ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5
3.0 PROGRAMMING
3.1 Using a security tool (CEECO part number 301-037, sold separately)
loosen and remove the security screws. Separate the telephone assembly
from the mounting or housing.
3.2 Looking at the rear of the phone, locate the multi-color ribbon cable,
which extends from the printed circuit board and has an open white
connector on the free end. Locate the separately packaged programming
keypad, which also has an open white connector attached to it. Connect
the programming keypad, via the white connectors.
3.3 Connect the Telephone to a working telephone line or a DTMF test set.
3.4 Locate the two plastic mini-jumpers on the corner of the Printed Circuit
Board and move them to the "ON" position, as depicted on the last page
of this manual.
3.5 Lift the handset and wait for dial tone. Utilizing the programming
keypad, enter # 9 7 on the keypad. This will clear all field programmable
memory.
NOTE: During programming it is essential to press the keys deliberately and
slowly. Missed or partial tones will result in improper programming. Also, the
Central Office will sometimes respond with fast busy, operator reorder, or other
such tones. Please ignore these and continue with programming, as the C.O.
tones will have no effect.
3.2 If the phone must automatically dial a number, when the handset is
lifted, enter # 1 9 on the programming keypad, followed by the desired
number of up to twenty-five (25) digits in length. Once programmed, this
number will always dial, when the handset is lifted.
EXAMPLE: Entering #1918005551212 on the programming keypad will
cause the phone to automatically dial the number 1-800-555-1212, when
the handset is lifted.
•Be sure to record your number in the Location #19 Table below for
future reference.
LOCATION #19 TABLE:
__ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __ __
3.3 If the phone must automatically dial a second number, when the handset
is lifted, enter # 2 0 on the programming keypad, followed by the desired
number of up to twenty-five (25) digits in length. In order for the phone
to dial the number stored in the #20 programming location, you must
select a “1” for Digit 1, under the #00 programming location (refer to next
section-3.7). You must also make selections for Digits 2 and 3
accordingly. Location #19 must be used in order to use Location #20.
