biodex 058-840 Assembly instructions

FN: 08-186 Rev A 8/11
IMPORTANT:
UNPACKING INSTRUCTIONS
AND TABLE RAMP ASSEMBLY
058-840
058-845
058-846
058-847
058-870
058-875
058-878
BIODEX
Biodex Medical Systems, Inc.
20 Ramsey Road, Shir ey, New York, 11967-4704
Te : 800-224-6339 (Int’l 631-924-9000),
Fax: [phone] Emai : [email protected], www.biodex.com

$ &!'#$&$!%!!( "#!&%$
058-840
058-845
058-846
058-847
058-870
058-875
058-878
NOTE: At least two people are required to re ove the table fro the
shipping crate.
Tool Required: Phillips screwdriver


(See Figures 1 and 2.)
The Biodex Ta le you have purchased is shipped in a crate that contains a
ramp as part of the packing material. This ramp can e easily assem led to
make it possi le to remove the ta le from the shipping crate without the
need for a forklift or other heavy moving equipment.
1. Remove the ox from over the ta le.
2. Carefully remove the shrink wrap from around the ta le.
3. Plug the power cord into a power source, or install the ta le attery.
4. Use the ta le’s Hand-Held Controller to raise the ta letop until it rests
several inches a ove the front race.
5. Using a Phillips screwdriver, unscrew the race from the skid and
unscrew the angled race supports from the race.
6. Lift up on the front race and remove it from the shipping crate.
7. Position the front race flat on the floor and flush against the front end
of the shipping crate, creating a small ramp that leads from the shipping
crate to the floor.
8. With the aid of another person, lift up on the ta le just enough to free the
wheels from the cutouts and simply roll the ta le, slowly and carefully,
down the ramp and onto the floor.
9. The ta le is now ready for installation. Please refer to the Installation and
Operation Manual supplied.
NOTE: If this table is on a trial evaluation you ust retain the packing
aterials in case they are needed to return the table.

Figure 1: The front
brace is positioned
under the front end
of the table. Use the
Hand-Held Controller
to raise the tabletop,
then unscrew the
brace fro the skid
and the angled brace
supports fro the
brace. Lift up on the
brace to re ove it
fro the shipping
crate.
Figure 2: Place
the front brace on
the floor flush
against the front
end of the ship-
ping crate to cre-
ate a ra p. With
the aid of another
person, lift up on
the table to free
the wheels and
then roll the table
slowly down the
ra p.
 $#(
$&""!#%
#
 $#(
$&""!#%
#
#! %#
 $#(
 $#(
#! %#"!$%! 
$%#"

BIODEX
Biodex Medical Systems, Inc.
20 Ramsey Road, Shir ey, New York, 11967-4704
Te : 800-224-6339 (Int’l 631-924-9000),
Fax: [phone] Emai : [email protected], www.biodex.com