bemodern HANSFORD GRANDE Programming manual

Assembly & Installation Instructions
HANSFORD GRANDE
Before You Start
• DO NOT dispose of the packaging until you have checked and made
sure you have all the parts and fittings listed above. If not, contact:
BE MODERN HELPLINE on 0191 430 0901
who will be able to assist you with this and any other problems you may
have encountered.
• When you are ready to start, make sure that you have the right tools to
hand, plenty of space and a clean dry working area.
NB. Protect the surface you are working on to prevent any possible
damage to the fire surround or floor.
Parts Supplied
Ref Description Illustration Qty
Fittings Supplied
AMantel
Suite with
Electric Fire
1
Ref Description Illustration Qty
B Mantel
Brackets
2
D4
CWall
Brackets
2
16mm
Screws
Tools (not supplied) For Fixing To Wall
• Drill •Pencil
• Screw Driver • Ruler
• Tape Measure
Fire Instructions
• For fire instructions please refer to separate instructions supplied.
Care
• To maintain the appearance of your new suite we recommend that it is dusted
using a lint free cloth. NEVER use any form of abrasive or DAMP cloth.

ISSUE 1 : 03-12-18
Fig.1
10mm
100mm
Fig.2
Where appropriate please recycle packaging responsibly.
7. NB. Should a defect be discovered and in the event of a suite being
permanently fixed to the wall the householder will be responsible for any
costs incurred.
Installing The Mantel
1. Trial fit the mantel in the required position.
Remove any obstructions, ie. cut to shape or
remove skirting to allow the mantel to butt up
tothe wall.
Note: Mantel is a two adult person lift.
2. Screw the 2 mantel brackets (B) to the
inside of each leg using the 4 screws
provided (D - 16mm), making sure that the
brackets are flush with the rear of the leg.
See Fig.1&2
3. With the mantel in position. Lightly scribe
the wall in line with outer edges of the mantel.
Lift the mantel away from the wall. Measure
inwards from the previously scribed line the
thickness of the mantel leg plus 10mm.
See Fig.2
4. Fix the wall brackets (C) in place using the
appropriate fixing dependent on the type of
wall (Fixing are not supplied). Ensure mantel
brackets (B) will fall halfway between the folds
onthe wall brackets (C).
See Fig.2
5. IMPORTANT: If a power cable is to be routed
tothe rear of the mantel. Care must be taken
not to crush or damage the cable when
positioning the mantel.
6. Lift the mantel onto the wall brackets (C) and
confirm it is securely held in place.
Ifany adjustment is required take the mantel
off the wall and adjust using the slots on
the mantel brackets (B).