Bittium OmegaSnap 3-CH ECG Electrode User manual

Copyright © 2021-11-16 Bittium. All rights reserved. Document number: 5800662A02
Bittium
OmegaSnap™
3-CH ECG Electrode
Bittium Biosignals Oy
Pioneerinkatu 6
70800 Kuopio, FINLAND
Bittium OmegaSnap™
3-CH ECG Electrode
Quick Guide
The Bittium OmegaSnap™ 3-CH ECG Electrode is intended to be used
with the Bittium Faros™ 360 ECG device for the purpose of measuring
cardiac signals (ECG).
Bittium
Faros™
360
Bittium
OmegaSnap™
Multi-CH
Adapter
Bittium
OmegaSnap™
3-CH ECG
Electrode
Equipment
Tel: [phone]
Email: [email protected] or
[e-mail]
www.bittium.com
Caution!
›Place the electrode onto intact, clean
skin only.
›Do not use body lotion or creams in
the electrode area prior to applying the
electrode.
›Do not use outdated electrodes. Please
check the date on the packing material.
›The electrode is for single use only.
Reuse of the product may cause con-
tamination, leading to infections.
›Stop using the Faros ECG device
and remove the electrode from the
skin if the electrode causes adverse
reactions such as skin irritation or rash.
If any problems occur, please contact
your clinic or person responsible for
treatment.
Quick Guide - Bittium OmegaSnap™3-CH ECG Electrode
›Replace the electrode if it does not
stick to the skin.
›Remove the electrode from the skin
after measuring.
›Use the electrode only with the Bittium
Faros™ ECG device.
›The Faros device and OmegaSnap
adapter must be cleaned between
users. The recommended cleaning
method: non-alcoholic cleaning and
disinfection wipes for medical devices,
for example mikrozid® sensitive wipes
or SaniCloth AF3 wipes.
›Follow these instructions. See more
detailed instructions in the Faros
manual.

If needed, remove excess body
hair using a razor or an electric
shaver. Clean the skin according
to the instructions given by your
clinic or the person responsible
for treatment. The skin should be
clean and dry when attaching the
electrode.
Quick Guide - Bittium OmegaSnap™3-CH ECG ElectrodeQuick Guide - Bittium OmegaSnap™3-CH ECG Electrode
1.
Make sure the electrode pouch is unopened and check the date
before use. Tear open the pouch and remove the electrode.
2.
Remove the plastic liner (marked
as number 1) of the electrode. Do
not touch the adhesive surface
with fingers.
3.
Fix the electrode onto the skin.
Place the top of the electrode
approx. two fingers’ width below
the suprasternal notch. The top
right part of the electrode should
be located below the patient's
right clavicle. Don't remove liners
number 2 or 3 just yet.
4.
When the top of the electrode is properly attached, remove the
second liner (marked as number 2) and pull it away while making
sure the electrode attaches to the skin. Then, remove the liner
marked with number 3 on top of the electrode and attach the rest
of the electrode onto the skin.
5.
Make sure the surface of the Faros
device and OmegaSnap adapter
are undamaged*. Connect device
to the adapter. To ensure a good
connection, pinch device and the
adapter together with thumb and
index finger. Attach adapter to the
electrode. Press the device against
the electrode to make sure the
snap fasteners are connected.
6.
Press and release the power
button to start measuring. A
sound and blinking green light
indicate that measurement has
started.
7.
When you want to end the
measurement, press and hold
the power button for approx.
8 seconds. The device beeps
three times and the blinking
light turns off.
8.
Remove the electrode off the skin by peeling back an edge
of the patch and then gently pulling off the rest of the patch.
You can use mild soapy water if necessary. Dispose of the
used electrode in accordance with local waste management
practices. Return the Faros ECG device and the OmegaSnap
adapter to your clinic or person responsible for treatment.
9.
Symbols
*If you notice any visual damage (e.g. a crack or dent), please contact your clinic for
further instructions.
Copyright © 2021-11-16 Bittium. All rights reserved. Document number: 5800662A02
REMOVE
REMOVE
1
3
1
3
1x
8sec.
2
3
2
3
2
3
3
Manufacturing date Lot number
Use-by dateManufacturer
CE mark Do not reuse
Follow instructions for use Prescription use only**
**USA users please note:
For prescriptions use, use only by designated healthcare professionals
Medical Device
MD