Black & Decker BDS1616R User manual

www.blackanddecker.co.uk
FSM1616
BDS1616R

23
1
9
10
2
5
5a
6
5b
6a
7
3
4
8

23
3
11
4
7
9
8
10a
7
5
5a
5b
3
5
6
4 4
11
B
C
E F
A
1
9
10
2
5
5a
6
5b
6a
7
3
4
8
D

4
ENGLISH (Original instructions)
5
ENGLISH
(Original instructions)
Intended use
Your BLACK+DECKERTM FSM1616 and BDS1616R steam
mop has been designed for sanitising and cleaning sealed
hardwood, sealed laminate, linoleum, vinyl, ceramic tile,
stone and marble oors. This appliance is intended for indoor
household use only.
Safety Instructions
tWarning! Read all Safety,
Maintenance, Service' manual
carefully before operating
this appliance. Read all of this
manual carefully before operat-
ing this appliance.
Safety of others
uThis appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sen-
sory or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved.
uChildren shall not play with the appli-
ance. Cleaning and user maintenance
shall not be made by children without
supervision.
uIf the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualied
persons in order to avoid a hazard.
uThe plug must be removed from the
socket-outlet before cleaning or main-
taining the appliance.
uThe liquid or steam must not be
directed towards equipment contain-
ing electrical components, such as the
interior of ovens.
uThe appliance shall not be left unat-
tended while it is connected to the sup-
ply mains;
uThe appliance is not to be used if it
has been dropped, if there are visible
signs of damage or if it is leaking;
ukeep the appliance out of reach of
children when it is energized or cooling
down.
Labels on appliance
The following pictograms along with the
date code are shown on the appliance.
CAUTION Hot Steam
Features
1. On/off switch
2. Steam operate button
3. Removable water tank
4. Handle
5. Steam Head
5a. Delta oor head
6. Steam head cleaning pad
6a. Delta head cleaning pad
7. Bottom cable tidy hook
8. Top cable swiveling tidy hook
9. Grip
10. Variable steam operation thumb wheel
10a. Hanging bracket
Assembly
@Warning! Before attempting any of the following
instructions, make sure that the appliance is
switched off and unplugged and the appliance is
cold and does not contain any water.
Attaching the handle (Fig. A)
uSlide the bottom end of the handle (4) into the top end of
the stem mop body (11) until it clicks into place. The arrow
on the handle (4) should be aligned with the top of the
steam mop body (11).
Attaching the water tank (Fig. B)
uSlide the water tank (3) into the steam mop body (11),
ensure that the water tank is rmly seated.
Attaching a cleaning pad (Fig. C)
Replacement cleaning pads are available from your
BLACK+DECKER dealer :- (cat no. FSMP20-XJ).

4
ENGLISH (Original instructions)
5
ENGLISH
(Original instructions)
Delta cleaning pads :- (cat no. FSMP30-XJ).
u Place a cleaning pad (6) on the oor with the velcro 'loop'
side facing up.
uLightly press the steam mop down onto the cleaning pad
(6).
Caution: Always place your steam mop with the handle (4)
supported in the upright position when stationary and make
sure the steam mop is turned off when not in use.
Removing a cleaning pad
Caution! Always wear suitable shoes when changing the
cleaning pad on your steam mop. Do not wear slippers or
open toed footwear.
uReturn the handle (4) to the upright position and turn the
steam mop 'OFF'.
uWait until the steam mop cools down (approximately 5
minutes).
uLift the steam mop away from the cleaning pad freeing it
from the velcro fastening.
Caution! Always place your steam mop with the handle (4)
supported in the upright position when stationary and make
sure the steam mop is turned off when not in use.
The Delta Head (Fig. D)
This Steam Mop incorporates a built in delta head which
enables you to access into tight corners and narrow gaps.
Caution! Always wear suitable shoes when accessing the
delta head on your steam mop. Do not wear slippers or open
toed footwear.
uReturn the handle (4) to the upright position and turn the
steam mop ‘OFF’.
u Wait until it cools down (approximately ve minutes).
u Place the front of your shoe onto the steam head removal
tab (5b) and press down gently.
u Lift the delta head (5a) up off the steam head (5).
uFit the delta head cleaning pad (6a) to the bottom of the
delta head.
Filling the water tank (Fig. E)
The water tank on your steam mop is removable for
convenient and easy lling.
Note! Fill the water tank with clean tap water.
Note! In areas of hard water, the use of de-ionised water is
recommended.
u Remove the water tank (3).
u Remove the lter cap by unscrewing in an anti-clockwise
direction.
u Fill the water tank (3) with water.
Warning! Your water tank has a 350ml capacity. Do not over
ll the tank.
u Replace the lter cap by screwing in a clockwise direction.
u Re-t the water tank (3).
Note! Ensure the lter cap is rmly secured.
Note! Do not use chemical cleaners with your steam mop
water tank.
Use
Important! This unit will kill 99.9% of bacteria and germs
when used in accordance with the instructions in this manual
and with the micro bre pad tted and a continuous run time
of 90 seconds.
Switching on and off
u To switch the appliance on, press the ON/Off button (1).
It takes approximately 15 seconds for the steam mop to
heat up.
u Press the steam operation button (2). This will operate the
pump and the unit will begin to produce steam.
uTo stop steam generation, turn the steam operation button
(2) to off. This will maintain power to the boiler for quicker
start up.
u To switch the appliance off, press the ON/Off button (1).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (4) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
Caution! Always empty the steam mop after use.
Note! When rst lled or after running dry, it can take up to 45
seconds for steam to be produced.
Variable Steam operation
The unit is equipped with a variable steam operation
controlled by the thumb wheel (10) located on the handle grip
(9). This allows for 3 different surface settings.
The variable steam settings are:
Wood / Laminate
Tile / Vinyl
Stone / Marble
Hints for optimum use
General
Caution: Never use the steam mop without rst attaching a
cleaning pad.

