Bobrick Cub B-705 User manual

Cub_DTG r10-09 Page 1 of 5
Cub™ Dryer
Guide
Effective 10/09
www.bobrick.com
U.S. Headquarters: BOBRICK WASHROOM EQUIPMENT, INC.
11611 Hart Street, North Hollywood, California 91605-5882, Tel: [phone], FAX: [phone]
Email: [e-mail]
Canada Headquarters: BOBRICK WASHROOM EQUIPMENT COMPANY.
45 Rolark Drive, Scarborough, Ontario M1R 3B1, Eastern: 877.423.6555, FAX: [phone], Western: 877.423.6444,
FAX: [phone], Email: [e-mail]
International Sales: BOBRICK WASHROOM EQUIPMENT, INC.
11611 Hart Street, North Hollywood, CA 91605-5882, +1.818.764.1000, FAX: [phone]
Email: [e-mail]
Australia: Bobrick Washroom Equipment Pty Ltd., 1.800.353158, FAX: [phone]
Email: [e-mail]
Germany: 0800.79.00.456, FAX: [phone] Email: [e-mail]
United Kingdom: Bobrick Washroom Equipment Ltd., +44.0.20.8366 1771, FAX: [phone].
Email: [e-mail]
All Bobrick dryers require cleaning every 6 months to ensure
that they function effectively. Please note that failing to clean
the dryer may result in malfunction and can void the warranty.
(Refer to page 3 of the Dryer Troubleshooting and Information Guide for Routine Maintenance Instructions)

Cub_DTG r10-09 Page 2 of 5
Cub™ Dryer
Contents Page
1. Information and Troubleshooting 3
2. Limited Warranty 4
3. Schematic Diagram 5

Cub_DTG r10-09 Page 3 of 5
Warning
Risk of electric
shock
Disconnect power
supply before
removing cover
Information and Troubleshooting
for the B-705 CubTM Dryer
For complete set of Installation Instructions refer to form No. 705-69
http://www.bobrick.com/Bobrick/Install_Instructions.aspx
Information about the Dryer:
•Model B-705 CubTM is not designed for vandal-prone installations. For vandal-prone
installations use Bobrick AirCraft®dryers with cast-iron, vitreous enamel finished covers.
•There are no replacement parts available for this dryer except for the cover.
Product Type:
B-705 Series A
Electrical Characteristics:
Model B-705, 115V, 9A, 1035W, 60HZ, Single Phase, cULus listed.
Model B-705E, 220-240V, 6.5A, 1500W, Single Phase, VDE approved, CE marked.
Removal of Cover
Start installation of dryer by removing cover. Remove
two screws, from the bottom of the dryer. Pull bottom
of the cover away from the mounting base. Rotate
cover up until tabs on top of the cover release from
the top of the mounting base.
When the tabs on top of the cover are separated
from the top of the mounting base, the cover can be
removed.
If a fault occurs with the dryer:
1. Check that the electrical supply is OK.
2. Check that the circuit breaker is switched on.
3. Check that sensor is clean and not obstructed, the sensor optics can be cleaned with
a cotton swab.
Replacement Parts
705-150 Dryer Cover Series A

Cub_DTG r10-09 Page 4 of 5
Limited Warranty
The Bobrick B-705 CubDryer™ and all parts are warranted to the original owner of the
installed unit for one year from date of original installation against defects in factory
workmanship or material under normal use and service *
This warranty is limited to repair or exchange of defective parts at the option of Bobrick.
THIS WARRANTY DOES NOT COVER ACCIDENTAL DAMAGE, IMPROPER
HANDLING OR INSTALLATION, OR REPAIRS MADE BY UNAUTHORIZED PERSONS,
AND SPECIFICALLY EXCLUDES CLAIMS FOR INDIRECT, ACCIDENTAL OR
CONSEQUENTIAL DAMAGES TO PROPERTY. THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO
THE SAME DURATION OF THE ABOVE WARRANTY.
Some states do not allow the exclusion of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. Some states do not allow limitations on
how long an implied warranty lasts, so the above limitation may not apply to you. This
warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
* Normal service constitutes performing the following preventive maintenance
procedures at six-month intervals:
Clean any lint, dust or grease from air-intake grille and air-outlet grille.
Labor costs for preventive maintenance shall be at owner's expense.
For repair or exchange of defective part, send the part together with installation date and
serial number to Bobrick.

Cub_DTG r10-09 Page 5 of 5
Schematic Diagram
115V Dryer
Schematic Diagram
220-240V Dryer