BCP SKY6328 User manual

SKY6328 + SKY6329 + SKY6330 + SKY6331Ver. 2
Ride On Bumper Car
INSTRUCTION
MANUAL

bestchoiceproducts.com
Charge for 18 hrs
before initial use.
After initial charge,
follow the normal
recommended
charging time.
To reduce the risk of injury, adult supervision is
required. Never use on roadways, near motor vehicles,
on or near steep inclines or steps, swimming pools or
other bodies of water; always wear shoes, and never
allow more than one rider.
FOR: 1.5-6 YEARS OLD & UP TO 66 LBS
ADULT ASSEMBLY REQUIRED

| 3
Please retain these instructions for future reference.
SAFETY
Before using the vehicle the child should understand the vehicle controls and safety issues. They must
also demonstrate the capability to handle the vehicle and operate its controls. It is the responsibility of
the adult to educate the child and supervise the vehicles use. Read the following safety warnings to any
child using the vehicle before riding.
NOTE: For best performance, only use this vehicle on flat and hard surfaces.
AGE RANGE: 18 months to 6 years old
WEIGHT CAPACITY: 66 lbs.
The following safety hazards may result in serious injury or death:
• This product contains small parts. Keep children away during assembly. Make sure to remove all
packaging material and parts from underneath the vehicle body.
• Never open the battery. Batteries contain lead and lead compounds (acids) that are toxic and corrosive,
and known to the state of California to cause cancer and reproductive harm.
• Limbs, hair, and clothing can get caught in moving parts. Always wear shoes, keep limbs away from
moving parts, and do not wear loose clothing while operating this vehicle.
• This vehicle does not have brakes or braking capability. Do not leave a child unattended during
operation. Do not use this in a location that may require braking capability, as this could result in loss of
control, which may cause serious injury or death.
• Use of this vehicle near streets, motor vehicles, steps, bodies of water, sloped surfaces, hills, wet areas,
flammable vapors, in alleys, at night, or in the dark could result in an unexpected accident.
• Use of this vehicle in unsafe conditions such as snow, rain, loose dirt, mud, sand, or gravel may result in
an unexpected accident such as tipping over, and could damage the electrical system or battery.
• Do not operate this vehicle in an unsafe manner. Examples include but are not limited to:
- Pulling the vehicle with another vehicle or similar device
- Pushing the user
- Traveling at an unsafe speed
To reduce the risk of injury, adult supervision is required. Never use on roadways, near motor vehicles, on
or near steep inclines or steps, swimming pools or other bodies of water and always wear shoes.
• Maximum of one child is allowed in the vehicle at a time.
• Always sit in the seat when using this vehicle.
• Keep your hands, hair, and clothes away from moving parts.
• Children under 18 months of age cannot use the vehicle.
• Only drive on level ground.
• Do not drive the vehicle into loose dirt, mud, sand, fine gravel, or on wet surfaces.
WARNING
BATTERY WARNINGS
The following safety hazards may result in serious injury or death:
• Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire
or explosion. Only use the supplied battery and charger.
• Use of the rechargeable battery and charger for any other product may result in overheating, fire,
or explosion. Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery in a well-ventilated area. Do not
charge the battery near heat or flammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct
contact between the terminals. Picking up the battery by the wires or charger can cause damage to the
battery and may result in a fire. Always pick up the battery by its case or handles.

