Brodit 727203 User manual

25 May, 2020, www.brodit.com, © 2020 Brodit AB
Product 727203
727203 Active holder for fixed installation Adjustable holder with Type C connector. Fits for devices with and
without skin with the following dimensions: Width: 70-83 mm, Thickness: 2-10 mm. With USB cable. 2 USB ports:
QC 3.0A + 2.4A. With tilt swivel. 12/24 Volt.
With your mobile in a holder while driving you will always have it within easy sight and reach! And with an active
holedr you always have a charged battery when leaving the car. Neat, discreet and convenient! For fixed
installation. The holder is to be connected inside the dashboard, providing an elegant installation without any
cables hanging over the interior. The charging box has two USB ports: QC 3.0A + 2.4A. It is easy to slide the
device in place in the holder so it connects to the charging, and to take it out of the holder when leaving the
vehicle.
The holder is equipped with a tilt swivel so you can easily adjust the angle for better viewing. Tilts 17° and swivels
360°. Mounting plate 42x50 mm with 4 mm AMPS-holes. Made of high grade black ABS/Acetal plastic. Made in
Sweden. Connect the power cable with a 2A fuse. Professional installation recommended.
The adjustable holder fits for devices with Type C connector, with and without skin with the following dimensions:
Width: 70-83 mm, Thickness: 2-10 mm. Adjustable holders come in various sizes. Measure your device and
compare with the holder specifications in order to make sure you have chosen the correct product (if you are
using a skin: measure the device with the skin in place).
Before using the holder you need to set the holder's width so it suits your device, then your phone is held firmly in
place in an upright position for maximum cellular reception. The holder has a neat and discreet design which
blends well with the vehicle's interior. Attach onto ProClip Mounting Platform.
This product supports Qualcomm QC 3.0 quick charge (provided the device supports Qualcomm QC 3.0 quick
charge).
EAN: 7320287272031
NEW!

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. To adjust the holder for your device: Loosen the screws on the front side of the holder, so the sides of the
holders can be adjusted. Place the device in the holder and press the sides together so the device is firmly in
place. Remove the device carefully without moving the sides. Tighten the screws on the front side of the holder.
2. To install the holder: Loosen the screw in the center of the holder so you can remove the tilt swivel attaching
plate on the back.
3. Place the attaching plate into the desired position. Screw the attaching plate into place with the enclosed
screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw
so the holder is firmly in place, but still can be adjusted.
4. The holder is in place.