Body Solid SGH500 User manual

OWNER’S MANUAL
®

Warning, Safety & Maintenance
#DWRULE-4

Table of Contents

Important Safety Instructions
When using exercise equipment, you
should always take basic precautions,
including the following:
m
m
m
m
m
m
m
m
m
m
m
m
m
Personal Safety During Assembly
m
m
m
Obtaining Service
Retain this Owner’s Manual for future
reference. If you need to order replacement
parts please be prepared to provide the
following information when contacting us so
that we can assist you better.
1. Model Number
2. Place of Purchase
3. Serial Number (S/N)
4. Part # and Description

Preparation
Required Tools
m
m
m
m
m
m
Installation Requirements
Assembly Tips

Part# Size Description Quantity
SGH500 Hardware List

SGH500 Hardware Illustration
 
 

 



SGH500 Hardware Illustration




 

SGH500 Parts List/Illustration

SGH500 Parts List/Illustration

SGH500 Parts List/Illustration

STEP
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.

STEP
1

STEP
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.

STEP
2

STEP
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware fi r st in this step. Wrench tighten ALL hardware at the end of
STEP 3B. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tighten to fully go on.

STEP
3

STEP
4
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware fi r st in this step. Wrench tighten ALL hardware at the end of
STEP 4H. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tighten to fully go on.

STEP
4