Callaway Micro Pro User manual

A. Eye Piece
B. Diopter Adjustment
C. Power Button
D. Mode Button
E. Slope Button
F. Charging Port
LCD DISPLAY
A. Zero-In Aiming Square
B. Laser Indicator
C. P.A.T. Mode Indicator
D. Pulse Indicator
E. Distance
F. Unit of Measure
G. Angle of Incline/Decline
H. Slope Adjusted Distance
RANGEFINDER DIAGRAM
CALLAWAY MICRO PRO
LASER RANGEFINDER MANUAL
H
4. Unit of Measure - To change the unit of measure from Yards
to Meters, start with the device powered o󰀨. Then HOLD the
Mode Button for 3 sec. The unit of measure is indicated by a
“Y” or “M” shown directly to the right of the distance displayed.
SLOPE FUNCTION
To turn Slope on/o󰀨, press the “S” button on the top of the unit
1. If GREEN is ashing: Slope function is o󰀨. The Laser is
tournament legal when the slope is turned o󰀨.
2. If RED is ashing: Slope function is enabled. Slope adjusted
yardage will be displayed after every time the laser is red.
The Laser is not tournament legal when the slope is enabled.
SLOPE ON SLOPE OFF
CHARGING
FOR MORE SUPPORT VISIT:
www.CallawayDMD.com/product-support
Caution: Use of controls or adjustments or performance of
procedures other than those specied herein may result in
hazardous radiation exposure.
1. Insert the USB-C charger end into the Micro Pro & then insert
the USB end of the charging cord into a USB charging port or
AC adapter (not included). The recommended USB charging
rate is 5V, 1A.
2. A complete full charge will take about 6 hours. the indicator
light will turn green when charging is completed.
3. A full charge should last 100+ rounds of golf
Front indicator
lights:

2.P.A.T. with Pulse Technology - P.A.T. Mode is best used
when measuring the distance to a Flagstick or smaller objects.
Device will provide a short vibration to conrm that the laser
has locked on to the pin. To toggle between Standard and
P.A.T Mode, quickly PRESS the Mode Button once while
device is powered on. When P.A.T. Mode is activated, the
agstick icon will appear on the right side and the Pulse icon
will appear on the left of the LCD display (Fig. B).
MEASUREMENT MODES
1. Standard - Standard Mode is recommended when
measuring distances to larger objects. (Fig. A)
3. Scanning - To measure distances to multiple targets in
succession, PRESS and RELEASE Power Button to power
on. Then HOLD Power Button, the Laser Indicator will ash
and the laser will continuously re. Measurements will change
as you scan the landscape and change targets. This mode will
continuously re the laser for 3 seconds & the laser will lock on
to the closest distance during the ring period.
HOW TO USE
While looking through the
Eye Piece, PRESS &
RELEASE the Power
Button.The rangender
is now powered on.
1.
To focus/increase
clarity, use the Diopter
Adjustment by turning
the Eye Piece.
2.
Continue looking through
the Eye Piece, aim the
Zero-In Aiming Square at
your intended target &
PRESS the Power Button.
The laser will re and the
Laser Indicator will appear
to the left of the Zero-In Aiming
Square.The measurement will be
displayed at the top of the LCD display.
3.
NOTE: While scanning in P.A.T. Mode, the measurement will only
change when a shorter distance is measured. This is useful when
measuring the distance to a agstick when there are trees or other
objects in the background.