Breville the Quick Stack LPC140SIL User manual

the Quick Stack™
Instruction Book - LPC140SIL

2
IMPORTANT
SAFEGUARDS
READ ALL
INSTRUCTIONS BEFORE
USE AND SAVE FOR
FUTURE REFERENCE
•Carefully read all
instructions before
operation and save for
future reference.
•Remove any packaging
material and promotional
stickers before using the
pancake maker for the first
time.
•To eliminate a choking
hazard for young children,
remove and safely discard
the protective cover fitted
to the power plug of this
appliance.
•Always ensure the
pancake maker is properly
assembled before use.
Follow the instructions
provided in this book.
2Breville Recommends Safety First
7Components
8Functions
10 Care & Cleaning
11 Recipes
BREVILLE
RECOMMENDS
SAFETY FIRST
At Breville we are very safety
conscious. We design and
manufacture consumer
products with the safety of you,
our valued customer, foremost
in mind. In addition we ask
that you exercise a degree of
care when using any electrical
appliance and adhere to the
following precautions.
Contents

3
•Do not place the pancake
maker near the edge of
a bench or table during
operation. Ensure the
surface is level, clean and
free of water.
•Do not use on a sink drain
board.
•Always operate the
pancake maker on a
stable and heat resistant
surface. Do not use on
a cloth-covered surface,
near curtains or other
flammable materials.
•Keep the pancake maker
clear of walls, curtains
and other heat or steam
sensitive materials
•Do not place the pancake
maker on or near a hot
gas or electric burner,
or where it could touch
a heated oven. Use the
pancake maker well away
from walls.
•Do not touch hot surfaces.
Use the handle to lift and
open the top plate.
•Do not leave the pancake
maker unattended when
in use.
•Do not place anything on
top of the pancake maker
when the lid is closed,
when in use and when
stored.
•When operating the
pancake maker, ensure
the power cord is kept
away from any heat source
including the surface of the
pancake maker. Ensure
the power cord does not
become trapped between
the upper and lower hot
plates of the pancake
maker during use and
storage.
•Always switch the pancake
maker off at the power
outlet, then unplug the
power cord and allow to
cool, if the appliance is not
in use, before cleaning,
before attempting to
move the appliance,
disassembling, assembling
and when storing the
appliance.

4
•Do not use chemicals,
steel wool, metal scouring
pad or abrasive cleaners to
clean the pancake maker
as these can damage the
housing or the coating of
the cooking plates.
•Always remove the food
from the pancake maker
with a heatproof plastic
spatula or tongs. Never
use your hands.
•Do not use sharp objects
or utensils inside the
pancake maker as they
may scratch or damage
the interior surface of the
hot cooking plate.
•The pancake maker is not
intended to be operated
by means of an external
timer or separate remote
control system.
•Keep the exterior housing
and the non-stick cooking
plates clean. Follow the
cleaning instructions
provided in this book
(Page 10).
WARNING
Fully unwind power cord
from cord storage facility
before use.
IMPORTANT
SAFEGUARDS FOR
ALL ELECTRICAL
APPLIANCES
•Fully unwind the power
cord before use.
•Connect only to 230V or
240V power outlet.
•Do not let the power cord
hang over the edge of
a bench or table, touch
hot surfaces or become
knotted.
•To protect against electric
shock, do not immerse the
power cord, power plug
or appliance in water or
any other liquid, unless
it is recommended in the
cleaning instructions.

