BLAUBERG Ventilatoren BLABBRAVO 100 User manual

USER’S MANUAL
BLABBRAVO
AXIAL WALL / CEILING FAN
EN

2
EN
CONTENTS
Delivery set ............................................................................................................................................................................................................................................ 7
Brief description .................................................................................................................................................................................................................................. 7
Operation guidelines ....................................................................................................................................................................................................................... 7
Installation and set-up..................................................................................................................................................................................................................... 8
Technical maintenance................................................................................................................................................................................................................... 9
Storage and transportation regulations............................................................................................................................................................................... 9
Blauberg Australasia warranty.................................................................................................................................................................................................... 10
This user’s manual is a main operating document intended for technical, maintenance, and operating staff.
The manual contains information about purpose, technical details, operating principle, design, and installation of the
BLABBRAVO unit and all its modifications.
Technical and maintenance staff must have theoretical and practical training in the field of ventilation systems and should
be able to work in accordance with workplace safety rules as well as construction norms and standards applicable in the
territory of the country.

3
EN
READ THE USER’S MANUAL CAREFULLY BEFORE PROCEEDING WITH INSTALLATION WORKS.
COMPLIANCE WITH THE MANUAL REQUIREMENTS ENSURES RELIABLE OPERATION AND LONG
SERVICE LIFE OF THE UNIT.
KEEP THE USER’S MANUAL AVAILABLE AS LONG AS YOU USE THE UNIT. YOU MAY NEED TO
REREAD THE INFORMATION ON THE PRODUCT SERVICING.
All user’s manual requirements as well as the provisions of all the
applicable local and national construction, electrical, and technical
norms and standards must be observed when installing and
operating the unit.
Disconnect the unit from the power supply prior to any connection,
servicing, maintenance, and repair operations.
Only qualied electricians with a work permit for electrical
units up to 1000 V are allowed for installation. The present user’s
manual should be carefully read before beginning works.
Check the unit for any visible damage of the impeller, the casing, and
the grille before starting installation. The casing internals must be free
of any foreign objects that can damage the impeller blades.
While mounting the unit, avoid compression of the casing!

4
EN
Deformation of the casing may result in motor jam and excessive
noise.
Misuse of the unit and any unauthorised modifications are not
allowed.
Do not expose the unit to adverse atmospheric agents (rain, sun, etc.).
Transported air must not contain any dust or other solid impurities,
sticky substances, or fibrous materials.
Do not use the unit in a hazardous or explosive environment
containing spirits, gasoline, insecticides, etc.
Do not close or block the intake or extract vents in order to ensure the
efficient air flow.
Do not sit on the unit and do not put objects on it.
The information in this user’s manual was correct at the time of the
document’s preparation.
The Company reserves the right to modify the technical
characteristics, design, or configuration of its products at any time in
order to incorporate the latest technological developments.
Never touch the unit with wet or damp hands.

5
EN
Never touch the unit when barefoot.
This appliance can be used by children aged from 8 years and above
and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge if they have been given supervi-
sion or instruction concerning use of the appliance in a safe way and
understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children with-
out supervision
Precautions must be taken to avoid the back-flow of gases into the
room from the open flue of gas or other fuel-burning appliances.
The appliance may adversely affect the safe operation of appliances
burning gas or other fuels (including those in other rooms) due to
back flow of combustion gases. These gases can potentially result
in carbon monoxide poisoning. After installation of the unit the

6
EN
THE PRODUCT MUST BE DISPOSED SEPARATELY AT THE END OF ITS SERVICE LIFE.
DO NOT DISPOSE THE UNIT AS UNSORTED DOMESTIC WASTE.
operation of flued gas appliances should be tested by a competent
person to ensure that back flow of combustion gases does not occur.
Connection to the mains must be made through a disconnecting
device, which is integrated into the fixed wiring system in accordance
with the wiring rules for design of electrical units, and has a contact
separation in all poles that allows for full disconnection under over-
voltage category III conditions.
Ensure that the unit is switched off from the supply mains before
removing the guard.

7
EN
DELIVERY SET
Fan - 1 pc.
Protective screen - 1 pc.
Screws with dowels - 4 pcs.
User’s manual - 1 pc.
Packing box - 1 pc.
BRIEF DESCRIPTION
The unit described herein is an axial fan for exhaust ventilation of small to medium-sized premises heated during winter. It
is designed for wall or ceiling mounting (Fig. 3-4). The fan is designed for connection to ø 100, 125 and 150 mm air ducts.
OPERATION GUIDELINES
The fan is rated for connection to single-phase AC 220-240 V/50 Hz power mains.
Air motion direction in the system must match the pointer on the fan casing.
Hazardous parts access and water ingress protection rating is IP22.
The fan is rated for operation at the ambient temperature ranging from +1 °C up to +40 °C.
The unit is rated as a Class II electrical appliance.

