 (参见第页 )
大小 (参见第页 06)
流量示意图 (参见第页 07 )
备用零件 (参见第页 15 )
XX = 颜色代码
00 = 镀铬
34 = Brushed Black Chrome
99 = Polished Gold-Optic
选装附件 (不在供货范围内)
⁄ 加长件 60 mm #93882000 (参见第页 15 )
清洗 (参见第页 08)
操作 (参见第页 07)
问题 原因 补救
⁄龙头出水量小 ⁄ 花洒滤网有垃圾堵塞 ⁄ 清洗花洒和软管间的过滤网
⁄龙头不灵活 ⁄ 阀芯损坏，结垢 ⁄ 更换阀芯
⁄龙头滴水 ⁄ 阀芯损坏 ⁄ 更换阀芯
⁄水从龙头出水嘴流出 ⁄ O形环损坏 ⁄ 更换O形环
⁄龙头出水温度和温度设定的不符 ⁄ 热水和冷水连接头已调换 ⁄ 安装功能块时，旋转180º
(参见第页 11 )
⁄燃气热水器不工作 ⁄ 花洒滤网有垃圾堵塞 ⁄ 清洗花洒和软管间的过滤网
⁄ 手持花洒的流量限制器没有去除 ⁄ 去除流量限制器

03
ASSEMBLY (see page 04 )
EN
SAFETY NOTES
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
Children as well as adults with physical, mental and⁄or
sensoric impairments must not use this product without
proper supervision. Persons under the influence of
alcohol or drugs are prohibited from using this product.
Do not allow the streams of the shower touch sensitive
body parts (such as your eyes). An adequate distance
must be kept between the shower and you.
The product may not be used as a holding handle. A
separate handle must be installed.
The hot and cold supplies must be of equal pressures.
INSTALLATION INSTRUCTIONS
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective
countries must be observed.
⁄ The mesh washer must be insert to protect the shower
against incoming dirt by pipework. Incoming dirt leads
to defects or⁄and can damage parts of the shower;
such caused faults voids all liability and guarantee
claims.
TECHNICAL DATA
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 60°C
Thermal disinfection: 70°C ⁄ 4 min
The product is exclusively designed for drinking water!
SYMBOL DESCRIPTION
Do not use silicone containing acetic acid!
Hot and cold supplies are reversed
(see page 11 )
MAINTENANCE (see page )
DIMENSIONS (see page 06)
FLOW DIAGRAM (see page 07)
SPARE PARTS (see page 15 )
XX = Colors
00 = Chrome Plated
34 = Brushed Black Chrome
99 = Polished Gold-Optic
SPECIAL ACCESSORIES
(order as an extra)
⁄ extension 60 mm #93882000 (see page 15 )
CLEANING (see page 08)
OPERATION (see page 07)
FAULT CAUSE REMEDY
⁄ Insufficient water ⁄ Shower filter seal dirty ⁄ Clean filter seal between shower and
hose
⁄ Mixer stiff ⁄ Cartridge defective, calcified ⁄ Exchange cartridge
⁄ Mixer dripping ⁄ Cartridge defective ⁄ Exchange cartridge
⁄ Water escaping in area of swivel
spout
⁄ O-ring defective ⁄ Exchange O-ring
⁄ Spout temperature does not
correspond with temperature set
⁄ Hot and cold supplies are reversed ⁄ Install function block turned through
180º (see page 11 )
⁄ Instantaneous heater didn’t work ⁄ Shower filter seal dirty ⁄ Clean filter seal between shower and
hose
⁄ Flow limiter in handshower isn’t re-
moved
⁄ Remove flow limiter

04
1.
2.
3.
4.
6 x
(M10x35)
SW 8 mm
5.
104 52187
10 mm
SW 8 mm
1.
2.
1 2
3 4
Montage

05
> 2 min
1.
2.
3.
4.
SW 22 mm
(2 Nm)
SW 22 mm
silicone
5 6
7
8
Montage

06
Rp 1/2
Maße
AXOR Citterio
39451XX7

07
1
bar
4,5
0,0
0,5
1,0
1,5
2,0
2,5
3,0
3,5
4,0
5,0
0,45
0,00
0,05
0,10
0,15
0,20
0,25
0,30
0,35
0,40
0,50
5,50,55
6,00,60
036912 15 18 21 24 27 30
MPa
00,1 0,2 0,3 0,4 0,5
Q = l/min
Q = l/sec
2
1
关 ⁄ close开 ⁄ open 开 ⁄ open
热 ⁄ hot 冷 ⁄ cold
2.
3.
1.
2
Durchflussdiagramm BedienungDurchflussdiagramm
AXOR Citterio
39451XX7

