Page 3- Manual FA01799 -EN - 04/2022 - © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
GENERAL PRECAUTIONS FOR INSTALLERS
⚠WARNING! Important safety instructions.
Please follow all of these instructions. Improper installation may cause
serious bodily harm.
Before continuing, please also read the general precautions for users.
This product must only be used for the purpose for which it was designed. Any other
use is hazardous. • The manufacturer cannot be held liable for any damage caused by
improper, unreasonable or erroneous use. • This product is defined by the Machinery
Directive 2006/42/EC as “partly completed machinery”. • “Partly completed machinery”
means an assembly which is almost machinery but which cannot in itself perform a
specific application. • Partly completed machinery is only intended to be incorporated into
or assembled with other machinery or other partly completed machinery or equipment
thereby forming machinery to which the Directive 2006/42/EC applies. • The final
installation must comply with the European Directive 2006/42/EC and current European
reference standards. • The manufacturer declines any liability for using non-original
products, which would also void the warranty. • All operations indicated in this manual
must be carried out exclusively by skilled and qualified personnel and in full compliance
with the regulations in force. • The device must be installed, wired, connected and
tested according to good professional practice, in compliance with the standards
and laws in force. • Make sure the mains power supply is disconnected during all
installation procedures. • Check that the temperature ranges given are suitable for
the installation site. • Do not install the operator on surfaces that could yield and
bend. If necessary, add suitable reinforcements to the anchoring points. • Make sure
you have set up a suitable dual-pole cut-off device along the power supply that is
compliant with the installation rules. It should completely cut off the power supply
according to category III surcharge conditions. • Demarcate the entire site properly to
prevent unauthorised personnel from entering, especially minors. • In case of manual
handling, have one person for every 20 kg that needs hoisting; for non-manual
handling, use proper hoisting equipment in safe conditions. • Use suitable protection
to prevent any mechanical hazards due to persons loitering within the operating range
of the operator. • The electrical cables must pass through special pipes, ducts and
cable glands in order to guarantee adequate protection against mechanical damage.
• The electrical cables must not touch any parts that may overheat during use (such
as the motor and transformer). • Before installation, check that the guided part is
in good mechanical condition, and that it opens and closes correctly. • Remove all
cords and chains and disable any equipment not required for automating the guided
part such as locks. • The product cannot be used to automate any guided part that
Page 3- Manual FA01799 -EN - 04/2022 - © Came S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructions
