Bacharach Fyrite INTECH User manual

P/N: 0024-9513
Revision 0
February 23, 2016
COMBUSTION GAS ANALYZER
QUICK START GUIDE
PREPARE CONFIGURE MAINTAIN
Review funcons and locaons of
key components (1 through 20)
Connect the probe (14 to 11, and
15 to 13)
Turn on the instrument (9)
Verify power (1)
Access and navigate the menus Replace sensors as needed
1 Display with backlight
2 Funcon keys
3-6 Navigaon keys
7 Enter key
8 Escape key
9 Power/backlight key
10 Run/hold key
11 T-Stack port
12 USB port
13 Sample gas port
14 Sample gas
thermocouple (T-Stack)
connector
15 Sample gas hose
16 USB cable (Oponal)
17 Locaon of oponal
NOx filter
18 Water trap and
filter assembly
19 Probe handle
20 Probe tube
Select fuel type
Use default configuraon values or
navigate to Setup Menu to set
combuson test parameters
Calibrate as needed
Replace baeries as needed
Replace water trap (18) filter as
needed
Baery
Compartment
T-STACK
GAS
USB
Leave Top
Port Open
CALIBRATION GAS
500 PPM CO
FLOW METER
This quick start guide provides basic infor-
maon. For safety warnings, addional
instrucons, and more detailed informa-
on, refer to the Configuraon and Opera-
on manual (part number 0024-9486)
available at www.MyBacharach.com.
T-STACK
GAS
USB
BOTTOM
VIEW
Filter
Wait for warm-up to complete
Full
Medium
Low
Replace
O2 Cap
O2Sensor
Slot
Nub
CO
Cap
Printed Circuit Board
CO Sensor
Open
Closed

World Headquarters
621 Hunt Valley Circle
New Kensington, PA 15068 USA
Phone: [phone] • Fax: [phone]
Toll Free: 1-800-736-4666
Website: www.MyBacharach.com
E-mail: [email protected]
TEST ADJUST FINISH
Insert probe at the appropriate sampling point based on equipment type (be sure to avoid
diluon of the gas sample) Review all combuson data from
various sources:
• Hold Screen
• Data previously saved to memory
(oponal)
• Printout (oponal)
Allow instrument to purge aer a
test
Start (RUN) and Stop (HOLD) Test
Forced Air Furnace Hot Water Tank Condensing Furnace
or Boiler
Fan Assist or
Power Vented
Furnace or Boiler
Boiler
O2, CO, Stack Temp
Undiluted
Flue Gas
O2, CO, Stack Temp Combuson Air O2, CO, Stack Temp O2, CO, Stack TempO2, CO, Stack Temp
Print data (F1 buon) and/or Save data
(F3 buon) to memory if desired
Run Nat Gas
T-STK 374 °F
T-Air 68 °F
EA 44.8 %
CO(0) 116 ppm
Run Nat Gas
O
2
7.0 %
CO 107 ppm
Eff 80.9 %
CO
2
7.9 %
Toggle
Between
Run and
Hold Modes
Scroll Bar
Indicates
More Items
Print
Screen
Display
Main
Menu
Save Results
to Memory
161
8 to 16 in.
(20 to 41 cm)
Made in USA
IrDA
Printer
Adjust combuson equipment as
needed based on combuson data
and manufacturer recommendaons
for the combuson device under test
Retest combuson device to verify
proper/opmal operaon
Hold Nat Gas
O
2
7.0 %
CO 107 ppm
Eff 80.9 %
CO
2
7.9 %
BACHARACH, Inc.
InTech
SN: AB1234
Time: 12:25:41
Date: 02/8/16
Fuel
NGAS
O 7.0 %
CO 107 ppm
Lambda 1.5
CO 7.8 %
CO Max 11.8 %
T-STK 190 C
T-AIR 20.0 C
qA 9.5 %
Eta 90.5 %
Eff 80.9 %
CO/CO2 0.0014
CO(O) 161 ppm
AVG SMOKE ***
OIL DERIV ***
BOILER TEMP *** C
=========================
-------------------------
Comments:
2
2
O
O
2
O
Bridge Street HVAC
Outer Kensington West
London,ENG SW1J 3
RE-TEST
BACHARACH, Inc.
InTech
SN: AB1234
Time: 12:25:41
Date: 02/8/16
Fuel
NGAS
O 7.0 %
CO 107 ppm
Lambda 1.5
CO 7.8 %
CO Max 11.8 %
T-STK 190 C
T-AIR 20.0 C
qA 9.5 %
Eta 90.5 %
Eff 80.9 %
CO/CO2 0.0014
CO(O) 161 ppm
AVG SMOKE ***
OIL DERIV ***
BOILER TEMP *** C
=========================
-------------------------
Comments:
2
2
O
O
2
O
Bridge Street HVAC
Outer Kensington West
London,ENG SW1J 3
Turn off instrument (hold PWR key)
Disconnect probe
Clean then store the instrument and
probe.
Right Arrow
Displays QR
Code for
Reporng App
Up and Down Arrows
Scroll Display
(North
American
Version Only)
(Sample Printout
from Siegert Version)