
6EN
• Transport the coee maker in the original package.
• Keep the unit out of reach of children and disabled
• persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the coee maker and remove all the
packaging materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the coee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specications of power supply
voltage specied on the label correspond to the
specications of your mains. When the unit is used in
the mains with 60 Hz frequency, it does not need any
additional settings.
• Wipe the surface of the coee maker body with a
clean, slightly damp cloth to remove dust.
• Make sure that the control buttons (8, 9) are in the
o position.
• Make sure that the steam supply is closed. To do this
turn the knob (16) « /» to the position « ».
• Before using the coee maker for the rst time, wash
all removable parts (1, 2, 5, 6, 15, 20) with warm
water and neutral detergent, rinse and dry them.
• Remove the water tank (15), ll it with cold water up
to the MAX mark and install it back to its place.
• Install the coee lter (6) (do not add ground coee
into the lter) into the holder (5) having preliminary
matched the ledge on the lter (6) with the groove on
the holder (5) and turn the lter (6) counter/clockwise
to x the lter.
• Install the lter holder (5) into the coee maker. The
holder (5) ledges should match the grooves on the
boiler « », after that turn the lter holder handle
(3) to the right until bumping « ».
• Place a suitable cup on the grid (2).
• Insert the power plug into the mains socket.
• Switch the coee maker on, setting the power switch
(19) to the «I» position, the indicator (11) will light up,
and the ready indicator (10) will start ashing.
• To ll the boiler with water press the button (9) «
», wait for 15-20 seconds, or at the rst signs
of appearance of water in the cup, switch the water
supply o by pressing the button (9) « » again.
• Wait until the indicator (10) glows constantly, then
switch the water supply on by pressing the button
(9) « ». After the cup is lled with water, press the
button (9) « » again to switch the water supply o