C.R. Plastic Products St. Tropez L38 User manual

By: C.R. Plastic Products Inc.
L38 St. Tropez Chaise Lounge
C.R. Plastic Products Inc.
1-533 Romeo Street South
Stratford Ontario, N5A 4V3
Toll Free: 800-490-1283
Fax: [phone]
www.crpproducts.com
Rev: 2015-05-12

B. Right Arm, Qty:1
A. Left Arm, Qty:1
E. Back, Qty:1
G. Seat, Qty:1
D. Front Stringer, Qty:1
H. Seat, Qty:1
C. Rear Stringer, Qty:1
PARTS LIST:
A Left Leg
B Right Leg
C Rear Stringer
E Back
F Back Support
G Seat
H Front Legs
HARDWARE LIST:
12 Screws 1-1/2
8 Bolts
8 Nylock Nuts
2 Screws 2 1/2"
Note:
Read these instructions carefully before assembling.
Tools required: #2 Phillips or #2 Robertson bit, a power drill and two 7/16" wrenches
Find a clean, smooth area on which to work, such as a carpet, in order to avoid
scratching the plastic surfaces.
Two people might be required for assembly.
Caution! Do not over tighten screws
F. Back Support, Qty:1

A
Step 1
2 1/2" Screw
DETAIL A
Step 2
2 1/2" Screw
B
Step 3
DETAIL B
1 1/2" Screws
Step 1: Set the Left arm (A) on its side as shown and attached Rear Stringer (C)
with one 2 1/2" screw. (Detail A)
Step 2: Stand assy on end and secure Right Arm (B) with one 2 1/2" screw.
Step 3: Set assy. down flat and attach Front Stringer (D) with six 1-1/2" screws. (Detail B)
Requied Qty
Left Arm Assy. (A) 1
Rear Stringer (C) 1
Front Stringer (D) 1
1-1/2" Screws 6
2 1/2" Screws 2

C
Step 4
DETAIL C
Step 5
D
Step 6
Use 1-1/2" Screws and
align with back of 3rd slat.
DETAIL D
E
Step 7
DETAIL E
Step 4: Attach Back Support (F) to back (E) using two 2" bolts and nylock nuts. (Detail C)
Step 5: Attach back to leg assy. using two 2" bolts and nylock nuts.
Step 6: Attach Front leg assy. (H) to Seat (G) using six 1 1/2" screws. (Detail D)
Step 7: Attach Seat to complete leg and back assy. using four 2" bolts and nylock nuts.
(Detail E)
Required Qty
Back Assy. (E) 1
Back Support (F) 1
Seat (G) 1
Front Legs (H) 1
1-1/2" Screws 6
2" Bolt 8
Nylock Nut 8