8
EN
INSTALLATION AND SET-UP
The fan is designed for wall or ceiling mounting with direct air exhaust to the ventilation shaft or into the round air duct of
matching diameter (Fig. 2).
Fan installation sequence:
step 1. Cut off power supply and make sure electricity has been turned off (Fig. 5).
step 2. Run the power cable to the vent hole (Fig. 6).
step 3. Remove the front panel from the fan. Then remove the circuit board cover (Fig. 7).
step 4. Mark and drill holes for mounting the fan and then install the fan (Fig. 8-10).
step 5. Connect the fan to power mains according to the wiring diagram (Fig. 13).
step 6. Install the front panel and the protective screen on the fan casing (Fig. 11).
step 7. Supply power voltage to the fan (Fig. 12).
TERMINAL DESIGNATIONS ON WIRING DIAGRAMS
L— phase (220-240 V only) S— external switch
N— neutral (220-240 V only) QF — automatic circuit breaker
1
2
2250
2250
750
750
600
600
R 600
1
2
3
1
1
3
3
22
2
2
1
2
2
The unit with a protection rating against access to hazardous
parts and water ingress IP34 is allowed to be installed in zone
2, according to IEC 60364-7-701:2019.

9
EN
TECHNICAL MAINTENANCE
The fan maintenance periodicity is at least once per 6 months.
Maintenance steps:
• Disconnect the fan from power supply and make sure electricity has been turned off (Fig. 14).
• Remove the front panel and the protective screen, wipe the fan with a dry cloth or a brush (Fig. 15).
• Clean the front panel under running water (Fig. 16).
• Wipe the fan surfaces dry.
• Cover the fan with the front panel.
• Connect power supply to the fan (Fig. 17).
CAUTION! Do not allow water or liquid come into contact with electric components!
STORAGE AND TRANSPORTATION REGULATIONS
• Store the unit in the manufacturer’s original packaging box in a dry closed ventilated premise with temperature range
from +5 °C to + 40 °C and relative humidity up to 70 %.
• Storage environment must not contain aggressive vapors and chemical mixtures provoking corrosion, insulation, and
sealing deformation.
• Use suitable hoist machinery for handling and storage operations to prevent possible damage to the unit.
• Follow the handling requirements applicable for the particular type of cargo.
• The unit can be carried in the original packaging by any mode of transport provided proper protection against precipitation
and mechanical damage. The unit must be transported only in the working position.
• Avoid sharp blows, scratches, or rough handling during loading and unloading.
• Prior to the initial power-up after transportation at low temperatures, allow the unit to warm up at operating temperature
for at least 3-4 hours.

10
EN
BLAUBERG AUSTRALASIA WARRANTY
- This warranty is given by Blauberg Australasia Pty Ltd, with an office at U5, 45 Eastern Creek Drive, Eastern Creek, NSW 2766,
Australia. Phone [phone].
• From the date of purchase, the original purchaser is entitled to free replacement parts, or a new unit for a period of five
years from the date of purchase
• The defective parts or unit must be returned to Blauberg Australasia Pty Ltd at your own cost before an exchange or
parts or unit will be given
• A proof of purchase will be required before a warranty clam is accepted
• The warranty will also not cover damage caused by misuse, neglect, shipping accident, incorrect or improper
installation, voltage supply problems, unauthorised modification or repairs of any kind, exposure to corrosive
conditions, exposure to weather and where no fault is found with the product
• We will not cover any loss incurred by you in relation to the product or making the claim under this warranty including
without limitation any costs associated with installation, reinstallation, or transporting the product.
Additional information:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a
replacement of the purchased product for a major failure of the product. You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Our ventilation
products also come with a five years limited warranty given by the distributor Blauberg Australasia Pty Ltd, with an office at
U5, 45 Eastern Creek Drive, Eastern Creek, NSW 2766, Australia, as set out in the instruction manual in the box. If your product
does not provide the general features and functions described in the user documentation in the five year period after
delivery to you, please call Blauberg Australasia Pty Ltd, (ABN 85 637 003 582) on 1300 475 504 with details of your product,
serial number and proof of purchase. You maybe required to return the ventilation product to the address listed, in which
case such a return will be at your own cost.
The benefits under this warranty are in addition to other rights and remedies that you may have at law.

11
EN
FOLLOWING THE REGULATIONS STIPULATED HEREIN WILL ENSURE A LONG AND TROUBLE-FREE
OPERATION OF THE UNIT.
USER’S WARRANTY CLAIMS SHALL BE SUBJECT TO REVIEW ONLY UPON PRESENTATION OF THE
UNIT, THE PAYMENT DOCUMENT AND THE USER’S MANUAL WITH THE PURCHASE DATE STAMP.

12
EN
1.
2.
Model
Dimensions [mm] Weight
[kg]
a b c d e
BLABBRAVO 100 150 122 102 100 17 0.56
BLABBRAVO 125 176 144 104 125 17 0.73
BLABBRAVO 150 205 174 124 150 19 0.9
b
a
c
d
e

13
EN
3.
4.

14
EN
QF
L N
5. 6. 7.
8. 9.
10. 11. 12.

15
EN
QF
L
N
SL
N
QF
L
N
L
N
Contact of the switch
is OPEN.
Fan runs
Contact of the switch
is CLOSED.
Fan does not run
13.
BLABBRAVO 100/125/150
BLABBRAVO 100/125/150 S

16
EN
QF
L N
14. 15.
16. 17.

17
EN

18
EN

19
EN
Quality Inspector’s Stamp
Manufacture Date
Sold by
(name and stamp of the seller)
Purchase Date

B_Australasia175EN-03
www.blaubergventilation.com.au
BLABBRAVO
BLABBRAVO
100
125
150