Canon Lunar Globe User manual

* This model was designed for Papercraft and may differ from the original in some respects.
* Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
Assembly Instructions : Three A4 sheets (No. 1 to No. 3)
name
After cutting out the hole,
glue the reinforcement to
the reverse side, taking
care to ensure it doesn't
obstruct the fold lines.
Attach the red cir-
cles into place at
these positions.
Front side of the Moon
Back side of the Moon
Cut out the upper half base. Use scissors to
cut out the center hole. Cut out the center by
first cutting with scissors along the red line
connecting the center to the exterior.
Cut out the front side of
the Moon (upper half)
and the back side of
the Moon (upper half)
and glue them together
using the central tabs.
Glue the back side of the Moon (upper half) to
the upper half base by attaching the red circles
on the back side of the Moon (upper half) into
place on the glue tabs near the joints of the
upper half base, as shown in the illustration.
Assembling the main body of the lunar globe
1. 2. 3.
Lunar Globe : Assembly Instructions
1

Glue the parts of the upper half together so that its
shape is semispherical. To fit the parts together
correctly, gently fold the tabs inward, then align the
surface features (e.g., craters) while holding the upper
half base down with your finger and gently pulling on
the tabs. Assemble the lower half in the same way.
4.
Glue the upper half base lid to the
upper half base and the lower half
base lid to the lower half base to cover
their holes.
6. Glue the upper half and the lower half
together at the joint.
7.
Fold the lid of the lower half base in half and cut out
a slot so that Moon story plates can be inserted.
Flatten out the lid.
5.
Reinforce the thin tabs near
the top, using a brush or
other implement to apply
glue from the reverse side.
Lunar Globe : Assembly Instructions
2

Stand 3
After folding stands 1, 2, and 3 according to
the directions, arrange the three hexagons on
the three parts so that they are positioned
face to face. Glue them together so that the
colored parts facing each other face upward.
Stand 1
Stand 2
1.
Align and glue the rear surfaces of the Moon
story plates together.
2.
Insert the Moon story plates into the slot on
the lower half.
3.
Assembling the stand
Finished!
Lunar Globe : Assembly Instructions
3