BrandMotion ADAS Series User manual

! INSTALLATION!INSTRUCTIONS!
ADAS-1020 Instructions 1-10-18 Page 1 of 2
ADAS+ Seat Belt Vibration Alert Module
(Kit # ADAS-1020)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Seat Belt Vibration Alert Module
These instructions
Wire strippers
Wire cutters
Electrical tape
Zip ties
Plastic panel removal tools
Digital Volt Meter / BCM safe test light
Screwdriver
Socket set
Wrench
Safety Precautions:
•Work in well ventilated area that is clear of obstructions.
•Secure vehicle with tire chucks in both front and rear of tires.
•Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•Wear safety goggles and snug fitting clothes.
•Use tools only for their intended purpose and which are in good repair.
•Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com

! INSTALLATION!INSTRUCTIONS!
ADAS-1020 Instructions 1-10-18 Page 2 of 2
1. The white plug on the vibration module
plugs into the connector on the HUB from
the main ADAS-100 unit marked vibrator.
2. The module can be mounted 2 ways.
2a. Insert the module into the black cloth
sleeve and attach to the vehicle seat belt.
Attach the belt that DOSE NOT move or
retract. Take caution not to pinch the cable
in the track from the seat.
2b. Cut a small slit in the bottom seat foam
from under the seat. Be careful not to cut
the seat cover be going all the way through.
Insert the module into the foam and secure
module to foam. Run the cable with any
factory harnesses and secure with zip ties.
Take caution not to pinch the cable in the
track from the seat.
The switch on the module will change the
output of the vibration.
1-low
2-medium
3-high