7
11 2 Door settings
Relay output delay time
To set door relay strike time
* Master code # 4 0 – 99 # *
0 – 99 is to set the door relay time to 0 – 99 seconds
Door open detection
Door open too lon (DOTL) warnin . When used with an optional ma netic contact or a ma netic lock with a built-in contact,
if the door is opened normally, but not closed after one minute, the inside buzzer will beep automatically to remind people to
close the door and continue for one minute before switchin off automatically.
Door forced open warnin . When used with an optional ma netic contact or a ma netic lock with a built-in contact, if the
door is forced open, or if the door is opened after 20 seconds, the inside buzzer and alarm output will both operate. The
alarm output time is adjustable between 0 – 3 minutes, with the default bein 1 minute.
To disable door open detection (factory
default)
6 0 #
To enable door open detection
6 1 #
To chan e a PIN in card and PIN mode
(method 1)
Chan e usin card. Note that this is done
outside of pro rammin mode so the user can
undertake this themselves.
* Read card Old PIN # New PIN # New PIN #
To chan e a PIN in card and PIN mode
(method 2)
Chan e usin User ID number. Note that this is
done outside of pro rammin mode so the user
can undertake this themselves.
* ID number # Old PIN # New PIN # New PIN #
To delete card and PIN user
To delete the user just delete the card
2 User ID number #
To add a card user in card mode ( 3 0 # ) mode
To add or delete a card user
The operatin is the same as addin and deletin a card user in
3 0 #
