BeviClean Bevi Plus User manual

1
Bevi Plus

2
Contents Page
1. Safety instructions .......................................................... 2
2. Scope of supply ............................................................... 3
3. Operating instructions ...................................................... 3
4. Cleaning and service ....................................................... 5
5. General information ......................................................... 5
6. Illustration and components ............................................. 6
. Spare parts ......................................................................
8. Technical information ....................................................... 8
1. Safety Instructions
 Check the device for transport damages upon receipt
 Observe the operating instructions and always keep it
next to the equipment
 It must be excluded that unauthorised persons oper-
ate the equipment
 Secure the dispensing equipment during the cleaning against
use
 Do only use with water cocks not connected to a low-
pressure flow heater
 We do not accept any liability for damages caused by
use of not original parts and accessories, or due to inappropri-
ate handling

3
2. Scope of Supply
 Bevi Plus
 Operating instructions
 Cleaning pellets Bevi Tab alkaline (2 pieces)
3. Operating Instructions
3.1 Connection
 Connect the water hose to Bevi Plus
 In case of a steady connection, on site there must be a pipe dis-
connector with ventilation according to DVGW, and a hose burst
protection
 Establish the connection of the line to be cleaned with the drain
Optional: Cleaning adapter AFG on stainless steel plate

4
3.2 Cleaning
 Detach the adapter sight glass from the equipment by slightly
turning it to the left, place Bevi Tab flat (see Fig.1), and fasten
again (depending on the length of the line use 2 Bevi Tabs)
 Open the water cock
 Open the dispenser tap
 Close the dispenser tap again after cleansing agent is coming
out (Fig. 2)
 Let it act for 15 to 20 minutes
 Open the dispenser tap again and rinse sufficiently (Fig. 3)
 Pay attention that the equipment is free from cleansing agent,
check e.g. with pH indicator paper
 Close the water cock after the cleaning
3. Rinse thoroughly
1. Detach the adapter sight glass
and place Bevi Tab flat
2. Cleansing agent comes out

5
4. Cleaning and Service
 Disinfect inside and outside of the equipment in regular
intervals,
e. g. with Bevi Desinfect (Attention: do not use alcohol-
containing agents)
5. General Infor ation
 It is only allowed to connect the equipment with water cocks
without low-pressure flow heaters
 Protect the equipment against temperatures below
freezing point (risk of freezing and destruction of the
pump)
 Do only use customary cleansing agents (e. g. Bevi
Tab)
 When operating the equipment properly the warranty for
components is of 1 year