Black Horse Model Extra 260-EP BH55 Owner's manual

Made in Vietnam.

SPECIFICATION

 Wingspan : 1,070 mm 42.13 in.

 Length : 1,030mm 40.55 in.

 Weight : 1 kg 2.2 lbs.

 Radio : 4 channels.

 Servo : 4 servos.

Partslistingrequired(notincluded):

 Electric Motor : AXI 2814/12.

 Battery : 3 CELLS - LI - POLY - 11.1V-2000mAh-20c.

 Propeller : 11 x 4.7.

 Speed control : 30A.

INSTRUCTION MANUAL BOOK

ITEMCODE:BH55.

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

This instruction manual is designed to help you build a great flying aeroplane. Please read this

manual thoroughly before starting assembly of your EXTRA 260- EP . Use the parts listing below

to identify all parts.

WARNING.

Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is

capable of causing injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU

ASSUME ALL RISK & RESPONSIBILITY.

If you are inexperienced with basic R/C flight we strongly recommend you contact your R/C supplier

and join your local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training

procedures designed to help the new pilot on his way to successful R/C flight. They will also be able

to advise on any insurance and safety regulations that may apply.

TOOLS & SUPPLIES NEEDED.

Thick cyanoacrylate glue.

30 minute epoxy.

5 minute epoxy.

Hand or electric drill.

Assorted drill bits.

Modelling knife.

Straight edge ruler.

2mm ball driver.

Phillips head screwdriver.

220 grit sandpaper.

90° square or builder’s triangle.

Wire cutters.

Masking tape & T-pins.

Thread-lock.

Paper towels.

Some more parts.

HARDWARE PACK

COWLING.

Landing gear.....

To avoid scratching your new airplane, do not

unwrap the pieces until they are needed for

assembly. Cover your workbench with an old

towel or brown paper, both to protect the air-

craft and to protect the table. Keep a couple of

jars or bowls handy to hold the small parts af-

ter you open the bag.

Please trial fit all the parts. Make sure you have

the correct parts and that they fit and are

aligned properly before gluing! This will assure

proper assembly. EXTRA260 - EP ARF is hand

made from natural materials, every plane is

unique and minor adjustments may have to

be made. However, you should find the fit su-

perior and assembly simple.

The painted and plastic parts used in this kit

are fuel proof. However, they are not tolerant

of many harsh chemicals including the follow-

ing: paint thinner, C/A glue accelerator, C/A glue

debonder and acetone. Do not let these chemi-

cals come in contact with the colors on the

covering and the plastic parts.

PARTS LISTING.

FUSELAGE ASSEMBLY

(1) Fuselage.

WING ASSEMBLY

(1) Right wing half with pre-installed

aileron.

(1) Left wing half with pre-installed

aileron.

Tail section assembly

(1) Vertical stabilizer with pre-

installed rudder.

(1) Horizontal stabilizer with pre-

installed elevator halves.

SUGGESTION.

NOTE.

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

SAFETY PRECAUTION. INSTALLING THE AILERON SERVOS.

1) Install the rubber grommets and brass

eyelets onto the aileron servo.

3) Turn the wing panel right side up.

Using a modeling knife, remove the covering

at servo tray.

2) Install the metal connector onto servo

arm .

C/ A glue

B. Wing panel(Right&Left).

C. Fuselage.

A. Cowling.

D. Motor mount wood.

E. Horizontal stabilizer.

G. Aluminium wing dihedral brace.

H. Decal sheet.

F. Vertical stabilizer

Bottom

+ This is not a toy

+ Be sure that no other flyers are using your

radio frequency.

+ The glow plug clip must be securely

attached to the glow plug.

+ Do not flip the propeller with your fingers.

+ Keep loose clothing and wires away from

the propeller.

+ Do not st art the motor if people are near .

Do not stand in line with the side of the propel-

ler.

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

C/A glue

Remove covering

5) Attach the micro control connector to

the servo arms. Be sure to use the lock tie but

it could free rotation.

4) Install the aileron servo as same as

picture.

 Using the thread as a guide and using

masking tape, tape the servo lead to the end

of the thread: carefully pull the thread out.

When you have pulled the servo lead out, re-

move the masking tape and the servo lead

from the thread.

Micro control connector.

Remove the covering on to the pre-cut slot

of aileron as picture.

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

1) Using a ruler & pen to draw a straight

line as below picture.

INSTALLING THEAILERON CONTROLHORN.

INSTALLINGTHEAILERONCONTROLHORN.

aileron control horn.

Insert aileron control horn to the aileron.

Remove covering

Control horn slot.

C/A glue.

Secure

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

Cut.

Repeat the procedure for the other

wing half.

INSTALLING ELECTRIC MOTOR.

