Bromic Heating Tungsten 2000W User manual

500mm
368mm
(14.5")
(20")
A
2 layers of minimum 16mm (5/8")
fireproof insulation must be installed
on all surfaces of ceiling box
Supporting structure
for fireproof insulation
Fireproof
insulation
Ceiling surface
1. Prepare ceiling cut out & ceiling box.
Ceiling box minimum internal dimensions must
be as showin table.
Heater must be installed with heater surface at
least 2400mm above the floor level.
2. From below, bring ceiling frame up and into
ceiling cut out.
3. Fasten ceiling frame to ceiling box through
mounng holes with fasteners (not supplied).
4. Prepare heater for installaon
Aach mounng brackets to both ends
of heater with supplied fasteners
CEILING RECESS KIT (SOLD SEPARATELY)
MODEL DIMENSION "A"
2000W & 4000W 1170mm (46")
3000W & 6000W 1463mm (57.5")
www.bromicheating.com

I
DETAIL I
SCALE 1 : 6
6. Assemble supplied terminal blocks,
wire, conduit & junction box cover.
7. Raise one side of heater up into the
ceiling box & then raise whole heater
into cavity.
8. Rotate the heater into horizontal
position in the ceiling box & then lower
down onto the ceiling frame.
9. Ensure all four side mounting
brackets are hooked over
the ceiling frame & centre the heater
inside the frame.
10. Make electrical connection from
heater to power supply.
Connection to be made outsideon the
side or top of the ceiling box.
www.bromicheating.com
BROMIC HEATING
Head Office: 1 Suttor Street, Silverwater, Sydney, NSW 2128 Australia
Telephone: [phone] (within Australia) or [phone] (from overseas) Fax: [phone]
Email: [email protected] Web: www.bromicheating.com
Note: Bromic Heating reserves the right to make changes to specifications, parts, components and equipment without prior notification.
This Installation, operation and service manual may not be reproduced in any form with prior written consent from Bromic Heating.
V1.0 Last Edited 07/01/2014