C.R. Plastic Products St. Tropez C34 User manual

C34 St. Tropez Dining Arm Chair
C.R. Plastic Products Inc.
1 –533 Romeo Street South
Stratford Ontario N5A 4V3
Toll Free: 800-490-1283
Fax: [phone]
www.crpproducts.com

A. Seat Qty: 1
B. Back Qty: 1
C. Left Leg Qty: 1
D. Right Leg Qty: 1
E. Stringer Qty: 2
PARTS LIST:
A - Seat
B - Back
C - Left Leg
D - Right Leg
E - Stringer
HARDWARE LIST:
18 –1½”Screws
4 –2½” Screws
Note:
Read these instructions carefully before assembling.
Tools required: # 2 Phillips or #2 Robertson bit and power drill.
Find a clean, smooth area on which to work, such as a carpet, in order to avoid scratching the plastic surfaces.
Two people might be required for assembly.
Caution!! Do not over tighten screws.

Step 1: Attach seat (A) to Back (B) on one side using 2 - 2½” screws.
Step 2: Flip chair over and insert 2 more 2½” screws on other side.
Figure 1
Step 3: Attach Left Leg (C) to back leg using 1 - 1½” screw
Step 4: Attach front of leg (C) to seat using 1 - 1½” screw.
Step 5: Install the remaining 3 - 1½” screws.
Step 6: Flip chair over and repeat for Right Leg (D).
Figure 2
Required
Qty
Seat (A)
1
Back (B)
1
2½” Screws
4
Required
Qty
Left Leg (C)
1
Right Leg (D)
1
1½” Screws
10
Step 1
Use 2½” Screws
Step 3
Place curved leg in center of back
leg, flush bottom and install this
screw first.
Use Stringer (E) to
keep chair level.
Step 2
Use 2½” Screws
Use Stringer (E) to
keep chair level.
Step 4
Use scribe line on leg for alignment and
install this screw second.

Step 7: Insert one of the Stringers (E) and install with 2 - 1½” screws.
Step 8: Repeat for second stringer (E).
Step 9: Flip the chair over and install 4 - 1½ screws.
Figure 3
Required
Qty
Stringer (E)
2
1½” Screws
8
Step 7
Use 1½” screws
Step 8
Use 1½” Screws