Brodit 711027 User manual

17 June, 2020, www.brodit.com, © 2020 Brodit AB
Product 711027
711027 Passive holder with tilt swivel
With your PDA in a passive holder attached onto the dashboard it is always within easy reach -safe and
convenient. The holder is mounted onto a tilt swivel so it is adjustable for avoiding light reflection on the screen. It
is easy to put the PDA in the holder, and to take it out of the holder. You can connect e.g. a charging cable to the
PDA when it is in the holder.
EAN: 7320287110272
Item no 711027 fits:
Motorola MC3200 (For all countries)
Zebra MC3200 (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed
screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns
on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same
time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in
place, but still can be adjusted.
3. To place the device in the holder: Place the lowerpart of the device into the holder. Press the device downward
into place in the holder. To remove the device from the holder: Push the decvice uppward. When the device is set
free, lift it upward out of the holder.
4. The holder is in place.