5
•The appliance is not
intended for use by
persons (including
children) with reduced
physical, sensory or
mental capabilities,
or lack of experience
and knowledge, unless
they have been given
supervision or instruction
concerning use of the
appliance, by a person
responsible for their
safety.
•Children should be
supervised to ensure that
they do not play with the
appliance.
•It is recommended to
inspect the appliance
regularly. Do not use
the appliance if the
power supply cord, plug,
connector or appliance
becomes damaged in
any way. Return the
entire appliance to
the nearest authorised
Breville Service Centre
for examination and/or
repair.
•Any maintenance other
than cleaning should be
performed at an authorised
Breville Service Centre.
•This appliance is for
household use only.
Do not use this appliance
for other than its intended
use. Do not use in moving
vehicles or boats.
Do not use outdoors.
Misuse may cause injury.
•The installation of a
residual current device
(safety switch) is
recommended to provide
additional safety protection
when using electrical
appliances. It is advisable
that a safety switch with a
rated residual operating
current not exceeding
30mA be installed in the
electrical circuit supplying
the appliance. See your
electrician for professional
advice.

6
•Always turn the appliance
to the OFF position,
switch off at the power
outlet and unplug at the
power outlet when the
appliance is not in use.
•Before cleaning, always
turn the appliance to the
OFF position, switch off at
the power outlet, unplug
at the power outlet and
remove the power cord,
if detachable, from the
appliance and allow all
parts to cool.
•Do not place this
appliance on or near a
heat source, such as hot
plate, oven or heaters.
•Position the appliance at
a minimum distance of
20cm away from walls,
curtains and other heat or
steam sensitive materials
and provide adequate
space above and on all
sides for air circulation.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS

7
A. Cool-touch handle
B. START/CANCEL button
C. ‘Power’ & ‘Ready’ indicator lights
D. Timer Increase/Decrease buttons
E. LED Display with count-down timer
F. PFOA-free non-stick coating
For quick and easy cleaning.
G. Four large pancake wells
H. A Bit More™ button
Press to automatically add additional time to get your
pancakes just right without having to reset the timer.
I. Non-slip feet
For stability.
I
H
A
F
G
C
D
B
E
Not Shown
• Auto o
Heating turns off after timer counts down to zero
and the pancake maker will enter Standby mode..
• Cord storage integrated into base
Components

8
Functions
OPERATING YOUR BREVILLE
PRODUCT
Before first use, remove and safely discard any
packing material, promotional labels and tape
from the pancake maker.
WARNING
Fully unwind power cord from cord storage
facility before use.
BEFORE FIRST USE
Check that cooking plates are clean and free
of dust. Wipe over with a damp cloth. Place the
pancake maker on a flat, level surface with the
lid in the closed position.
Ensure there is a minimum distance of 20cm of
space on all sides of the pancake maker. Ensure
there are no items on top of the pancake maker.
1. Insert power plug into a 230/240V power
outlet and turn the power on. The unit will
be in standby mode and the screen will
display 2 dashes.
2. Press the button to start pre-heating.
The ‘POWER’ light will illuminate red and
the screen will show a rotating loop ‘ ’
whilst pre-heating.
3. Once the pancake maker has finished
pre-heating, the ‘POWER’ light will remain
lit and the ‘READY’ light will illuminate
green, the unit will beep 3 times to alert
that the pre-heat has finished and ‘ ’ will
continuously flash on the screen.
NOTE
If you don’t attend to the unit within 30 seconds
after the initial pre-heat, the unit will continue
pre-heating for an additional 20 minutes with
the screen continuing to show the rotating
loop. The ‘Power’ light will remain on and the
‘READY’ light will cycle on and off.
If after 20 minutes you still have not attended
to the unit to set your cooking time, the unit
will go into auto off, the unit will sound 5
beeps, stop heating and 2 dashes '– –' will
be displayed on the screen and both the
‘POWER’ and ‘READY’ lights will no longer be
illuminated indicating heating has stopped.
4. Open the lid and pour/place your batter/
ingredients evenly into the centre of each
well. The total volume of batter/ingredients
should not exceed the rim of the bottom
cooking well.
NOTE
Do not overfill the cooking wells. 1/3 cup is
the maximum amount of pancake batter per
cooking well.
5. Set your required cooking time using the
timer increase decrease buttons.
Select a time between 1 to 15 minutes.
6. Press button to commence cooking.
The time will stop flashing to indicate that
the timer is counting down.
7. During this time the ‘POWER’ light will
remain lit, while the ‘READY’ light will
illuminate green.
NOTE
The ‘READY’ light will continue to cycle
on and off to indicate the pancake maker is
maintaining the correct temperature.

