
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially
when children are present, basic safety
precautions should always be taken,
including the following:
DANGER – To reduce the risk of electric
shock:
1. Always unplug this appliance
immediately after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it
can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or any
other liquids.
5. WARNING: Do not use this
appliance near bathtubs,
showers, basins or other
containing water.
WARNING – To reduce the risk of burns,
electrocution, fire, or injury to persons:
1. An appliance should never be left
unattended when plugged in.
2. Do not pull, twist or wrap line cord
around appliance
3. This appliance should not be used by,
on, or near children or individuals with
certain disabilities.
4. Use this appliance only for its intended
use as described in this manual. Do not
use attachments not recommended by
BaBylissPRO.
5. Do not use the appliance if the cord
is damaged. In the event of damage
discontinue use immediately. If the
supply cord is damaged, it must
be replaced by manufacturer or its
service agent or similarly qualified
persons in order to avoid a hazard.
6. Keep the cord away from heated surfaces.
7. Never block the air openings of the
appliance or place it on a soft surface,
such as a bed or couch, where the air
openings may be blocked. Keep the air
openings free of lint, hair, and other
obstructions.
8. Never use while sleeping.
9. Never drop or insert any object into any
opening or hole.
10. Do not use outdoors or operate where
aerosol (spray) products are being used
or where oxygen is being administered.
11. Do not use an extension cord with this
appliance.
12. Do not touch heat sink that holds rollers,
as it will be hot.
IMPORTANT!
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for
their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
• When the appliance is used in a bathroom,
unplug it after use since the proximity of
water presents a hazard even when the
appliance is switched off.
• For additional protection, the installation
of a residual current device (RCD) with
a rated operating current not exceeding
30mA is advisable in the electrical current
circuit supplying the bathroom. Ask your
installer for advice.
HOW TO OPERATE YOUR HOT
ROLLERS:
1. Place hot rollers on a firm, flat surface.
With the lid on, plug cord into outlet. This
appliance is designed to operate at 220-
240V ~ (50-60Hz).
2. Once plugged in, turn the unit on by
switching it to the ON position. The rollers
will heat up quickly.
3. Allow rollers to heat with lid on, as this
will provide the fastest, most efficient
heat-up. Once the rollers are hot — the
Ready Indicator light on the front of
the stand will turn green and the Heat
Sensor dot on one of the rollers will turn
white — you can begin setting your hair.
Allow rollers to heat longer for tighter
curls. Never leave your hot rollers on and
unattended. Always unplug the hot rollers
when not in use. Allow the hot rollers to
cool down after use, and store in a safe
place.
4. Hair should be clean and dry or slightly
damp – never wet when setting. For
further instruction, please refer to HOW
TO CURL YOUR HAIR.
HOW TO CURL YOUR HAIR
1. Place ends of hair on roller and wind
toward the scalp. Roll hair up firmly, and
secure pin, crossing over roller. Do not
place pin in roller slit.
2. The firmness of the curl is regulated by
the roller temperature and the length of
time the roller is left in your hair.
3. For tight, firm curls, leave rollers in
the hair for at least 10 minutes before
removing. For soft, wavy curls, the rollers
should be removed from the hair after a
shorter period of time.
4. Removing rollers: Hold roller in one hand
while removing pin with the other. Gently
drop roller (do not pull) and let curl bounce
back after roller has been completely
removed. Repeat with remaining rollers.
Let hair cool for one minute for firmly set
curls and then style your hair into a look
that lasts for hours.
Important: After using the hot rollers several
times, you will find the best timing for the
texture of your hair and for the result you
desire.
CERAMIC TECHNOLOGY!
These innovative Standing Hot Rollers
feature ceramic technology to ensure even,
consistent, and gentle far-infrared heat that
creates long-lasting and voluminous curls.
USER MAINTENANCE
This product represents the highest
standards of workmanship and engineering
research. Your hot roller set is designed for
professional or household use and is virtually
maintenance free.
If cleaning becomes necessary, disconnect
the appliance from the power source. Allow
the setter to cool. Clean the unit and the
heat sink with a cloth. Occasionally, you may
want to clean your rollers. Use a damp cloth
and mild detergent or soap. If any abnormal
condition occurs, unplug the hot roller set,
allow it to cool, and return it to an authorized
service representative for repair.
STORAGE
Allow hot rollers to cool. Handle cord carefully
for longer life; avoid jerking or straining at
plug connections. Place hot rollers out of
reach of children in a safe, dry location.
CAUTION
NEVER allow the power-supply cord to be
pulled or twisted. Never wrap the cord
around the unit. Damage will occur at the
high flex point of entry into the unit, causing
it to rupture and short circuit. Inspect the
cord frequently for damage. Stop use
immediately if damage is visible or if unit
stops or operates intermittently.
2 3
B16SHRA_IB.indd 2B16SHRA_IB.indd 2 2023/12/11 07:402023/12/11 07:40