08
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
⁄
Hansgrohe
Hansgrohe
www.hansgrohe-int.com/guarantee
QUICKCLEAN
QuickClean
Reinigung
QUICK
CLEAN
QUICK
CLEAN

09
CLEANING RECOMMENDATION FOR
HANSGR
OHE PRODUCTS
T
oday, modern sanitary and kitchen tapware, showers,
accessories,
washstands, tubs and radiators consist of very
differ
ent materials to comply with the needs of the market
w
ith regard to design and functionality.
T
o avoid damage and reclamations, it is necessary to
consider
certain criteria when cleaning.
W
ITH REGARD TO CARING FOR THE
HANSGR
OHE PRODUCTS, THE FOL-
LO
WING MUST IN PRINCIPLE BE
HE
EDED:
⁄ Only use cleaning material which is explicitly provided
for this type of application.
⁄ Never use cleaning materials, which contain hydrochlo-
ric acid, formic acid, chlorine pale lye or acetic acid, as
they cause considerable damage.
⁄ Phosphorus acidic cleaners are only conditionally
applicable.
⁄ Mixing cleaning agents is not permitted, generally.
⁄ Never use cleaning materials or appliances with an
abrasive effect, such as unsuitable cleaning powders,
sponge pads or micro fibre cloths.
⁄ The instructions of the cleaning agent manufacturers
have to be followed absolutely.
⁄ Cleaning has to be carried out with a specified cleaner
dosage, contact time, object-related and adapted to the
needs.
⁄ The building up of calcifications has to be removed by
cleaning regulary.
⁄ When using spray cleaners, spray the cleaning solution
onto a soft cloth or sponge, never directly onto the
Hansgrohe products, as the atomised spray could enter
openings and gaps in the Hansgrohe products and
cause damage.
⁄ After cleaning rinse thoroughly with clean water to
remove any cleaner residue.
⁄ The use of steam cleaners is not permitted. The high
temperatures can damage the products.
Important
Residues of toiletries such as liquid soaps, shampoos and
shower gels, hair dyes, perfumes, aftershave and nail
varnish can also cause damage.
Here too: Carefully rinse with water after use to remove
residues.
Likewise, do not store any cleaning agents or chemicals
under the products, for example in a vanity unit, as the
vapours may damage the products.
The damage of already damaged surfaces will deteriorate
under the effect of the cleansers.
Components with damaged surfaces must be
exchanged, otherwise there could be an injury
danger.
Damage caused by improper treatment will not be covered
by our guarantee.
WARRANTY
Hansgrohe guarantees to the consumer that this product is
free of production faults. If evertheless any defect is
detected within 5 years from date of purchase, Hansgrohe
will remedy this defect free of charge. You will find the
conditions and details of this guarantee at
www.hansgrohe-int.com/guarantee. Please contact your
contracting party to claim your rights under this guarantee.
This guarantee does not affect the customer‘s rights under
the respective national legislation.
QUICKCLEAN
The QuickClean cleaning function only needs a small
manual rub over to remove the lime scale from the spray
channels.
Reinigung
QUICK
CLEAN
QUICK
CLEAN

10
> 1 min
1.
2.
max. 10 min
20 mm
1 2
3 4
5 6
Reinigung

11
1.
2.
1.
2.
SW 8 mm
SW 6 mm
2.
1.
180°
1 2
3 4
5
Vertauschte Anschlüsse

12
2.
1. 12
12
9
1.
2.
6 7
8 9
10 11
Vertauschte Anschlüsse

13
180°
1.
4.
2.
3.
6x
(M10x35)
SW 8 mm
1.
2.
SW 6 mm
(6 Nm)
1.
2.
12
Vertauschte Anschlüsse

14
1 2
3 4
5
Wartung

15
39091000
98164000
(33x1, 5)
98186000
(30x2)
974 6 6X X 0
(M6x6)
97157000
95871XX0
97978000
98058000
96466XX0
97979XX0
28272XX0
93981XX0
97670000
(M10x35)
98162000
(44x2,5)
98371000
(29x3)
94246000
93339007
96339000
97980000
94409XX7
93882000
(60 mm)
98419000
(7x2)
Serviceteile
AXOR Citterio
39451XX7

06/2021 9.04303.54
AXOR ⁄ Hansgrohe SE
Auestraße 5–9
77761 Schiltach
Deutschland
[e-mail]
axor-design.com