Brodit ProClip 853014 User manual

25 May, 2020, www.brodit.com, © 2020 Brodit AB
Product 853014
853014 ProClip
Center mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288530147
Item no 853014 fits:
BMW 7-series E65 02-08 (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Attention! Read all instructions before attaching the ProClip.
1. a) Press the thin ends of the two enclosed gap openers into the gap between the dashboard ledge and the air
vent frame to widen the gap. (The air vent frame may "pop up" a little. The distance between the gap openers has
to be wider than the width of the ProClip.) b) Peel off the cover of the adhesive tape on the ProClip. Press the thin
angled edge on the upper part of the ProClip into the gap between the gap openers - don't press it all the way in
so the adhesive tape attaches to the ledge yet.
2. a) Remove the left gap opener and slide the ProClip to the left to desired position. b) Pull the lower part of the
ProClip downwards so it hooks behind the wood grain panel. By doing this you seal the adhesive tape at the top
of the ProClip.
3. a) Press upwards on the lower part of the ProClip so the angled edge goes all the way in behind the wood
grain panel. b) Remove the right gap opener by the upper part of the ProClip and press down on the air vent
panel so it "pops" back into place.
4. The ProClip is in place