Brodit ProClip 804816 User manual

28 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 804816
804816 ProClip
Left mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288048161
Item no 804816 fits:
Audi A1 11-15 (For all countries)
1(2)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Press the thin end of the
enclosed gap opener into the gap between the frame surrounding the air vent and the dashboard, to widen the
gap obliquely above the air vent. Peel off the adhesive tape covers on the ProClip. Press/Hook the angled edge
on the upper part of the ProClip into the gap next to the gap opener. Press downward on top of the ProClip so all
of the the curved angled edge goes all the way into the gap. Pull out the gap opener.
2. Press the gap opener into the gap between the frame surrounding the air vent and the dashboard to widen the
gap obliquely below the air vent. Pull the lower part of the ProClip downward and hook the angled edge into the
gap next to the gap opener.
3. Press upward on the lower part of the ProClip so all of the curved angled edge goes all the way into the gap.
Pull out the gap opener. This ProClip can be placed onto any of the air vents, also onto the ones placed on the
right side of the steering wheel).
4. The ProClip is in place.
2(2)