4|
WARNINGS REGARDING BATTERIES
•RISK OF FIRE: Do not bypass fuse. This may overload and damage the electrical system. Replace only
with original size and type.
•Do not mix alkaline, standard (carbon zinc) and rechargeable (nickel hydride) batteries.
•Do not mix old and new batteries.
•Non-rechargeable batteries should not be charged.
•Rechargeable batteries should be charged under adult supervision only.
•Exhausted batteries should be removed.
•The supply terminals should not be short-circuited.
•Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
•Do not hit batteries against hard objects.
•Do not submerge batteries in water.
•Batteries should be inserted with the correct polarity.
BATTERY WARNINGS
• Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery
and keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury.
If contact or exposure occurs immediately call your physician. If the chemical is on the skin or in the
eyes, flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person
water
or milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not
induce vomiting.
• Battery posts, terminals, and related accessories contain lead and lead compounds (acid) – chemicals
known to the State of California to cause cancer, reproductive harm, and are toxic and corrosive.
Never open the battery.
• Tampering or modifying the electric circuit system may cause a shock, fire or explosion and
permanently damage the system. Exposed wiring and circuitry in the charger may cause electric shock.
Always keep the charger housing closed.
SPECIFICATIONS
Overall Dimensions
Weight
Weight Capacity
Age Range
Speed
Charging Time
27.5"(L) x 27.5"(W) x 15.7"(H)
17.5 lbs.
66 lbs.
18 months – 6 years old
Approx. 1.2 MPH
8 – 12 hours
Initial Charge Time 18 hours

| 5
SPECIFICATIONS
Run Time
Battery Type
Motor
Charger
Material
1 – 2 hours
6V 4.5AH
DC 6V
Input: 100V – 240V AC
Output: DC 6V500MA
PP Plastic, Iron
PARTS
TOOLS REQUIRED
UP TO 15 MIN.
ASSEMBLY
1 PERSON
ASSEMBLY
66 LBS
CAPACITY
LBS
2 AAA 1.5V
BATTERIES
+AAA -
PHILLIPS
SCREWDRIVER
D
1 PC
REMOTE CONTROL
1 PC
CAR BODY
A
1 PC
ROTATING CASTER
B
1 PC
CHARGER
C

6|
A
B
PRODUCT ASSEMBLY
1Place the part A car body onto a flat, level surface with the bottom facing upward.
Insert the part B rotating caster into the corresponding slot on the car body.
2Within the seat area, connect the two red couplers to direct power from the battery to the
circuit board.
NOTE: Make sure the connection is secure before attempting to switch the power on.
BATTERY
CIRCUIT BOARD

| 7
PRODUCT DIAGRAM
NOTE: Control the forward and reverse of the left and right drive motors with their corresponding
joystick. Hold down the power button for three seconds to turn this item on or o.
RIGHT JOYSTICK LEFT JOYSTICK POWER
SWITCH
HORN
BUTTON
CHARGING
PORT
LIGHT
SWITCH
OPERATING INSTRUCTIONS
1. Push both joysticks forward to go forward in a straight line.
2. Push both joysticks back to go reverse in a straight line.
3. To turn right, push the left joystick forward without moving the right joystick.
4. To turn left, push the right joystick forward without moving the left joystick.
5. Push the right joystick forward and the left joystick backward to rotate counterclockwise.
6. Push the left joystick forward and the right joystick backward to rotate clockwise.
RESETTING FUSE
This product contains an automatic, resetting fuse. If the current exceeds a certain rating, the recoverable
fuse will automatically shut down to prevent damage. This shutdown period will last between 5 and 60
seconds before power is restored. Please allow at least this much time before seeking technical support.
The following safety hazards may result in serious injury or death:
• Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire
or explosion. Only use the supplied battery and charger.
• Use of the rechargeable battery and charger for any other product may result in overheating, fire,
or explosion. Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery in a well-ventilated area. Do not
charge the battery near heat or flammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct
contact between the terminals. Picking up the battery by the wires or charger can cause damage to the
battery and may result in a fire. Always pick up the battery by its case or handles.

