Canon PIXMA MX410 Series Manual

<< Previous Next >>
Using Your Multifunction with
Additional computers on Your Network
PIXMA MX410
Windows OS
1

<< Previous Next >>
Using Your Multifunction with
Additional computers on Your Network
PIXMA MX410
Windows OS
Preparing to Connect My Multifunction to My Network 3
Network Requirements 3
Important Information You Need Before Adding Your Multifunction 4
Installing the Drivers & Application Software 5
Downloading & Installing the Drivers 11
Download the Driver 11
Installing the Driver
Downloading & Installing Application Software 18
2

Network Requirements
Before connecting the machine to the network, make sure that configuration of the computer and access point or router is
complete, and that the computer is connected to the network.
Notes on Network Connection
•The configuration, router functions, setup procedures and security settings of the network device vary depending on your
system environment. For details, refer to your device's instruction manual or contact its manufacturer.
•The machine cannot be used over a wireless and wired connection at the same time.
Wireless Connection
Connect to your network environment over a wireless connection.
Preparing to Connect My Multifunction
To My Network << Previous Next >>
3

Preparing to Connect My Multifunction
To My Network << Previous Next >>
Be sure to prepare an access point.
Important Information You Need Before Adding Your Multifunction
The following information is required to connect to your access point or router.
•Access Point Name/Network Name:
Also referred to as SSID. A name to identify the specific access point.
•Network Key:
Also referred to as encryption key, WEP key or WPA/WPA2 passphrase, Pre-Shared key.
A password required to set to prevent unauthorized access to communication.
Check your access point or router for the following information, and then write it down.
NOTE: For details on how to check the following information, refer to the manual of your access point or router, or contact its manufacturer.
An "Ad-hoc connection," which establishes a direct
connection to the computer over a wireless connection
without using an access point, is not supported.
4

Installing the Drivers and Software
Installing the Driver
To use the machine by connecting it to a computer, software including the drivers needs to be copied (installed) to the computer's hard disk. The
installation process takes about 20 minutes. (The installation time varies depending on the computer environment or the number of applications
to be installed.) . We recommend using the Setup CD-ROM for installation. If you do not have the CD-ROM or want to use drivers downloaded
from our web site , Click here for instructions.
<< Previous Next >>
5
Step One
Insert the Setup CD-ROM into your computer’s CD-
ROM drive
Step Two
On the opening screen select Easy Install

Step Three
On the next screen click Install
Step Four
Select Use the printer with wireless LAN connection, then click Next.
6
Installing the Drivers and Software <<Previous Next>>

Step Five
Click Yes for the License Agreement
Step Six
Click Yes or No for the License Agreement Adobe RGB
7
Installing the Drivers and Software <<Previous Next>>

Step Seven
Click Next if the Please Allow All Install Wizard Processes appears
Step Eight
Click Next on the Printer Detection screen
8
Installing the Drivers and Software <<Previous Next>>

Step Nine
Turn on the printer and click OK
Step Ten
When the Detected Printers List appears, select Canon MX410 series
Then click Next.
9
Installing the Drivers and Software <<Previous Next>>

Step Eleven
Click Complete or OK on the Setup Completion screen. Your device and software have now been set up. Please follow any remaining
On-screen instructions to finish and exit.
10
Installing the Drivers and Software <<Previous