9
8. The timer will countdown by 1 minute
intervals, displaying the remaining cooking
time on the LED screen. Once it reaches
1 minute it will then count down by seconds
until cooking time has elapsed.
9. When the cooking time has elapsed, the
pancake maker will beep 5 times and go
into standby mode. The LED screen will
continuously flash displaying ‘– –’ on the
screen. Both the ‘POWER’ and ‘READY’
light will no longer illuminate indicating
heating has stopped.
A BIT MORE™
After the initial cooking time has elapsed, you
may want to cook your pancakes just ‘a bit
more’.
Press the A BIT MORE™ button to quickly and
conveniently add an additional 30 seconds to a
cooking cycle.
A BIT MORE™ can be used immediately
after the initial cooking cycle has finished;
an additional 30 seconds will display on
the screen. ‘POWER’ and ‘READY’ light will
illuminate.
10. Open the lid and carefully remove your
pancakes with the help of a silicone spatula.
Never use metal tongs or a knife as these
can cause damage to the non-stick coating.
11. Alternatively, if you just want to add more
batter/ingredients to cook a new batch.
Repeat steps 4 to 6.
12. Once you are finished cooking, press the
START/CANCEL button, switch the unit off
at the power outlet and remove the power
plug from the power outlet.
NOTE
Making standard pancakes should take
approximately two to three minutes. Exact
cooking time will depend on the type of filling
used. To maintain even heat, keep the lid
closed until you are ready to add your next
batch.
NOTE
At all times the lid must be locked closed.
When using the pancake maker for the first
time you may notice a fine smoke haze.
This is caused by the heating of some of the
components. There is no need for concern.
WARNING
Steam will be ejected from between the
cooking plates when the lid is closed.
Be careful not to make contact with the
steam as it may cause burns.

10
Care & Cleaning
Before cleaning, ensure the power is switched
off and then remove the power plug from the
power outlet.
Allow your pancake maker to cool before
cleaning however, the pancake maker is easier
to clean when still slightly warm.
Always clean your pancake maker after each
use to prevent a build-up of baked-on foods.
Wipe cooking plates with a soft, damp cloth to
remove food residue.
WARNING
Do not immerse any part of the Breville
Pancake maker or the power cord in water or
any other liquid.
PFOA-FREE NON-STICK COATING
Cooking on a non-stick surface minimises the
need for oil as food does not stick and cleaning
is easier. Any discolouration that may occur
will only detract from the appearance of the
pancake maker and will not affect the cooking
performance. When cleaning the non-stick
coating, do not use metal (or other abrasive)
scourers. Wash with warm soapy water and dry
thoroughly.
Remove stubborn residue using a damp cloth.
SEASON THE PLATES
Season the plates occasionally to prevent
sticking and to make cleaning easier. To
season, brush the cooking plates with a little
vegetable oil and rub off the excess with
absorbent paper. Do this after preheating the
unit.
Do not use spray on non-stick coatings as this
will affect the performance of the non-stick
surface on the cooking plates.
NOTE
The cooking plates, hinges and overflow moat
are coated with a non-stick surface, do not use
abrasives.
STORAGE
To store your pancake maker:
1. Ensure the power is off and then unplug
power cord from the power outlet.
2. Allow the pancake maker to fully cool.
3. Wrap the power cord in the cord wrap area
below the pancake maker.
4. Store on a flat, dry level surface.
Do not place anything on top of the
pancake maker.
WARNING
The handle is designed for opening and
closing the pancake maker during cooking.
It should not be used for moving or carrying
the pancake maker.
When moving the pancake maker, allow the
unit to fully cool down and carry the unit via
the base.