CDA ECA SERIES Quick start guide

EU Declarations of Conformity:
This appliance has been designed, constructed and marketed in
compliance with safety requirements of EU Directive 2014/35/EU
(Low voltage) and requirements of EU Directive 2014/30/EU (EMC).
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19/EU.

4
•Steam cleaners must not be used when cleaning this appliance.
•The performance of your extractor will vary depending on anumber
of factors. These include: type of extraction, lengthof ducting, room
volume, ventilation available and cleanliness of the filters.
Note:
For best performance, you should switch on the extractor 15 minutes
before starting tocook and leave it torun for approximately 15
minutes after the end of cooking.

5
Using Your Extractor (ECA Range)
Control Panel
A- Light button
B - Speed level buttons
C- Power o button
To switch the extractor light on or o:
•Press button “A”.
To switch on the extractor or to change the speed at any time when
the extractor is running:
• Press the relevant “B” button for the first,second or third speed level
as required.
To switch the extractor o:
•Press button “C”.
Fig. 1A B C

7
Care and Maintenance
IMPORTANT : DO NOT PERFORM
MAINTENANCE OR CLEANING OF
THE EXTRACTOR WITHOUT FIRST
SWITCHING OFF THE ELECTRICITY
SUPPLY.
Cleaning
You should use anonabrasive cleaner.
Any abrasive cleaner (including Cif) will
scratch the surface and could erase the
control panel markings.
You can clean your extractor eectively
by simply using adilutesolution of
water and mild detergent and drying to
ashine withaclean cloth, for example
the CDA E-Cloth.
Cleaning the grease filter
The grease filter should be kept clean
tominimise the risk of fire.
At least once amonthyou should
remove the grease filter and clean
it withhot soapy water. You can also wash the grease filter in a
dishwasher, ensuring that you place it in an upright position toprevent
damage from other items in the dishwasher.
Fig. 4
Fig. 5
Fig. 3

In re-circulating mode, air is vented
back into the kitchen through the
opening in the cooker hood.
This method is advised if you are
not using your hob intensively.
Re-circulated air requires the use
of charcoal filters to remove odours.

2W

10
Mains Electricity Connection
THIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY
BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE
POLE SWITCHED FUSED SPUR OUTLET AND PROTECTED BY A
3A FUSE.
We recommend that the appliance is
connected by aqualified electrician,
who is amember of the N.I.C.E.I.C. and
who will comply withthe I.E.T. and local
regulations.
The wires in the mains lead of this
appliance are coloured in accordance
withthe following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
As the colours of the wires in the mains lead for the appliance may
not correspond withthe coloured markings identifying the terminals
connecting tothe fused spur, proceed as follows:
•The wire which is coloured green and yellow must be connected to
the terminal marked “E” (Earth) or coloured green.
•The wire which is coloured blue must be connected tothe terminal
marked “N” (Neutral) or coloured black.
•The wire which is coloured brown must be connected tothe
terminal marked “L” (Live), or coloured red.
Note: Use a 3A Fuse.
DOUBLE POLE
SWITCHED
FUSED SPUR OUTLET
USE A3AMP FUSE