BMW 51 47 0 027 792 User manual

Retrofit / Installation kit No. 51 47 0 027 792
Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001
F 46 0753 EVA
BMW aluminium footrest
BMW 3 Series (E 46)
Specialist knowledge required.
The installation time is approx. 0.5 hours, but this may vary depending on the condition of the
car and the equipment in it.
Retrofit / Installation kit No. 51 47 0 027 792
BMW Parts and Accessories
Installation Instructions

EN/2
Retrofit / Installation kit No. 51 47 0 027 792
Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001
Contents
Section Page
1. Important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
2. Preparations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
3. Parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
4. To install the BMW aluminium footrest. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
5. To assemble the car . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

EN/3
Retrofit / Installation kit No. 51 47 0 027 792
Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001
1. Important information
Target group
The target group for these installation instructions is specialist staff trained on BMW cars.
All servicing, repair and installation work on BMW cars is completed at your own risk.
All work is to be carried out using current BMW
- Repair manuals
- Servicing manuals
- Work instructions
in a rational sequence with the prescribed tools (special tools) and taking into account the
relevant health and safety regulations.
Safety instructions
BMW cannot accept any liability for damage caused by a failure to follow the work and
instructions set out in these installation instructions. If the part is installed and used
improperly and not as set out in the installation instructions, all warranty claims to BMW
AG shall be rendered void. (The rubber pad on the BMW aluminium footrest must be
checked for signs of wear at regular intervals. A badly worn rubber pad must be replaced
by a new rubber pad since otherwise your safety cannot be guaranteed when you are
driving the car.)
The supplementary sheet supplied with the kit is to be placed in the car after the installation
of the BMW aluminium footrest.
"
Installation information
Only use the securing screws provided to secure the aluminium footrest plate.
"
Required tools and equipment
Drill
3 mm drill bit
Hammer
Centrepunch
Scissors
Torx screwdriver TX 10
Deburring tool
!

EN/4
Retrofit / Installation kit No. 51 47 0 027 792
Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001
2. Preparations
0
TIS instruction No.
Remove the door sill strip from the front left (interior) 51 47 000
Remove the trim for the pedals 51 45 185
Remove the side footwell trim on the left A pillar 51 43 070
Cut out the drilling template

EN/5
Retrofit / Installation kit No. 51 47 0 027 792
Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001
3. Teileübersicht
0
0
A Aluminium footrest plate 1x
B Rubber footrest pad 1x
C Torx screw K4 x 10 (self-tapping thread) 6x
D Drilling template (Order No. 01 29 0 136 496) 1x
F 46 0754 EVA
C
DBA

EN/6
Retrofit / Installation kit No. 51 47 0 027 792
Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001
4. To install the BMW aluminium footrest
0
0
0
0
Place the drilling template (D) on the surface of the
footrest (1) on the side footwell trim (2) in the
centre between the edge radius on each side.
Adjust the bottom right corner of the drilling
template until it is flush with the bottom edge of the
surface of the footrest (1). Mark the holes from the
drilling template (D) on to the surface of the
footrest (1) on the side footwell trim (2).
Remove the drilling template (D). Centrepunch the
holes (1), drill then with a 3 mm drill bit and deburr
them.
0
Press the rubber pad (B) into the aluminium plate
(A) from the rear. Secure the aluminium plate (A)
with the fitted rubber pad (B) to the surface of the
footrest (1) in the side footwell trim (2) using the six
Torx screws K4 x 10 (C). Tighten the Torx screws
K4 x 10 (C) by hand.
F 46 0755 EVA
D
1
2
F 46 0756 EVA
BB
A
C
1
2

EN/7
Retrofit / Installation kit No. 51 47 0 027 792
Installation Instructions No. 01 29 0 136 495 Issue date: 3.2001
5. To assemble the car
Assemble the car again following the instructions for its dismantling in reverse order.
0
0