Bartscher 114356 User manual

- 1 -
114.356
114.357
Bedienungsanleitung
Elektro-Warmhalteplatte
Seiten 3 bis 14
Instruction manual
Electric warming tray
from page 15 to 26
Mode
d’
emploi
Plaque chauffante électrique
de page 27 à page 38
V4/0512
F/B/CH
GB/UK
D/A/CH

- 15 -
1. General Information 17
1.1 Information about the instruction manual 17
1.2 Key to symbols 17
1.3 Liability and Warrantees 18
1.4 Copyright protection 18
1.5 Declaration of conformity 18
2. Safety 19
2.1 General information 19
2.2 Safety instructions for use of the device 19-20
2.3 Intended use 20
3. Delivery, packaging and storage 21
3.1 Delivery check 21
3.2 Packaging 21
3.3 Storage 21
4. Technical data 22
5. Installation and operation 22
5.1 Safety instructions 22-23
5.2 Installation and connection 23
5.3 Operating 23-24
6. Cleaning and maintenance 25
6.1 Safety advice 25
6.2 Cleaning 25
6.3 Safety instructions for maintenance 25
7. Waste disposal 26
Bartscher GmbH
Franz-Kleine-Str. 28
D-33154 Salzkotten phone: [phone]
Germany fax: [phone]
GB/UK
Keep this instruction manual
ready to hand at the product!

- 16 -

- 17 -
1. General information
1.1 Information about the instruction manual
This instruction manual contains information about the installation, operation and
maintenance of the device and should be consulted as an important source of
information and reference guide.
Awareness of the safety instructions and instructions for use in this manual will ensure
the safe and correct use of the device.
In addition to the information given here, you should comply with any local Health and
safety Controls and generally applicable safety regulations.
The instruction manual forms part of the product and should be kept near the device
and easily accessible for anyone carrying out the installation, servicing, maintenance
or cleaning.
1.2 Key to symbols
In this manual, symbols are used to highlight important safety instructions and any
advice relating to the device. The instructions should be followed very carefully to avoid
any risk of accident, personal injury or material damage.
WARNING!
This symbol highlights hazards, which could lead to injury.
Please follow the instructions very carefully and proceed with particular attention
in these cases.
WARNING! Electrical hazard!
This symbol draws attention to potential electrical hazards. If you do not follow
the safety instructions, you may risk injury or death.
CAUTION!
This symbol highlights instructions, which should be followed to avoid any risk
of damage, malfunctioning and/or breakdown of the device.
NOTE!
This symbol highlights tips and information, which have to be followed for
an efficient and trouble-free operation of the device.
WARNING! Hot external surface!
This symbol is a warning that the device surface is hot when in use. Ignoring this
warning may result in burns!

- 18 -
1.3 Liability and Warrantees
All the information and instructions in this manual take into account standard safety
regulations, current levels of technical engineering as well as the expertise and
experience we have developed over the years.
The instruction manual was translated with all due care and attention. However, we do
not accept liability for any translation errors. The German version of this instruction
manual is definitive.
If the delivery consists of a special model, the actual scope of delivery may differ from
the descriptions and illustrations in this manual. This is also the case for special orders
or if the device has been modified in line with new technology. If you have any
questions, you should contact the manufacturer.
NOTE!
Read the instruction manual carefully before using the device. The manufacturer
does not accept liability for any damage or malfunction resulting from not
following the instructions for use.
The instruction manual should be kept near the device, easily accessible for anyone
wishing to work with or using it. We reserve the right to make technical changes for the
purpose of developing and improving its useful properties.
1.4 Copyright protection
The instruction manual including any texts, drawings, images or other illustrations is
copyrighted. No part of this publication may be reproduced, transmitted or used in any
form or by any means without permission in writing from the manufacturer. Any person
committing an unauthorized act in relation to this publication shall be liable to claims for
damages. All rights reserved.
NOTE!
The contents, texts, drawings, pictures and any other illustrations are copyrighted
and subject to other protection rights. Any person unlawfully using this
publication is liable to criminal prosecution.
1.5 Declaration of conformity
The device complies with the current standards and directives of the EU.
We certify this in the EC declaration of conformity.
If required we will be glad to send you the according declaration of conformity.

