Before use, you must pair the headset with your cell phone. Pairing will create a stored connection in
the Z9 and your Bluetooth cell phone. Pairing has to be done only once, when first connecting to a
phone. The Z9 can store pairing information for three (3) different Bluetooth devices.
Pairing Procedure - This is an example procedure only.
These steps may differ from phone to phone, but the process will be the same.
1. First turn the phone OFF and then back ON again to refresh its memory.
2. Bring the mobile phone to about 30cm from the Z9 Dual Microphone.
3. Find the Bluetooth menu in your mobile phone. Turn Bluetooth ON.
(Check your mobile phone user guide)
4. With the Z9 OFF, Press and Hold the MFB for about 6 seconds until the LED flashes Blue.
5. Your headset is now ready to be discovered by your Bluetooth mobile phone.
6. Perform Bluetooth a device discovery on your mobile phone to add a new device. It takes a few
seconds to search for and find other Bluetooth devices around you.
7. When Bluetooth devices are found, the phone will display "BlueAnt Z9". Scroll to it and press OK
to confirm that you want to pair with it.
8.
Enter the Passkey "0000" when your phone prompts you. The phone will now pair with the BlueAnt Z9.
9. If your Bluetooth phone menu supports it "set as authorized" or "add to trusted devices"
10. Again select the BlueAnt Z9 to connect with it. OR, Press the MFB to connect with the phone.
BUTTON FUNCTION MATRIX
PAIRING
Note:
Standby Mode means connected
to a device but not on a call.
Idle Mode means the Z9 is
ON but not connected to any device
Multiple button presses
mean click together
Power ON MFB 3 Seconds From OFF
Power OFF MFB 3 Seconds Idle/Standby
Enter Pairing Mode MFB 6 Seconds From OFF
Connect to Device 1 MFB One Click Idle
Connect to Device 2 MFB Two Clicks Idle
Connect to Device 3 MFB Three Clicks Idle
Answer Call MFB Click Ringing
End Call MFB 3 Seconds Active Call
Reject Call MFB 3 Seconds Ringing
Redial Last Number VOL 3 Seconds Standby
Voice Dial Activate MFB Click Standby
Call Conference VOL 3 Seconds Active Call
Call Waiting 3 seconds Active Call
Volume Up VOL Click Active Call
Volume Down VOL Click Active Call
Mute VOL 3 Seconds Active Call
Turn LED’s OFF and 3 Seconds Idle/Standby
Reset Device &MFB & Click
Click
Idle