See pictures below:

C/A glue

Push

Motor mount wood:

3 x 15mm

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

Motor.

Rotor shaft.

1) Slide the cowl over the motor and line

up the back edge of the cowl with the marks

you made on the fuselage.

COWLING.

3) Slide the cowl back over the motor.

2) While keeping the back edge of the

cowl flush with the marks, align the front of

the cowl with the crankshaft of the motor. The

front of the cowl should be positioned so the

crankshaft is in nearly the middle of the cowl

opening. Hold the cowl firmly in place using

pieces of masking tape.

Install the spinner backplate, propeller and

spinner cone. The spinner cone is held in

place using two 2mm x 10mm wood screws.

INSTALLING THE SPINNER.

Machine screws.

Secure 3x10mm.

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

PARTSREQUIRED

 1) Assemble and mounting the wheel pants

as shown in the following pictures.

C/A glue

Secure

MAIN GEAR INSTALATION

3x15mm

3 x 40mm

Mark point

Drill a hole 3mm diameter.

Metal plate 3mm

M3 lockWooden collars

3 x 40mm

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

2) A drop of C/A glue on the wheel collar

screws will help keep them from coming lose

during operation.

Repeat the process for the other wheel.

1) The blind nuts are already mounted in-

side the fuselage.

2) The holes in the landing gear should be

to accept the mounting bolts.

3) Using the hardwarehardware provided,

mount the main landing gear to the fuselage.

INSTALLING THE MAIN LANDING GEAR

Secure

3 x 15mm

Remove covering

througt the balsa

wood

EXTRA 260-EP -ITEM CODE:BH55 INSTRUCTION MANUAL.

Right side.

Remove

covering.

HORIZONTAL STABILIZER INSTALLA-

TION.

Remove

covering.

Left side.

C/A glue

1) Install the rubber grommets and brass

eyelets onto the rudder and elevator servo.

2) Install the metal connector onto servo

arm.

SERVO INSTALLATION.

Table of contents

Other Black Horse Model Toy manuals

Black Horse Model

Black Horse Model Spitfire MK Owner's manual

Black Horse Model

Black Horse Model Matrix Owner's manual

Black Horse Model

Black Horse Model MIDGET MUSTANG-EP Owner's manual

Black Horse Model

Black Horse Model MIG-29 Owner's manual

Black Horse Model

Black Horse Model LF-107 Lunak Owner's manual

Black Horse Model

Black Horse Model CAP 232-EP Owner's manual

Black Horse Model

Black Horse Model VIPER JET TURBINE Owner's manual

Black Horse Model

Black Horse Model DECATHLON-EP Owner's manual

Black Horse Model

Black Horse Model Westland Lysander Owner's manual

Black Horse Model

Black Horse Model HAWKER TYPHOON MK1B Owner's manual

Black Horse Model

Black Horse Model Sea Fury BH102 Owner's manual

Black Horse Model

Black Horse Model JU87-STUKA Owner's manual

Black Horse Model

Black Horse Model BH169 User manual

Black Horse Model

Black Horse Model Harmon Rocket BH100 Owner's manual

Black Horse Model

Black Horse Model BEDE BD-5 Owner's manual

Black Horse Model

Black Horse Model Extra S Owner's manual

Black Horse Model

Black Horse Model SPEED AIR BH.08 Owner's manual

Black Horse Model

Black Horse Model RYAN 61 Owner's manual

Black Horse Model

Black Horse Model Motion RC PIPER J-3 CUB Owner's manual

Black Horse Model

Black Horse Model P.C-9 BH76 Owner's manual

Black Horse Model

Black Horse Model Blade BH 70 Owner's manual

Black Horse Model

Black Horse Model Sonic Owner's manual

Black Horse Model

Black Horse Model BH58 Owner's manual

Black Horse Model

Black Horse Model Twister Owner's manual

Popular Toy manuals by other brands

marklin

marklin 37321 instruction manual

Canon

Canon PAPER CRAFT Assembly instructions

GREAT PLANES

GREAT PLANES Pitts M-12S instruction manual

NOCH

NOCH 14261 manual

Hausler

Hausler 450 SE V2 quick start

Dynaflite

Dynaflite Daydream instruction manual

Kenner

Kenner Batman 63651 instructions

LEGO

LEGO 8527 instructions

Multiplex

Multiplex EasyStar II Building instructions

iKarus

iKarus ECO 8 Assembly instruction

Walkera

Walkera 38 User handbook

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE manual

MD MXION SWD user manual

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway instructions

marklin

marklin 39671 user manual

LEGO

LEGO TECHNIC 8735 instructions

Mattel

Mattel HOTWHEELS DWL04 instructions

REVELL

REVELL Bristol Beaufighter TF.X Assembly manual