Brother HL-6050 User manual

8
Setting Up Your Printer
Do NOT connect the interface cable.
Connecting the interface cable is
done when installing the driver.
1Insert the CD-ROM into your CD-ROM
drive. The opening screen will appear
automatically.
Follow the on-screen instructions.
2Click Initial Setup on the menu screen.
3You can view the Initial Setup instructions
and follow the steps on pages 9 to 12.
Do NOT connect the interface cable.
Connecting the interface cable is
done when installing the driver.
1Insert the CD-ROM into your CD-ROM
drive. Double-click the Start Here OS X
icon.
Follow the on-screen instructions.
2Click Initial Setup on the menu screen.
3You can view the Initial Setup instructions
and follow the steps on pages 9 to 12.
1Insert the CD-ROM into the CD-ROM Drive
For Windows®Users
This is for Mac OS®X 10.1 / 10.2 Users.
If you are Mac OS®8.6 to 9.2 Users, go to
next page.
For Macintosh®Users
Step 1

9
Do NOT connect the interface cable.
You will be prompted to connect the
interface cable during the driver
installation.
1Open the front cover by pressing the front
cover release button.
2Unpack the drum unit assembly.
Rock it from side to side several times to
distribute the toner evenly inside the
assembly.
3Put the drum unit assembly into the printer.
4Close the front cover of the printer.
2Install the Drum Unit Assembly
Front cover
Front cover
release
button
Go to the next page
Setting Up
Your Printer
Windows®
USB
Windows®
Parallel
Windows®
Network
Macintosh®
USB
Macintosh®
Network
For
Administrators
Installing the Driver

10
Setting Up Your Printer
1Pull the paper tray completely out of the
printer.
2Whilepressingthepaperguidereleaselever,
slide the adjusters to fit the paper size.
Check that the guides are firmly in the slots.
3Fan the stack of paper well to avoid paper
jams and misfeeds.
4Put paper in the paper tray.
Check that the paper is flat in the tray and
below the maximum paper mark.
5Put the paper tray firmly back in the printer.
3Load Paper in the Paper Tray
For Legal size paper, press the universal
guide release button and pull out the back of
the paper tray.
Paper guide
release lever
Universal guide
release button
Up to here
Step 1

11
Do NOT connect the interface cable.
Connecting the interface cable is
done when installing the driver.
1Make sure that the printer’s power switch is
off.
Connect the AC power cord to the printer.
2Plug the AC power cord into an AC power
outlet/socket.
Turn the printer’s power switch on.
3After the printer has finished warming up,
the READY message appears.
4Press the Go button. The printer prints a
test page.
Check that the test page has printed
correctly.
4Print a Test Page
Go to the next page
Setting Up
Your Printer
Windows®
USB
Windows®
Parallel
Windows®
Network
Macintosh®
USB
Macintosh®
Network
For
Administrators
Installing the Driver

12
Setting Up Your Printer
1Press the +button untilSETUP is displayed.
Press the Set button.
2Press the Set button again.
3Press the +or –button to select your
language. Press the Set button to accept.
6Setting Your Language on the Control Panel
SETUP
LANGUAGE
=ENGLISH *
Go to the next page
to install the driver.
Step 1