Bradley S19-240 User manual

P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 1-800-BRADLEY FAX [phone]
http://www.bradleycorp.com
Installation
215-161 Rev. L; EN 06-532E
© 2007 Bradley Corporation
Page 1 of 5 4/26/07
S19-240, S19-240FW
Unmounted Eyewash and
Eye/Face Wash - Laboratory
Application
Table of Contents
Pre-Installation Information . . . . . . . . . . . . . . . .2
Installation Instructions . . . . . . . . . . . . . . . . . . . .3
S19-240 Components and Parts List . . . . . . . . . .4
S19-240FW Components and Parts List . . . . . . .5
S19-240
S19-240FW

2
S19-240, S19-240FW Installation
4/26/07 Bradley Corporation • 215-161 Rev. L; EN 06-532E
WARNING
Read this installation manual completely to ensure proper installation, then file it
with the owner or maintenance department. Compliance and conformity to drain
requirements and other local codes and ordinances is the responsibility of the
installer.
Separate parts from packaging and make sure all parts are accounted for before
discarding any packaging material. If any parts are missing, do not begin
installation until you obtain the missing parts.
Flush the water supply lines before beginning installation and after installation is
complete. Test the unit for leaks and adequate water flow. Main water supply to
the eyewash should be “ON” at all times. Provisions shall be made to prevent
unauthorized shutoff.
The ANSI Z358.1 standard requires an uninterruptible supply of flushing fluid at a
minimum 30 PSI (0.21 MPa) flowing pressure. Flushing fluid should be tepid per
ANSI Z358.1.
The inspection and testing results of this equipment should be recorded weekly
to verify proper operation. This equipment should be inspected annually to
ensure compliance with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be
trained regarding the placement and proper operation of emergency equipment
per ANSI Z358.1.
For questions regarding the operation or installation of this product, visit
www.bradleycorp.com or call 1-800-BRADLEY.
Product warranties may also be found under ”Product Information” on our web
site at www.bradleycorp.com.
Installation
THIS
SIDE
UP
Packing List
!
!
!
!
P.O.Box309, MenomoneeFalls, WI 53051
R
TESTTHISUNITEACHWEEK
Test-operatevalve(s) each week and sign below.
Reportany malfunctions immediately.
Ventil(e)wöchentlich im Testbetrieb prüfen, bestätigt
durchUnterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESESGERÄT1STWÖCHENTLICHZUPRÜFEN.
ESSAIHEBDOMADAIRE
Testle fonctionnement des valves chaque semaine et
signeen bas. S'il y à quelque chose qui ne va pas fait
unrapport immédiatement.
P.O.BOX309, MENOMONEE FALLS,WI 53052-0309 USA
TEL:1-800-BRADLEY FAX: [phone])
http://www.bradleycorp.com
114-051

Installation
Supplies Required:
• Pipe sealant
• Piping to 1/2" IPS water supply inlet on unit
• Sign-mounting hardware
Step 1: Assemble eyewash
components
1. Assemble eyewash components as shown
in Figure 2a on page 4 (S19-240) or Figure
2b on page 5 (S19-240FW).
• Apply pipe sealant (supplied by
installer) to all male-threaded pipe
joints.
• Use the rubber grip pad provided or a
strap wrench around pipes when
tightening to prevent marring. Place the
grip pad on the pipe, then put the
wrench over the grip pad and turn the
pipe with the wrench.
NOTE: The top of the eyewash heads should be
33"–45" (838mm–1143mm) from the floor.
Step 2: Connect water supply
1. Connect water supply piping (supplied by
installer) to the 1/2" IPS inlet on the
eyewash (see Figure 1).
2. Open the water supply lines. Test for leaks
and adequate water flow.
3. Mount the safety sign to the wall using
sign-mounting hardware (supplied by
installer).
6-3/8"
(162mm)
5-1/4"
(133mm)
3-1/2"
(89mm)
5-3/4"
(146mm)
13-7/8"
(352mm)
1/2" IPS
Supply Inlet
6-3/8"
(162mm)
5-1/4"
(133mm)
3-1/2"
(89mm)
7-1/8"
(181mm)
14"
(356mm)
1/2" IPS
Supply Inlet
Figure 1
S19-240FW
S19-240
3
Installation S19-240, S19-240FW
Bradley Corporation • 215-161 Rev. L; EN 06-532E 4/26/07