- 19 -
2. Safety
This section provides an overview of all important safety aspects.
In addition, every chapter provides precise safety advice for the prevention of dangers
which are highlighted by the use of the above-mentioned symbols.
Furthermore, attention should be paid to all pictograms, markers and labels on the
device, which must be kept in a permanent state of legibility.
By following all important safety advice, you will gain an optimal protection against all
hazards as well as the assurance of a safe and trouble-free operation.
2.1 General Information
This device is designed in accordance with the presently applicable technological
standards. However, the device can pose a danger if handled improperly and
inappropriately.
Knowing the contents of the instruction manual as well as avoiding mistakes, and thus
operating this device safely and in a fault-free manner, is very essential to protect
yourselves from any hazards.
To prevent hazards and to ensure optimum efficiency, no modifications or alterations to
the device that are not explicitly approved by the manufacturer may be undertaken.
This device may only be operated in technically proper and safe condition.
2.2 Safety instructions for use of the device
The specifications regarding industrial safety are based on the Regulations of the
European Union applicable at the time of manufacturing the device.
If the device is used commercially, the user is obliged to ensure that the said industrial
safety measures concur with the state of the rules and regulations applicable at the time
in question for the entire period of use of the device, and to comply with the new specifi-
cations. Outside the European Union, the industrial safety laws applicable at the place of
installation of the device and the regional territorial provisions must be complied with.
Besides the industrial safety instructions in the instruction manual, the general safety
and accident prevention regulations as well as environment protection regulations
applicable for the areas of application of the device must be followed and complied with.

- 20 -
CAUTION!
oThe device is not intended for use by individuals (including children) with physical or
mental disabilities, insufficient experience, and/or insufficient knowledge unless such
persons are under the care of a person responsible for their safety or have received
instructions regarding appropriate use of the device.
oChildren should be observed to ensure that they are not playing with the device.
oPreserve this manual safely. When passing on/selling the device to a third party, the
manuals must be handed over along with the device.
oEvery person using the device must act in accordance to the manuals and under
consideration of the safety advice.
oThe device is to be used indoors only.
2.3 Intended use
Safe operation is only guaranteed when using the device for its intended purpose.
Any technical interventions, as well as assembly and maintenance are to be made by a
qualified customer service only.
The electric warming tray is intended for keeping the heat of foodstuffs with
the use of suitable containers.
Do not use the electric warming tray for:
-heating rooms;
-heating or warming up liquids or substances which are inflammable, harmful to
health, those that evaporate easily etc.
CAUTION!
Any use going beyond the intended purpose and/or any different use of the
device is forbidden and is not considered as conventional.
Any claims against the manufacturer or his authorized representative as a
consequence of experiencing damages resulting from unconventional use
are impossible.
The operator is liable for all damages resulting from inappropriate use.

- 21 -
3. Transport, packaging and storage
3.1 Delivery check
Please check the delivery for completeness and transport damage immediately
after receipt. In case of visible damage, do not accept or accept the delivery with
reservation only.
Note the extent of damage on the carrier’s bill of delivery and notify us of any
recorded damage.
Hidden damages should be reclaimed immediately after detection, as claims for
damages can only be asserted within the effective period for complaints.
3.2 Packaging
Please do not throw away the covering carton of your device as it might be useful for
storage purposes, when moving or, in case of damages, when the device must be sent
back to a repair center. The outer and inner packing material should be removed
completely from the device before installation.
NOTE!
Observe the regulations applicable in your country when disposing of the
packaging. Supply re-usable packing materials to the recycling centre.
Please inspect the device for completeness. In case any part is missing, please
contact our customer service center immediately.
3.3 Storage
Keep the package closed until installation and under consideration of the positioning-
and storage markings indicated on the outside.
Packages should be stored under consideration of the following:
-Do not store outdoors.
-Keep it dry and dust-free.
-Do not expose it to aggressive media.
-Do not expose it to direct sunlight.
-Avoid mechanical shocks and vibrations.
-In case of longer storage (> 3 months), make sure you
check the state of the packaging and the parts regularly.
If required, refresh or renew.

