BaByliss BIG HAIR 2775U User manual

Model 2775U
BIG HAIR

BIG HAIR
The BaByliss Big Hair air styler is perfect for adding gorgeous volume
and shine to styles. The large ceramic barrel gives fullness and body as
you style whilst the soft bristles create ultimate shine and smoothness.
FEATURES
• 700W
• 50mm ceramic barrel with soft brush bristles
• High shine ionic conditioning
• 2 heats plus a cool setting
• 2 rotation speeds for total control
• Multi-directional brush
• Hinged rear lter
• Protective cover
• 2.5m longer length cord
• 3 year guarantee
SAFETY CAUTIONS
• This appliance should only be used as described within
this instruction booklet. Please retain for reference.
WARNING! Polythene bags over product or packaging
may be dangerous. To avoid danger of suffocation, keep
wrapper away from babies and children. These bags are
not toys.
• UK Only: This appliance must not be used in the
bathroom. If using the appliance in a bathroom, unplug
after use as the proximity of water can be dangerous

even if the appliance is switched off. For additional
protection the installation of a residual current device
(RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
WARNING! Do not use this appliance near water
contained in basins, bathtubs or other vessels.
• Do not use this appliance in the bathroom.
• Do not immerse the appliance in water or other liquids.
• Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged or if the
appliance has been dropped. In the event of damage
contact the Conair Customer Care Line (refer to ‘UK
After Sales Service’ section for further information).
• Do not use the appliance if the lead is damaged. In
the event of damage contact the Conair Customer
Care Line (refer to ‘UK After Sales Service’ section for
further information).
• Do not leave the appliance unattended when switched
on or plugged in.
• This appliance is equipped with a safety thermostat.
In the event of overheating the appliance will stop
automatically. Should this happen, push the speed
switch on the handle to the “0” position to switch off,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear lter is clear of hair and other debris.
Plug in and switch on. If the appliance continues to
overheat discontinue use immediately, switch off and
unplug. Contact the Conair Customer Care Line (refer
to the ‘UK After Sales Service’ section for further
information).

• Do not place the appliance on any heat sensitive
surface whilst in operation.
• Take care to avoid the hot surface of the appliance
coming into direct contact with the skin, in particular
the ears, eyes, face and neck.
• This appliance should not be used by adults whose
reduced physical, sensory or mental capabilities,
or whose lack of experience and knowledge, might
cause a hazard, unless they have been correctly
instructed to understand the safe use and hazards
involved and are adequately supervised.
• Careful adult supervision is required when this
appliance is used on or near children. Do not use on
very young children.
• This appliance should not be used, cleaned or
maintained by children. Keep out of reach of children.
• Always ensure that this appliance is kept out of the
reach of children at all times, particularly during use
and whilst cooling.
• After use, do not coil the lead around the appliance
as this may cause damage to the lead. Instead, coil
the lead loosely by the side of the appliance.
• This appliance complies with the requirements
of Directives 2004/108/EC (Electromagnetic
Compatibility) and 2006/95/EC (Electrical Safety of
Domestic Appliances).

Ionic Technology
Many aspects of modern living, including air conditioning, contact with
man-made bres and air pollution contribute to a build-up of static
electricity in the hair. Even brushing and towel drying the hair can
increase these levels, causing the surface of the cuticle to become
rough. Consequently, hair may have a dull appearance. Also high
levels of static charge cause hair to become “y-away” and difcult to
style. The ion generator produces a stream of negative ions which act
to neutralise the static charge, smoothing the scales on the cuticle for
shiny, smooth and manageable hair so you can achieve your desired
style easily.
Heat Settings
There are 2 heats plus a cool setting. Use the high heat setting for initial
drying, and the low heat setting as hair begins to dry and for styling.
Use the cool setting to set the style for long lasting results. Slide the
‘on/off’ switch to the rst position to select the cool setting ‘*’, the
second position for the low heat ‘I’, and the third position for the high
heat ‘II’.
Rotation Settings
There are two rotation speed settings. To make the brush head rotate,
press the buttons marked << and >>, these will make the brush head
rotate clockwise and anticlockwise. When the appliance is set on
the high heat setting the brush head rotation will be faster. When the
appliance is set on the low heat setting the brush head rotation will be
slower. For best results, use the rotating brush feature to create styles
with gorgeous volume and shine.
NOTE: When the appliance is used on the cool setting, the brush head
will not rotate.
Protective Cover
After every use, always ensure the protective cover is placed over the
brush head. This protects the bristles from damage. When placing
the protective cover over the brush head, ensure to line it up with the

