Caberg A9235 PRO SPEAK EVO User manual

1.
2.
3.
4.
Remove both cheek pads and place the
cables under the rear cushion.
Place the right speaker (R) behind the
cheek pad at the holes using the velcro
on the back of the speaker.
Repeat the operations for the right
speaker (R) to position the left (L).
Snap in the cheek pad’s buttons on both
sides paying attention to not ‘’pinch’’ the
cables’’.
ASSEMBLY
A9235 PRO SPEAK EVO
FOR RIVIERA V4 X

5.
6.
7.
8.
Attach the microphone on the comfort
padding with the Velcro on the back of
the microphone base.
Adjust the microphone’s position by
deforming its boom.
WARNING check that the triangle on the
microphone is facing the mouth.
Place the BT controller in the designated
slot on the back of the inner shell.
Place the USB socket between the
removable cheek pads and the comfort
padding.
ASSEMBLY
A9235 PRO SPEAK EVO
FOR RIVIERA V4 X

9.
Fit the keypad on the left side (helmet
on), approximately 10 mm from the lower
edge of the shell using the provided
adhesive. Make sure that there is no
interference with the chin guard and full
contact surface between the adhesive
keypad and the outer shell.
ASSEMBLY
A9235 PRO SPEAK EVO
FOR RIVIERA V4 X