- 22 -
4. Technical data
Description Electric warming tray
Item no.:
114.356 (for GN 1/1) 114.357 (for GN 2/1)
Model: Body aluminium, surface glass
Temperature control: Infinitely variable, approx.30°- 95°C
Connection: 230 V ~ 50 Hz 150 W 230 V ~ 50 Hz 300 W
Dimensions: W 570 x D 305 x H 40 mm W 666 x D 550 x H 40 mm
Weight: 3.45 kg 6.1 kg
Subject to technical changes and alterations!
5. Installation and operation
5.1 Safety instructions
WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
•See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
WARNING! Hot external surface!
During operation some elements of the device very become hot.
To avoid burns, do not touch hot elements!
•Do not use the device in case it does not function properly, has been damaged or
dropped.
•Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the device
or personal injury, and further, the warranty expires.
•Do not lay the cable over carpets or heat insulations. Do not cover the cable.
Keep away the cable from operating range and do not dunk it into water.

- 23 -
•Do not move or tilt the device when in operation.
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!
5.2 Installation and connection
•Discard the complete packing material after unpacking the device.
•Place the device on top of an even and safe surface which supports the weight of the
device and is not heat sensitive.
•Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
5.3 Operating
•Clean the electric warming tray with a damp, soft cloth before first use.
Dry it thoroughly afterwards.
•Connect the device to an appropriate single power socket.
•Engage the warming tray using the toggle switch which can be found at the backside
of the device.
•Set the desired temperature (up to 95°C) using the turning knob. The red control
lamp flashes up.
•The red control lamp distinguishes after the set temperature has been reached.
When the warming tray cools down the red control lamp flashes up again and tray
will be heated up. This function prevents the warming tray from overheating.

- 24 -
WARNING! Danger of burn!
The surface of the device becomes very hot during operation.
Never touch the hot surfaces with your bare hands.
CAUTION!
The board keeping heat is not suitable for cooking or keeping the heat of
dishes directly on the board. Use suitable containers!
•Fill the desired foods into the appropriate GN-container (GN 1/1 or GN 2/1) and
place it on the warming tray. Cover it with a lid.
NOTE!
The foods may be kept warm for a longer period when covered appropriately.
•Make sure the warming tray is stands on top of an even and stable surface before
placing foods on it, in order to avoid a tipping over of the containers with foods.
CAUTION!
You must never move the warming tray with foods on top but remember to
remove the foods first!
Use safety gloves when removing the containers!
Move the warming plate using the provided handles.
•When the device is not in use, disconnect it from the power socket (pull the power
plug!).

- 25 -
6. Cleaning and care
6.1 Safety advice
oBefore beginning with repair or cleaning works make sure the device has been
disconnected from the power socket (pull the power plug!!!) and has cooled down.
oDo not use any acid agents and make sure no water ingresses the device.
oTo protect yourself from electric shock, never immerse the device, its cables and
the plug in water or other liquids.
CAUTION!
The device is not suited for direct washing via water jets. Therefore, you must not
use any kind of pressure water jet for cleaning the device!
6.2 Cleaning
oThe device should be cleaned regularly.
oClean the electric warming tray with a damp and soft cloth.
oNever use aggressive cleaning agents and liquids that are bleaching or contain
alcohol.
oOnly use a soft cloth and make sure you never use any kind of abrasive agents or
pads which could scratch the surface.
oAfter the cleaning procedure, you should use a soft and dry cloth to wipe dry and
polish the surface.
6.3 Safety instructions for maintenance
oCheck the mains connection cable for damage from time to time. Never operate the
device when the cable is damaged. A damaged cable must immediately be replaced
by customer service or a qualified electrician to avoid dangers.
oIn case of damage or malfunction, please contact your stockist or our customer
service centre.
oOnly a qualified technician and using original spare parts and accessories should
carry out repairs and maintenance of the device. Do not attempt to repair the
device yourself.

- 26 -
7. Waste disposal
Discarding old devices
At the end of its service life, the discarded device has to be disposed in accordance with
national regulations. It is advisable to contact a company which is specialized in waste
disposal, or just contact the local disposal service in your community.
WARNING!
To exclude any abuse and the dangers involved, make the waste device unfit for
use before disposal. For this purpose, disconnect device from mains supply and
remove mains connection cable from the device.
NOTE!
For the disposal of the device please consider and act
according to the national and local rules and
regulations.
Bartscher GmbH
Franz-Kleine-Str. 28
D-33154 Salzkotten phone: [phone]
Germany fax: [phone]