Canon Creative Park Easter Bunny Egg Holder User manual

Easter : Bunny Egg Holder : Assembly Instructions ©
Canon Inc. © Taka Taka
Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
View of completed model
Assembly Instructions : Three A4 sheets (No. 1 to No. 3)
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
* Build the model by carefully reading the Assembly Instructions , in the parts sheet page order.
Before starting assembly :
Writing the number of each section on its back side before
cutting out the sections is highly recommended.
(* This way, you can be sure which section is which even
after cutting out the sections.)
Indicates where sections should
be glued together.
We recommend using Matte Photo Paper and wood glue.
Assembling the Easter Bunny
Glue the inside
surfaces of parts
1-4 and 1-5.
Glue here

Easter : Bunny Egg Holder : Assembly Instructions ©
Canon Inc. © Taka Taka
Assembling the ribbon Assembling the lid
Wrap this part around a round
pencil or other such cylinder to make
it assume a curve.
Glue the rear sides of the dots first.
Glue the ribbon to the Easter Bunny.
Assemble three units of part 3-1.
Glue the rear side of part 3-3.
Glue the bottom surface first.
Glue part 3-4 into place after inserting
parts 3-1 into part 3-2.
The lid is complete!
Assembling the egg holders (three in all)
The egg holders differ in color only.
Each is assembled in the same way.
Apply a curve to this
piece in the same way
as with the ribbon, then
glue its ends together.
Glue each glue tab to
the interior of the stand,
one tab at a time.
The egg stand
is complete!
Assembling the chicks (three in all)
Although the shapes and illustrations of
each chick differ slightly,
each one is assembled in the same way.

Easter : Bunny Egg Holder : Assembly Instructions ©
Canon Inc. © Taka Taka
Assembling the Easter eggs (six pieces in all : three lids and three bases) Arrange the Easter Bunny box, the egg holders, the Easter eggs, and the chicks in
the way you find most pleasing. You can also use this model to hold real Easter eggs.
Although parts 6-1 and 6-2 differ in size and pattern, the assembly method is the same.
Glue each spot firmly, one spot at a time.
Glue each tab to the interior
of the egg, one tab at a time,
as shown in the illustration.
The Easter egg is complete!