Cane Creek DROPT Service manual

DROPT Installation Instructions Product Anatomy: Included in the package
Tools Needed
• 1.5mm Hex Key
• 2.5mm Hex Key
• 3mm Hex Key
• Cable Cutter
Required for Installation
Shifter cable, Shifter housing.
These items are not included in the
packaging, but are required for
installation.
Bar Mount Installation Options:
Using handle bar mount, fasten 2.5mm hex key 1.1 Nm
onto handlebar at desired position.
Using only the lever assembly, fasten 3mm lever
fastener bolt 3.0 Nm to AVID® Matchmaker™ location.
AVID® MatchMaker™
Compatible.
Lever Fastener
Bolt 3mm
Hex Key
Handle Bar Clamp
Handle Bar
Fastener Bolt
2.5 mm Hex Key
Lever Positioning
Bolt 3mm Hex Key
Cable Tension
Adjuster
Cable Fastening
Bolt 1.5mm Hex Key Travel Limit
Bolt 1.5mm Hex Key
Hinge Removal
Bolt 1.5mm Hex Key
1.
Handle Bar
Fastener Bolt
2.5 mm Hex Key
1.1 Nm
2.
Lever Adjustment Options:
Lever Clamp location Lever Positioning
Clamp
location
option 1.
Clamp
location
option 2.
1. 2.
Lever Positioning
Bolt 3mm Hex Key
Loosen to adjust.
Fasten to 3.2 Nm.
DROPT Installation Instructions
AAE0079
BE SURE TO FOLLOW ALL MANUFACTURER’S GUIDELINES FOR
SERVICING AND INSTALLING THE COMPONENTS OF YOUR
BICYCLE. IMPROPERLY INSTALLED COMPONENTS CAN RESULT IN
SERIOUS AND/OR FATAL INJURY. WE ALWAYS RECOMMEND YOU
HAVE YOUR COMPONENTS SERVICED AND INSTALLED BY A
QUALIFIED BICYCLE MECHANIC.
WARNING
!
!

Pair OPT with DROPT:
Handle Bar
Fastener Bolt
2.5mm Hex Key
1.1 Nm
OPT and DROPT Handle Bar Final Assembly:
Hinge Removal
Bolt 1.5mm Hex Key
Hinge Removal
Bolt 1.5mm Hex Key
Drop Standard
Handle Bar Hinge
Remove 1.5mm hinge bolt on both OPT and
DROPT handle bar assemblies.
Using one of the 1.5 hinge bolts, reinstall OPT
Climb Switch Remote onto the lower portion
of the DROPT bar mount.
Fasten 2.5mm hex handle bar fastener bolt
onto handlebar 1.1 Nm.
Cable Orientation Options:
Using butted end of cable at dropper post,
route cable to lever. Adjust cable length to
required length. Fasten 1.5mm hex key on cable
fastener bolt .3 Nm. Cut excess cable after
cable is fastened.
Butted end
of cable to
dropper.
Cable Tension
Adjuster
Cable Fastener
Bolt 1.5mm Hex Key .3 Nm
Insert cable in cable port and
tighten down bolt to secure
cable.
Using butted end of cable at DROPT Remote, feed
cable through lever until butted end is housed in
lever. Adjust cable length to required length.
DROPT Installation Instructions Page 2
Butted Cable
Insertion Port
Cable Tension
Adjuster
1.
2.
3.
1.
2.
Translations of this document are located at
www.canecreek.com/tech-center
1. 2.
3.