Caberg PRO SPEAK EVO User manual

1.
2.
3.
4.
ASSEMBLY
Remove the cheekpads as indicated in the
communicator’s instruction manual.
Place the right speaker (R) in its seat
after applying the adhesive round shaped
Velcro included in the package.
Repeat the operations performed for the
right (R) speaker for positioning the left
(L).
Position the microphone by passing the
boom under the chinstrap that will be
housed in its seat.

5.
6.
7.
8.
ASSEMBLY
Adjust the microphone’s position by
deforming its boom.
WARNING check that the triangle on the
microphone is facing th mouth.
Remove the inner liner. Place the cables
in the gap between the inner and outer
shell.
Place the BT controller in the designated
slot on the back of the inner shell.
Assemble the cheekpads. Place the USB
socket between the cheekpad and the
neckroll.

9.
10.
ASSEMBLY
Pass the flat cable of the remote control
between the neckroll’s pp plate and the
shell. The remote control must remain
accessible outside the helmet.
Fit the keypad on the left side (helmet
on), approximately 15 mm from the lower
edge of the shell using the provided
adhesive. Make sure that there is no
interference with the chin guard and full
contact surface between the adhesive
keypad and the outer shell.