C.R. Plastic Products C30 St. Tropez Lounge Chair User manual

C30 St. Tropez Lounge Chair
C.R. Plastic Products Inc.
1 –533 Romeo Street South
Stratford Ontario N5A 4V3
Toll Free: 800-490-1283
Fax: [phone]
www.crpproducts.com

A. Seat Qty: 1
B. Left Arm Qty: 1
C. Right Arm Qty: 1
PARTS LIST:
A - Seat
B - Left Arm
C - Right Arm
D - Back
HARDWARE LIST:
20 –1½”Screws
4 –2” Screws
Note:
Read these instructions carefully before assembling.
Tools required: # 2 Phillips or #2 Robertson bit and power drill.
Find a clean, smooth area on which to work, such as a carpet, in order to avoid scratching the plastic
surfaces.
Two people might be required for assembly.
D. Back Qty: 1

Step 1: Set the Left Arm (B) flat on the floor Fig. 1. Line up seat (A) keeping bottom edge of seat flush with
bottom edge of center rail of arm. Keep front edge of seat back 1/8” from front of leg, (detail X) and
attach with 6 - 1½” screws.
Figure 1
Step 2: Using right arm (C) to balance back Fig. 2. Line up back, (detail Y and Z). Insert 2 - 2” screws to
attach the back to the curved arm rest keeping screw holes centered on arm.
Step 3: Insert 4 - 1½” screws (detail Y).
Figure 2
Required
Qty
Seat (A)
1
Left Arm (B)
1
1½” Screws
6
Required
Qty
Back (D)
1
Right Arm (C)
1
1½” Screws
4
2” Screws
2
Keep bottom edge of seat
flush with center rail of
arm.
Use 2” Screws
keeping screw
holes centered
on arm.
Use 1½” Screws
Use 1½” Screws
only in this step.
1/8”
Keep front edge of seat
back 1/8” from the
front of leg.
X
Z
Y
Keep tight to seat.

Step 4: Flip assembled part of chair over on to Arm (C), keeping bottom edge of seat flush with bottom edge
of center rail of arm. Keep front edge of seat back 1/8” from front of leg, (detail U) and attach with
5 - 1½” screws.
Step 5: Line up back, (detail V and W). Insert 2 - 2” screws to attach the back to the curved arm rest,
(detail W) keeping screw holes centered on arm.
Step 6: Insert 4 - 1½” screws. (detail V)
Figure 3
Required
Qty
Right Arm (C)
1
1½” Screws
10
2” Screws
2
Keep front edge of seat
back 1/8” from the
front of leg.
Use 1½” Screws
Use 2” Screws
keeping screw
holes centered
on arm.
1/8”
U
V
W
Keep flush
Keep tight