8|
REMOTE CONTROL
Linking the remote control:
1. Install 2 AAA Batteries into the remote control.
2. Turn the power switch on the vehicle to “o.”
3. Press and hold both the Forward ( ) & Reverse ( ) buttons for 3 seconds. The LED indicators
will flash.
4. Turn the vehicle on. The red indicator lights will stop flashing, indicating a successful link.
5. If the indicator lights continue to flash (indicating an unsuccessful link), remove, and reinsert batteries
and repeat steps 1 to 4.
Inserting Batteries in Remote:
1. Use a small Philips Head Screw Driver to remove the battery cover of the remote control.
2. Insert Two AAA 1.5V batteries like diagram below.
3. Close the battery cover and screw driver to tighten screw.
STOP (P)
TURN LEFT ( )
TURN RIGHT ( )
SPEED (S)
LED INDICATOR:
+AAA -
+AAA -
REVERSE ( )
FORWARD ( )
LOW SPEED
MEDIUM SPEED
HIGH SPEED

| 9
CHARGING INSTRUCTIONS AND WARNINGS
• Charging socket is located under the seat. Insert one end of the part C charger into the charging socket
and plug the other end into a wall outlet (see Diagram).
• Charge the battery at least 18 hours before initial use.
• On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery for
more than 20 hours. Failure to charge the battery as directed could cause permanent damage to the
battery and void the warranty.
• Damage to the battery may occur if it is allowed to drain completely. Do not allow the battery to
drain completely.
• Check the battery and charger (supply cord, connector) for wear and damage before charging.
• Do not charge the battery if damage has occurred.
• Only an adult who has read and understood the safety warnings should handle, charge and recharge
the battery.
C
2
ATTENTION
21
A: Please connect picture 1: the power connector before assembling the seat.
Then press the Start button as shown in picture 2. Otherwise, the car will not
start because of no power supply.
B: After charging, please unplug the charger first, then press the Start button as
shown in picture 2. Otherwise, the car will not start because of no power supply.
A B
1

10 |
TROUBLESHOOTING
Issue
The motor does not rotate
Car only moves forward or backward
Slow Speed
The battery is not recharging
Car is unstable moving on and o
Solution
1. Allow 5-20 seconds then restart
2. Reconnect foot switch
3. Check for loose connections
4. Plug the plug in
1. Check the connection lines
2. Turn the toy on and o again, and
rotate the individual joysticks
1. Charge the battery
2. Driving circuit board requires
professional repair
1. Clear the contacts of the charging port
and cable
2. Replace the charger
1. Make sure all 3 wheels are in contact
with the ground
1. Maximum weight limit exceeded;
reduce load
2. The surface you are traveling on is not
level; change locations
Wheel is rotating, car is not moving
CALIFORNIA PROPOSITION 65
WARNING: Battery posts, terminals, and related accessories can expose you to chemicals including
lead and lead compounds, which are known to the State of California to cause cancer and birth defects or
other reproductive harm, and are toxic and corrosive. Wash hands after handling. For more information go
to www.P65Warnings.ca.gov
CARING FOR YOUR RIDE-ON
• Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
• Do not leave the vehicle in the sun for long periods of time or fading may occur.
• Store in shade or cover with tarp.
• Do not wash the vehicle with a hose.
• Do not wash the vehicle with soap.

| 11
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This product may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Responsible party (contact for FCC matters only):
Quality Control Dept.
15101 Red Hill Ave.
Tustin, CA 92780
FCC COMPLIANCE STATEMENT

All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long
as the item is returned in its original product packaging and all accessories from its original shipment are
included. All returned items will receive a full refund back to the original payment method. All returned
items will not be charged a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best
Choice Products Customer Service Representative when the return request is submitted. Items received
without an RA may not be accepted or may increase your return processing time. Once an item has been
received by Best Choice Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If
the reason for return is a result of an error by Best Choice Products then Best Choice Products will provide
a pre-paid shipping label via email. Boxes for return shipping will not be provided by Best Choice Products,
and is the customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items
returned are not considered undamaged until they are received by Best Choice Products and verified as
such. All damages to items are the customer’s responsibility until the item has been received by and
acknowledge by Best Choice Products as undamaged.
PRODUCT WARRANTY INFORMATION
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or
loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, unapproved modification, or neglect of this product.
HELP CENTER
Product Assembly
Product InquiryChat Support Returns & Refunds
Orders FAQ
WARNING
Question about your product? We're here to help. Visit us at:
help.bestchoiceproducts.com
CHAT
US!