6
ENGLISH (Original instructions)
7
ENGLISH
(Original instructions)
u Always vacuum or sweep the oor before using the steam
mop.
uThe easiest way to use the appliance is to tilt the handle
to a 45º angle and clean slowly, covering a small area at a
time.
u Do not use chemical cleaners with your steam mop. To
remove stubborn stains from vinyl or linoleum oors, you
can pre-treat with a mild detergent and some water before
using the steam mop.
Steam Cleaning
u Place a cleaning pad (6) on the oor with the velcro 'loop'
side facing up.
uLightly press the steam mop down onto the cleaning pad
(6).
u Connect the steam mop to the mains.
u Press the ON/OFF button (1). It takes approximately 15
seconds for the steam mop to heat up.
u Press the steam operate button (2). After a few seconds,
steam will start to come out of the steam head.
Note! When rst lled or after running dry, it can take up to 45
seconds for steam to be produced.
u It takes a few seconds for steam to enter the cleaning pad.
The steam mop will now glide easily over the surface to be
sanitized/cleaned.
u Push and pull the steam mop slowly across the surface to
thoroughly steam clean each section.
u When you have nished using the steam mop, return
the handle (4) to the upright position, making sure that it
is supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately ve minutes).
Caution! It is important to monitor the water level in the water
tank (3). To rell the water tank and continue to sanitize/
clean stand the mop upright making sure that the handle is
supported and turn the steam mop 'OFF'. Unplug the unit from
the electrical wall outlet, remove and rell the water tank (3).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (4) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
After use (Fig. F)
u Turn the steam mop 'OFF'. turn the steam operation
button (2) to off and then press the ON/OFF button (1).
u Wait until the steam mop cools down.
u Unplug the steam mop from the electrical wall outlet.
u Empty the water tank.
uremove the cleaning pad (6) and wash it ready for next
use.
uClip the supply cable around the cable tidy hooks (7 and
8)
uThere is a hanging bracket (10a) built into the hand grip
(9) which allows your steam mop to be hung from a
suitable hook on the wall. Always ensure that your wall
hook is capable of supporting the weight of the steam mop
safely.
Technical Data
FSM1616
(Type 1)
BDS1616R
(Type 1)
Voltage Vac 230 230
Power W 1600 1600
Tank
Capacity ml 350 350
Weight kg 2.3 2.3

6
ENGLISH (Original instructions)
7
ENGLISH
(Original instructions)
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Problem Step Possible solution
The steam mop is not
turning on
1. Check the unit is
plugged in at the wall
socket.
2. Check the unit is
switched on using the
ON/OFF switch (1)
3. Check the fuse in the
plug.
The steam mop is not
producing steam
4. Check the water tank
(3) is full and correctly
tted.
NOTE: When rst lled
or after running dry it
can take up to 45
seconds for steam to
be produced.
5. Check the steam
generation button is in
the ON position.
The steam mop is
producing too
much steam during
use.
6. The steam mop has 3
settings. Vary
thumbwheel control dial
(10) to reduce the
amount of steam being
produced.
The steam mop is
producing too
little steam during
use.
7. The steam mop has 3
settings. Vary
thumbwheel control dial
(10) to increase the
amount of steam being
produced.
The steam mop stops
producing steam
during use
8. Check step 1, then 2,
then 3.
The steam mop stops
producing too little
steam during use
9. Check step 4, then 2,
then 3
The steam mop is
producing too little
steam during use
10. Check step 4
Where can I get
further information/
accessories for my
steam mop
11. Refer to the assembly
chapter of the manual
for correct tting of
parts and
accessories.

90634487 REV-01
01/2016
Australia Black & Decker (Australia) Pty. Ltd. Tel. [phone]
20 Fletcher Road, Mooroolbark, Fax [phone]
Victoria, 3138
New Zealand Black & Decker Tel. [phone]
5 Te Apunga Place Fax [phone]
Mt Wellington
Aukland 1060
United Kingdom & Black & Decker Tel. [phone]
Republic Of Ireland 210 Bath Road Fax [phone]
www.blackanddecker.co.uk Slough, Berkshire SL1 3YD
[email protected]