Blaupunkt CHICAGO IVDM-7002 Product guide

Chicago IVDM-7002
Installation & Connections
Before attempting to connect, or operate this product, please read the manual completely.
TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO
NOT REMOVE THE
COVER (OR BACK).
NO USER-SERVICEABLE PARTS ARE INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION: THIS UNIT HAS BEEN ADAPTED WITH AN
INVISIBLE CLASS 1 LASER BEAM WHICH CAN CAUSE
HAZARDOUS RADIATION EXPOSURE IF DIRECTED. BE SURE
TO OPERATE THE UNIT CORRECTLY AS INSTRUCTED.
Caution:
This product satisfies FCC regulations when shielded cables and
connectors are used to connect the unit to other equipment. To
prevent electromagnetic interference with electric appliances, such
as radios and televisions, use shielded cables and connectors for
connections.
FCC NOTE (for U.S.A):
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect this equipment into an outlet on a circuit different form
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital apparatus
meets all requirements of the
Canadian lnterference - Causing
Equipment Regulations.
WARNING
To reduce the risk of fire or shock hazard, do not expose this DVD
player to rain or moisture.
CAUTION
THIS PRODUCT UTILIZES A LASER. USE OF CONTROLS OR
ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE. DO NOT OPEN COVER
AND DO NOT REPAIR YOURSELF. REFER SERVICING TO
QUALIFIED PERSONNEL.
Caution
Install the control unit away from moisture, heat sources, and places
exposed to strong magnetic or electric fields. When condensation
forms inside the player or on the surface of the disc due to sudden
temperature changes from cold to hot, the player may not operate
correctly. If this occurs, leave the player at room temperature for
about 2 hours or until the player becomes operational.
Warning
Never disassemble the main unit in any way. Electric shock or
exposure to an invisible laser beam may result. Do not look inside
the DVD player.
Installation
Install the in-dash unit so that the driver cannot view video while the
vehicle is in motion. The driver should park the vehicle in a safe area
and apply the parking brake before viewing video on the monitor.
Batteries
The batteries used in the remote control contain the chemical that
are harmful to the environment. Properly dispose of batteries.
Handling the Main Unit
For safety reasons,
• Do not use benzene or other solvents when cleaning.
• Wipe the main unit with a soft cloth.
This symbol indicates dangerous voltage
inside the product that presents a risk of
electric shock or personal injury.
This symbol indicates
important instructions
accompanying the product.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
KLASS 1 LASER APPARAT

When connecting the data cable to the
back of the main unit, it must be connected
as shown. Incorrect connection will cause
permanent damage to the unit.
Caution
FILTER &
FUSE BOX
12 V Constant
(Yellow)
Ground
(Black)
12 V Switched
(Red)
Illumination
(Orange)
Parking Brake (–)
(Green)
(Blue)
Data Bus
Blaupunkt CDC-A08 Input
Line Input
Main Unit
Control Unit
System Remote (Turn-On)
Max. 100mA
Chicago IVDM-7002
Main Unit & Control Unit Connections

• DO NOT connect any speaker wires to the metal
body or chassis of the vehicle.
• DO NOT connect the speaker common (-) wires
to each other.
• Connect each speaker wire directly to each
speaker terminal.
• All speaker common (-) wires must remain
floating. ie - no common connections or
connection to vehicle ground.
• Connect each pair of speaker leads only to a
single speaker (or speaker system) that has an
impedance of at least 4 ohms, as well as a
50-watt power-handling capability.
• DO NOT connect speaker leads to any inputs on
external amplifiers. This will cause damage to
the internal amplifier of this unit.
*Caution
AUX 3 Video Input
AUX 3 Audio Input
Center Speaker*
(Black)
(Black/White)
Front Left Speaker*
(White)
(White/Black)
Front Right Speaker*
(Gray)
(Gray/Black)
Rear Left Speaker*
(Green)
(Green/Black)
Rear Right Speaker*
(Purple)
(Purple/Black)
(Yellow)
(Black)
(Brown/White)
(Purple/White)
(Orange)
(Blue)
(Blue/White)
+
–
Center
Rear Right
Front Right
Front Left
Rear Left
Subwoofer
Monitor 2 Video Output
Monitor 2 Audio Output
Aux 2 Video Input
Aux 2 Audio Intput
Aux 1 Audio Input
Aux 1 Video Input
Monitor 1 Audio Output
Monitor 1 Video Output
Antenna Input
Audio
Preamp
Outputs
+
–
+
–
+
–
+
–
Fuse 12 V Constant
Ground
Twin CDC Remote (Turn-On)
Max. 100mA
Reverse (+)
Navi-Mute (–)
Power Antenna
Max. 100mA
System Remote (Turn-On)
Max. 100mA
Control Unit
Sirius input or
Blaupunkt Signal
Controller Connection
Sirius Cable Required (7 607 001 606)
1m 13 Pin Male/Male DIN Cable
Chicago IVDM-7002 Control Unit
Input & Output Connections

Chicago IVDM-7002 Main Unit
DX-N/DX-V Navigation Unit
RGB/RC-10 Adapter Cable
4m RGB Extension Cable
Speaker Output Connector
(Pin 5 & 6)
Navi Mute Connector
(Pin 4, Connects to orange wire
of Control unit)
Remote Mounted IR Sensor
(RC-10 Compatible)
Speaker
Chicago IVDM-7002
Main Unit to DX-N/DX-V Navigation Connections
Navigation Audio Kit - (7 607 001 607)
Kit includes:
• RGB/RC-10 Adapter Cable (7 607 001 609)
• 4 meter RGB Extension Cable (7 607 001 602)
• Speaker Output Connector (8 604 492 515)
• Speaker (8 618 842 586)
• Navi Mute Connector (7 607 001 608)