Burley d'lite ST Guide

Using Your Stroller
1. Loop tether around handle bar center,
slide strap end through small loop
on other end of strap and tighten
securely. PHOTO 1
2. Engage parking brake.
3. Place stroller wheel in “Stroll” position
and secure by tightening knob. PHOTO 2
4. Slide tow bar into left tow bar mount
as far as it will go and then close
clamp firmly, making sure clamp latch is
engaged. PHOTO 3
Note: Retaining pin is not used for the
“Stroll” position.
5. Push trailer to test stroller wheel
tracking. If trailer does not roll straight,
adjust wheel tracking.
Note: See “Adjust Stroller Wheel Tracking”
instructions on back of page.
d’lite ST, Solo ST Stroller Kit
Installation Instructions
Using Your Stroller
1. Loop tether around handle bar center,
slide strap end through small loop
on other end of strap and tighten
securely. PHOTO 1
2. Engage parking brake.
3. Place stroller wheel in “Stroll” position
and secure by tightening knob. PHOTO 2
4. Slide tow bar into left tow bar mount
as far as it will go and then close
clamp firmly, making sure clamp latch is
engaged. PHOTO 3
Note: Retaining pin is not used for the
“Stroll” position.
5. Push trailer to test stroller wheel
tracking. If trailer does not roll straight,
adjust wheel tracking.
Note: See “Adjust Stroller Wheel Tracking”
instructions on back of page.
d’lite ST, Solo ST Stroller Kit
Installation Instructions
Tow Bar
Clamp
PHOTO 1
PHOTO 3: Tow bar in “Stroll” position
Tow Bar
Mount
Tow Bar
PHOTO 2: Stroller wheel in “Stroll” position
Knob
Tow Bar
Clamp
PHOTO 1
PHOTO 3: Tow bar in “Stroll” position
Tow Bar
Mount
Tow Bar
PHOTO 2: Stroller wheel in “Stroll” position
Knob

B U R L E Y D E S I G N
Copyright © 2008 by Burley Design LLC. “Burley” is a registered trademark of Burley Design LLC :Rev 08/08 :170151 ST Stroller Kit Installation Instructions r0
4020 Stewart Rd. Eugene, OR 97402 :PH 541.687.1644 800.423.8445 FAX [phone] :
[e-mail] :www.burley.com
Adjusting Stroller
Wheel Tracking
Note: For best results, adjust with trailer
fully loaded.
Tool Required: 5mm hex wrench (provided)
25mm (1”) wrench
1. With stroller wheel secured in “Stroll”
position, loosen bolt using 5mm
hex wrench. FIGURE 1
2. Using a 25mm wrench, turn bushing so
that stroller wheel is vertical when viewed
from front.
3. Fine tune as necessary so that trailer rolls
straight.
4. Tighten bolt.
Adjusting Stroller
Wheel Tracking
Note: For best results, adjust with trailer
fully loaded.
Tool Required: 5mm hex wrench (provided)
25mm (1”) wrench
1. With stroller wheel secured in “Stroll”
position, loosen bolt using 5mm
hex wrench. FIGURE 1
2. Using a 25mm wrench, turn bushing so
that stroller wheel is vertical when viewed
from front.
3. Fine tune as necessary so that trailer rolls
straight.
4. Tighten bolt.
B U R L E Y D E S I G N
Copyright © 2008 by Burley Design LLC. “Burley” is a registered trademark of Burley Design LLC :Rev 08/08 :170151 ST Stroller Kit Installation Instructions r0
4020 Stewart Rd. Eugene, OR 97402 :PH 541.687.1644 800.423.8445 FAX [phone] :
[e-mail] :www.burley.com
THIS PRODUCT WAS DESIGNED FOR USE ON
SURFACES THAT ARE MEANT FOR WALKING. DO
NOT USE IT ON STAIRS, ESCALATORS OR OTHER
UNEVEN SURFACES. NEVER USE IT WITH
INLINE OR ROLLER SKATES. FAILURE TO
FOLLOW THESE INSTRUCTIONS AND THOSE IN
YOUR BURLEY TRAILER MANUAL CAN CAUSE
AN ACCIDENT RESULTING IN SERIOUS INJURY.
WARNING
WHEN CONVERTING THIS ATTACHMENT FROM
STROLLING TO BIKING, MAKE SURE THAT
STROLLER WHEEL IS IN PROPER POSITION
BEFORE ATTACHING TRAILER TO YOUR
BICYCLE.
WARNING
FIGURE 1: To adjust stroller wheel tracking
Bushing
Bolt
THIS PRODUCT WAS DESIGNED FOR USE ON
SURFACES THAT ARE MEANT FOR WALKING. DO
NOT USE IT ON STAIRS, ESCALATORS OR OTHER
UNEVEN SURFACES. NEVER USE IT WITH
INLINE OR ROLLER SKATES. FAILURE TO
FOLLOW THESE INSTRUCTIONS AND THOSE IN
YOUR BURLEY TRAILER MANUAL CAN CAUSE
AN ACCIDENT RESULTING IN SERIOUS INJURY.
WARNING
WHEN CONVERTING THIS ATTACHMENT FROM
STROLLING TO BIKING, MAKE SURE THAT
STROLLER WHEEL IS IN PROPER POSITION
BEFORE ATTACHING TRAILER TO YOUR
BICYCLE.
WARNING
FIGURE 1: To adjust stroller wheel tracking
Bushing
Bolt