Belkin HI-SPEED USB 2.0 EXTERNAL DRIVE ENCLOSURE User manual

En
It
Es
Ne
P74081ea F5U217ea
Hi-Speed USB 2.0
User Manual Pocket Hub
Manuel d’utilisateur du concentrateur de
poche USB 2.0 à haut débit
Hispeed USB 2.0 Pocket-Hub
Benutzerhandbuch
Handleiding voor hi-speed
pocket-hub voor USB 2.0
Manuale utente per hub tascabile
USB 2.0 ad alta velocità
Manual de usuario del Concentrador de
bolsillo USB 2.0 de alta velocidad
Fr
De
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page a

P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page b

TABLE OF CONTENTS
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Technical Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
En
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page c

P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page d

Congratulations and thank you for purchasing the Belkin Hi-Speed
USB 2.0 Pocket Hub (the Hub). The Hub provides three downstream
USB ports that are compatible with both USB 1.1 (low-speed and
full-speed) devices, as well as with USB 2.0 (high-speed) devices.
This means that the Hub is backward-compatible with all of your
current USB 1.1 devices as well as the new generation of Hi-Speed
USB 2.0 devices. This may include such peripherals as scanners,
printers, mass storage devices, and high-resolution cameras. The Hub
is self-powered, which allows the cascading of devices with additional
hubs, so that up to 127 USB devices can be connected to a single
port. The Hub also provides a multicolored status LED for each
individual port, and a master power LED. For additional information,
refer to the Technical Specifications section.
INTRODUCTION
1
En
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page 1

FEATURES
2
• Compliant with Universal Serial Bus specification 2.0 (data
rate 1.5/12/480Mbps)
• Backward-compatible with Universal Serial Bus specification
1.1 (data rate 1.5/12Mbps)
• Compatible with Windows®98 SE, Me, 2000, and XP
• Approved by USB Implementers Forum (USB-IF)
• Supports Plug-and-Play specifications
• Supports hot swapping of USB devices
• Over-current detection and protection
• Individual port-status indicator LEDs
• Three 480Mbps downstream ports
• Fully compatible with USB 1.1 and USB 2.0 devices
• Operates without power supply when used with low-power
devices such as keyboards and mice
• Compact slim-line design
• Convenient storage/mounting clip
• Built-in USB device cable
Package Contents
• Hi-Speed USB 2.0 Pocket Hub
• AC Power Adapter
• User Manual
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page 2

3
En
TECHNICAL SPECIFICATIONS
Upstream Ports 1
Downstream Ports 3
Per-Port Voltage DC +5V
Per-Port Current 500mA (max)
Power Mode Self-powered
Operating Temperature 5º C ~ 40º C
Storage Temperature -20º C ~ 60º C
Enclosure Plastic
Power Supply Output: DC 5V 2.4A
Plug Size: 3.5mm (outer)
1.0mm (center)
Plug Polarity: Center Positive
Main Power LED
Color Definitions:
Off Not Operational
Red Operational
Port-Status LED
Color Definitions:
Off Not Operational
Amber Error Condition
Green Fully Operational
Blinking Off/Green Software Attention
Blinking Off/Amber Hardware Attention
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page 3

INSTALLATION
4
1. Plug the AC adapter into a wall outlet or surge suppressor.
Plug the DC connector into the DC power jack found on the
side of the Hub.
Note: The Hub may be used without the power supply when
connecting low-power devices such as keyboards and mice.
Remove the USB A cable connector from its built-in storage
bay, then plug it into the downstream port of your computer, or
downstream port of another hub (see Fig. 1).
Important Note: The Hub must be connected to a USB
2.0-compliant host in order to function in high-speed mode
(480Mbps data rate). If the Hub is connected to a USB
1.1-compliant host, it will operate only in low-speed or
full-speed mode (1.5Mbps/12Mbps).
2. Your Windows operating system will now detect your
Hub and install the required driver support. (The Windows
Port 1
Port 2
Upstream Port
Port 3
Figure 1
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page 4

En
INSTALLATION (CONTINUED)
“Install New Hardware Wizard” may prompt you to
provide your Windows Installation CD to complete the
driver installation process).
Important Note: Hi-Speed USB 2.0 hub drivers are
included with most USB 2.0 PCI upgrade cards, and are
pre-installed along with the PCI card drivers. If you
purchased an upgrade card prior to the release of
Hi-Speed USB 2.0 hub support, please check with your
PCI card vendor for an updated USB 2.0 driver. The Belkin
Hi-Speed USB 2.0 driver supports all competitive cards
based on the NEC host controller with the exception of
Adaptec. The most recent Belkin driver is available at
www.belkin.com.
3. Plug the USB A connector of the USB device, or an
additional hub, into any of the downstream ports of
the Hub (see Fig. 2).
Important Note: When plugging a USB device into the
Hub for the first time, it may be necessary to reinstall the
USB drivers for that device. Likewise, if you move the
device to another port on the Hub, it may be necessary to
reinstall the drivers.
USB-A Connector
Figure 2
5
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page 5

INFORMATION
FCC Statement
DECLARATION OF CONFORMITY WITH FCC RULES FOR
ELECTROMAGNETIC COMPATIBILITY
We, Belkin Components, of 501 West Walnut Street, Compton CA 90220,
declare under our sole responsibility that the product:
F5U217
to which this declaration relates:
Complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
CE Declaration of Conformity
We, Belkin Components, declare under our sole responsibility that the F5U217, to which this
declaration relates, is in conformity with Generic Emissions Standard EN550022 1998 and
with Generic Immunity Standard EN550024 1998, EN61000-3-2, and EN61000-3-3.
Belkin Components Limited Lifetime Product Warranty
Belkin Components warrants this product against defects in materials and workmanship for
its lifetime. If a defect is discovered, Belkin will, at its option, repair or replace the product at
no charge provided it is returned during the warranty period, with transportation charges
prepaid, to the authorized Belkin dealer from whom you purchased the product. Proof of
purchase may be required.
This warranty does not apply if the product has been damaged by accident, abuse, misuse,
or misapplication; if the product has been modified without the written permission of Belkin;
or if any Belkin serial number has been removed or defaced.
THE WARRANTY AND REMEDIES SET FORTH ABOVE ARE EXCLUSIVE IN LIEU OF ALL OTHERS,
WHETHER ORAL OR WRITTEN, EXPRESSED OR IMPLIED. BELKIN SPECIFICALLY DISCLAIMS
ANY AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
No Belkin dealer, agent, or employee is authorized to make any modification, extension, or
addition to this warranty.
BELKIN IS NOT RESPONSIBLE FOR SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES RESULTING FROM ANY BREACH OF WARRANTY, OR UNDER ANY OTHER
LEGAL THEORY, INCLUDING BUT NOT LIMITED TO LOST PROFITS, DOWNTIME,
GOODWILL, DAMAGE TO OR REPROGRAMMING, OR REPRODUCING ANY PROGRAM
OR DATA STORED IN OR USED WITH BELKIN PRODUCTS.
6
P74081ea-F5U217ea-8-02.qxd 8/28/02 5:47 PM Page 6