Assembly of Components and Parts List
4
S19-240, S19-240FW Installation
4/26/07 Bradley Corporation • 215-161 Rev. L; EN 06-532E
P.O. BOX309
MENOMONEEFALLS, WI53052-0309 USA
TEL:1-800-BRADLEYFAX:(262-251-5817)
http://www.bradleycorp.com
1.2
1.1
1.3
1.4
1.5
1.6
1.7
2
3
4
7
6
5
8
4.1
2
P.O.BOX 309, MENOMONEE FALLS,WI 53052-0309 USA
TEL:1-800-BRADLEY FAX:[phone])
http://www.bradleycorp.com
P.O. Box 309, Menomonee Falls, WI 53051
R
TEST THIS UNIT EACH WEEK
Test-operate valve(s) each week and sign below.
Report any malfunctions immediately.
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt
durch Unterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAI HEBDOMADAIRE
Test le fonctionnement des valves chaque semaine et
signe en bas. S'il y à quelque chose qui ne va pas fait
un rapport immédiatement.
1
Figure 2a
Prepack S45-122 includes Items 4, 4.1, 5, 8
Prepack S45-123 includes Items 4.1, 5, 8
1 S05-063B 1 Eyewash Assembly
1.1 S05-091 1 Eyewash Yoke
1.2 107-371 2 Dust Cover
1.3 110-237 1 Tailpiece, Plated
1.4 142-040 1 Retainer
1.5 125-032 1 Flo-et
1.6 124-001AF 1 Washer
1.7 153-146 1 Union Adapter
2 169-862 2 90° Street Elbow
3 113-596 1 Pipe Nipple
4 S27-282 1 1/2" IPS Ball Valve with Nut
4.1 110-215 1 Nut Only
5 128-135 1 Handle
6 114-051 1 Safety Sign
7 204-421 1 Emergency Inspection Tag
8 142-002DA 1 Lockwasher
Item Part No. Qty Description Item Part No. Qty Description

Assembly of Components and Parts List
P.O. BOX 309
MENOMONEEFALLS, W I53052-0309 USA
TEL:1-800-BRADLEYFAX:(262-251-5817)
http://www.bradleycorp.com
1.2
1.1
1.3
1.4
1.5
1.6
1.2
2
3
4
7
6
5
8
4.1
2
P.O.BOX 309, MENOMONEE FALLS,WI 53052-0309 USA
TEL:1-800-BRADLEY FAX:[phone])
http://www.bradleycorp.com
P.O. Box 309, Menomonee Falls, WI 53051
R
TEST THIS UNIT EACH WEEK
Test-operate valve(s) each week and sign below.
Report any malfunctions immediately.
Ventil(e) wöchentlich im Testbetrieb prüfen, bestätigt
durch Unterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESES GERÄT 1ST WÖCHENTLICH ZU PRÜFEN.
ESSAI HEBDOMADAIRE
Test le fonctionnement des valves chaque semaine et
signe en bas. S'il y à quelque chose qui ne va pas fait
un rapport immédiatement.
1
Figure 2b
5
Installation S19-240, S19-240FW
Bradley Corporation • 215-161 Rev. L; EN 06-532E 4/26/07
1 S05-064 1 Eye/Face Wash Assembly
1.1 S05-091P 1 Eyewash Yoke
1.2 S05-135 1 Eye/Face Wash Head
1.3 S53-063 2 Dust Cover
1.4 110-237 1 Tailpiece, Plated
1.5 124-001AF 1 Washer
1.6 153-146 1 Union Adapter
2 169-862 2 90° Street Elbow
3 113-596 1 Pipe Nipple
4 S27-282 1 1/2" IPS Ball Valve with Nut
4.1 110-215 1 Nut Only
5 128-135 1 Handle
6 114-051 1 Safety Sign
7 204-421 1 Emergency Inspection Tag
8 142-002DA 1 Lockwasher
Item Part No. Qty Description Item Part No. Qty Description
Prepack S45-122 includes Items 4, 4.1, 5, 8
Prepack S45-123 includes Items 4.1, 5, 8