Brother DCP-1510 Installation guide

3.7.2018 Clean the Drum Unit. | Brother
http://support.brother.com/g/b/faqend.aspx?c=au&lang=en&prod=dcp1510_eu_as&faqid=faq00002256_019 1/4
DCP-1510
FAQs & Troubleshooting
Date: 08/04/2013 ID: faq00002256_019
Clean the Drum Unit.
Follow the steps below to clean the drum unit:
1. Open the scanner cover. The pull-arm (1) on the left side of the machine will lock. Open the top cover.
2. Slowly take out the drum unit and toner cartridge assembly.
3. Push down the lock lever (1) and take the toner cartridge out of the drum unit (2).
4. Turn the drum unit gear by hand while looking at the surface of the drum roller (1).

3.7.2018 Clean the Drum Unit. | Brother
http://support.brother.com/g/b/faqend.aspx?c=au&lang=en&prod=dcp1510_eu_as&faqid=faq00002256_019 2/4
5. Wipe the surface of the drum gently with a dry cotton swab until the dust of glue on the surface comes off.
6. Put the toner cartridge back into the drum unit until you hear it lock into place. If you put the cartridge in correctly, the lock lever on the drum unit
will lift automatically.
7. Put the drum unit and toner cartridge assembly back into the machine.
8. Close the top cover. After pulling the pull-arm (1) on the left side of the machine down, close the scanner cover using both hands.

3.7.2018 Clean the Drum Unit. | Brother
http://support.brother.com/g/b/faqend.aspx?c=au&lang=en&prod=dcp1510_eu_as&faqid=faq00002256_019 3/4
Related FAQs
Clean the scanner to improve the copy or fax quality.
If your question was not answered, have you checked other FAQs?
Go to the Top page in the FAQs & Troubleshooting section
See other FAQs in this category
Have you checked the manuals?
Go to the Manuals section
If you need further assistance, please contact Brother customer service:
Go to the Contact Us section
Related Models
DCP-1510, MFC-1810
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Very helpful
Helpful
Not helpful
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.