Blu VIVO ONE User manual

BLU Model: VIVO ONE
VIVO ONE
SERVICE MANUAL –ASSEMBLY/DISASSEMBLY
1

Chapter 1
EXPLODED VIEW AND COMPONENT DISPOSAL
EXPLODED DIAGRAM
2

BLU Model: VIVO ONE
Disassembly
1. Use SIM Tray Eject tool to separate Device and SIM tray ，and Remove 2 pcs pentagon screws by screw driver.
.
2 Remove battery cover.
3

BLU Model: VIVO ONE
3. Remove 13 pcs screws by screw driver，screw drive torque：0.6kgf.cm
.
4. Separate rear housing from handset by black stick
.
5Separate PCB connector with LCM FPC、Battery FPC、Side Key FPC、fingerprint FPC、front camera.
4

BLU Model: VIVO ONE
6. Remove PCBA screw, separate motor and antenna cable connector、back camera
.
7.Separate Side Key FPC and Receiver light sensation rubber，in accordance
with the direction of the arrow
5

BLU Model: VIVO ONE
8. Remove the Speaker module FPC and Antenna Board 、Speaker module、sub-board from tweezers
9. Separate battery and LCM FPC,
.
10. All components
6

BLU Model: VIVO ONE
Assembly
1. Apply the UV on front housing by UV machine, Combine front housing and LCM with glue
7
2. Insatll the maintenance jig and Maintain pressure with 45minsTake apart jigs after the time is over

BLU Model: VIVO ONE
3. Install REC and F-Camera Foam、breathe-led-guide、sensor rubber.
4. Install the F-Camera/B-Camera CONN
5. Install the motor、RF cable、side key FPC
8

BLU Model: VIVO ONE
6. Fasten the Screw to fix the MB
7. Paste side key FPC and waterproof label
9
8. Assemble SPK and SUB

BLU Model: VIVO ONE
9. Paste conductive tape and waterproof label
10. Paste SPK- mylar and route the cable and connect conn in the SB
11. Assemble BATTERY Connector on PCB Main, and stick Battery on Bezel case.
10