grooves around the top of the airstyler so it slides easily into place.
NOTE: The diagram on the protective cover demonstrates the direction
it should be placed on to the brush head. If placed on incorrectly it may
be difcult to remove.
INSTRUCTIONS FOR USE
• If you have long or thick hair, you may nd it quicker and easier to
use a hairdryer rst, to rough dry your hair and remove the excess
moisture. For added volume, turn your head upside down as you dry.
• Once the hair is 80% dry, you should start to create your style using
the styler.
Maximum Volume and Body
1) Start by sectioning the hair.
2) To turn the appliance on, slide the ‘on/off’ switch to the correct heat
setting for your hair.
3) Place the appliance into the hair, close to the roots and brush through
the section to remove any tangles.
4) For added root lift, hold the brush in place at the root for a few
seconds.
5) Move the brush through the hair, towards the ends and as you reach
the end of the section, start to rotate the brush away from your head
by pressing and holding the appropriate rotation button.
6) As you do this, resist the rotation of the brush by pulling the brush
downwards. This will create tension through the section of hair.
IMPORTANT! It may take several attempts to perfect this technique,
if the brush spins too quickly, simply release the rotation button and
remove from the hair.
7) For even more volume, place the brush at the end of the hair section
and allow the brush to rotate along the hair section by pressing and
holding the appropriate rotate button. Wind the entire section of hair
around the barrel until you reach the root. Release the rotate button
and then leave the brush in the hair for a few seconds.
8) Slide the switch to the cool setting ‘*’ for a further few seconds, this

creates long, lasting volume.
9) To release the section, move the switch back to setting ‘I’ or ‘II’
then press and hold the opposite rotation button to unwind the hair
section.
10) Repeat as necessary.
11) After use, switch off and unplug the appliance.
12) Allow to cool before storing away.
13) Place protective shield over brush head to protect the bristles.
Please see the ‘Protective Cover’ section for direction.
Helpful Hints and Tips
• To dene layers and add shape to the ends of the hair, follow steps
5 - 6 and repeat through the sections.
• To get root volume and body through the top section of hair, follow
steps 7 - 9 using an upward motion.
CLEANING & MAINTENANCE
To help keep your appliance in the best possible condition follow the
steps below:
General
• Do not wrap the lead around the styler, instead coil the lead loosely
by the side of the dryer.
• Do not use the styler at a stretch from the power point.
• Always unplug after use.
Cleaning & Maintenance
• Unplug the appliance and let cool completely before cleaning it.
• Holding the handle of the appliance rmly pull the top of the rear lter
towards you, this will enable the rear lter to open.
• Using a soft brush, clean any hair and other debris from the lter.
• Replace the rear lter by pushing back into position.
• To clean the outside of the styler, wipe with a damp cloth. Make sure
no water enters the styler and it is completely dry before use.

UK GUARANTEE
This BaByliss appliance is guaranteed for consumer use for 3 years. This
guarantee covers defects under normal use from date of purchase and
ceases to be valid in the event of alteration or repairs by unauthorised
persons. If the appliance does not perform satisfactorily due to defects
in materials or manufacture, it will be repaired or replaced through
Conair UK After Sales Service. The Conair Group Ltd reserves the right
to amend terms and specications without prior notice.
This guarantee in no way affects your statutory rights.
UK AFTER SALES SERVICE
For further advice on using the appliance, contact the Conair
Customer Care Line on 0870 5 133191 (09:00 to 17:00 Monday to
Friday) or email your enquiry to [e-mail]
If you should need to return your appliance to us please send it to the
following address:
Customer Care Centre,
Conair Logistics
Unit 4
Revolution Park
Buckshaw Avenue
Buckshaw Village
Chorley
PR7 7DW
Please enclose your name and address, together with a copy of proof
of purchase and details of the fault.

UK WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the
following code:
BLUE = NEUTRAL
BROWN = LIVE
• The wire which is coloured BLUE must be connected to the terminal
which is marked with the letter N.
• The wire which is coloured BROWN must be connected to the terminal
which is marked with the letter L.
• Neither core should be connected to the earth terminal of a three pin
plug marked with the letter E or .
This appliance comes tted with a British Standard 13 amp type plug and
a 13 amp fuse. It is important to always use a 13 amp fuse, should its
replacement be required. If any other type of plug is used, a 5 amp fuse
must be tted at the distribution board.