Buyers 8891100 Operation and maintenance manual

www.buyersproducts.com
Phone [phone]
Fax [phone]
Installation Instructions
889110 0 LED Mini Light Bar
WARNING
It is not recommended to use magnetically mounted warning
devices on the exterior of vehicles in motion. Usage is at the
sole risk and responsibility of the user.
Flash Patterns
Momentarily push the Flash Pattern button:
• Once for next pattern
• Quickly 3 times for reset to FP#0
Note: This unit is not factory set to FP#0
Vacuum Magnet Mount
(Standard)
WARNING
Do not look directly into LEDs while in operation; this may
cause momentary blindness and/or eye damage.
FP# Flash Patterns
0 Kit Scan (split)
1Outside-In Single
2Outside-In Ultra
3Side-by-Side Single
4Side-by-Side Ultra
5Random
6 Single (split)
7Double (split)
8 Quad (split)
9Quint (split)
10 Mega (split)
11 Ultra (split)
12 Single-Quad (split)
FP# Flash Patterns
13 Single H/L (split)
14 Single (all)
15 Double (all)
16 Quad (all)
17 Quint (all)
18 Mega (all)
19 Ultra (all)
20 Single-Quad (all)
21 Single H/L (all)
22 Single Cross
23 Ultra Cross
24 Rotator 1
25 Rotator 2
flash pattern
selector
on/off

www.buyersproducts.com
Phone [phone]
Fax [phone]
WARRANTY
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions. Any
product which has been altered, including modification, misuse,
accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of
Buyers Products Co. under this warranty is limited to repairing or
replacing any part or parts which are returned, prepaid, and are
found to be defective by Buyers Products Co. Authorization from
Buyers Products Co. must be obtained before returning any part.
No charges for transportation or labor performed on Buyers’ prod-
ucts will be allowed under this warranty.
8891100INST_C
8891010 Optional Permanent Mount
WARNING
Do not look directly into LEDs while in operation; this may
cause momentary blindness and/or eye damage.
8891010 Mounts shown on 8891100 Light Bar
RED: To +VDC (fuse @ 10A)
BLACK: To Chassis Ground (-)
WHITE: For Simultaneous or Alternating Flash
-Group 1 Units: (Wiring - WHITE connected to RED) will flash
together
- Group 2 Units: (Wiring - WHITE not connected to RED) will
flash together
*Group 1 Units will alternate with Group 2 Units
YELLOW: Flash Patterns & Synchronization
-Connect YELLOW wires of all head together for synchronization
*All heads must be set to the same pattern
Wiring Code