Checkpoint 730 User manual

Getting Started Guide
Check Point 730/750
Appliance
Locally Managed
Models: L-71, L-71W Classification: [Protected] P/N 707409

2
© 2017 Check Point Software Technologies Ltd.
All rights reserved. This product and related documentation
are protected by copyright and distributed under licensing
restricting their use, copying, distribution, and decompilation.
No part of this product or related documentation may be
reproduced in any form or by any means without prior written
authorization of Check Point. While every precaution has been
taken in the preparation of this book, Check Point assumes no
responsibility for errors or omissions. This publication and
features described herein are subject to change without notice.
RESTRICTED RIGHTS LEGEND:
Use, duplication, or disclosure by the government is subject to
restrictions as set forth in subparagraph (c)(1)(ii) of the Rights
in Technical Data and Computer Software clause at DFARS
252.227-7013 and FAR 52.227-19.
TRADEMARKS:
Refer to the Copyright page
http://www.checkpoint.com/copyright.html for a list of our
trademarks.
Refer to the Third Party copyright notices
http://www.checkpoint.com/3rd_party_copyright.html for a list
of relevant copyrights and third-party licenses.

3
Latest Documentation
The latest version of this document is at:
http://downloads.checkpoint.com/dc/download.htm?ID=46103
To learn more, visit the Check Point Support Center
http://supportcenter.checkpoint.com.
Feedback
Check Point is engaged in a continuous effort to improve its
documentation.
Please help us by sending your comments
mailto:[e-mail]?subject=Feedba
ck on Check Point 730/750 Appliance Locally Managed Getting
Started Guide.

4
Health and Safety
Information
Read these warnings before setting up or using the appliance.
Warning - Do not block air vents. A minimum
1/2-inch clearance is required.
Warning - This appliance does not contain any
user-serviceable parts. Do not remove any covers
or attempt to gain access to the inside of the
product. Opening the device or modifying it in any
way has the risk of personal injury and will void
your warranty. The following instructions are for
trained service personnel only.
Power Supply Information
To reduce potential safety issues with the DC power source,
only use one of these:
•The AC adapter supplied with the appliance.
•A replacement AC adapter supplied by Check Point.
•An AC adapter purchased as an accessory from Check
Point.

5
To prevent damage to any system, it is important to handle all
parts with care. These measures are generally sufficient to
protect your equipment from static electricity discharge:
•Restore the communications appliance system board and
peripherals back into the antistatic bag when they are not
in use or not installed in the chassis. Some circuitry on the
system board can continue operating when the power is
switched off.
•Do not allow the lithium battery cell used to power the
real-time clock to short. The battery cell may heat up
under these conditions and present a burn hazard.
Warning - DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH
SAME OR EQUIVALENT TYPE RECOMMENDED BY
THE MANUFACTURER. DISCARD USED
BATTERIES ACCORDING TO THE
MANUFACTURER’S INSTRUCTIONS.
•Do not dispose of batteries in a fire or with household
waste.
•Contact your local waste disposal agency for the address of
the nearest battery deposit site.
•Disconnect the system board power supply from its power
source before you connect or disconnect cables or install
or remove any system board components. Failure to do this
can result in personnel injury or equipment damage.
•Avoid short-circuiting the lithium battery; this can cause it
to superheat and cause burns if touched.
•Do not operate the processor without a thermal solution.
Damage to the processor can occur in seconds.

6
For California:
Perchlorate Material - special handling may apply. See
http://www.dtsc.ca.gov/hazardouswaste/perchlorate
The foregoing notice is provided in accordance with California
Code of Regulations Title 22, Division 4.5, Chapter 33. Best
Management Practices for Perchlorate Materials. This product,
part, or both may include a lithium manganese dioxide battery
which contains a perchlorate substance.
Proposition 65 Chemical
Chemicals identified by the State of California, pursuant to the
requirements of the California Safe Drinking Water and Toxic
Enforcement Act of 1986, California Health & Safety Code s.
25249.5, et seq. ("Proposition 65"), that is "known to the State
to cause cancer or reproductive toxicity." See
http://www.calepa.ca.gov.
WARNING:
Handling the cord on this product will expose you to lead, a
chemical known to the State of California to cause cancer, and
birth defects or other reproductive harm. Wash hands after
handling.

7
Declaration of Conformity
Manufacturer's Name: Check Point Software
Technologies Ltd.
Manufacturer's Address: 5 Ha'Solelim Street, Tel Aviv
67897, Israel
Declares under our sole responsibility, that the products:
Model Number: L-71, L-71W *
Product Options: 730, 730 WiFi, 750, 750 Wifi
Date First Applied: January 2016
Conform to the following Product Specifications:
RF/Wi-Fi (* marked model)

8
Certification Type
CE EMC,
European Standard EN 55032 & EN
55024.
EN61000-3-2:2014
EN61000-3-3:2013
EN61000-4-2:2009
EN61000-4-3:2006+A1:2008+A2:2010
EN61000-4-4:2012
EN61000-4-5:2014
EN61000-4-6:2014
EN61000-4-11:2004
EMC
AS/NZS CISPR 22:2009+A1 2010 Class
B
EMC
FCC part 15B , 47 CFR subpart B ,
Class B
ICES-003:2012 Issue 5 Class B
ANSI C63.4:2009
EMC
VCCI, V-3/2015.4 Class B, V4/2012.04 EMC
Draft ETSI EN 301 489-1 V2.2.0
(2017-03)
Draft ETSI EN 310 489-17 V3.2.0
(2017-03)
EMC

9
Certification Type
CE LVD: EN 60950-1 Safety
UL/c-UL: UL 60950-1 Safety
CB IEC 60950-1 Safety
AS/NZS 60950-1 Safety
ETSI EN 300 328 V2.1.1:2006
ETSI EN 300 893 V2.2.2 (2017-05)
RF/Wi-Fi *
RF exposure EN62311:2008, EN62479 RF/Wi-Fi *
RF exposure IC RSS-102 Issue 5:2015
IEEE C95.3-2002
KDB 447498D01
RF/Wi-Fi *
Canada RSS-247 Issue 1 (2015-05)
Canada RSS-Gen Issue 4 (2014-11)
ANSI C63.10:2013
RF/Wi-Fi *
47 CFR FCC Part15, Subpart C (section
15.247)
ANSI C63.10:2013
RF/Wi-Fi *
FCC Part 2 (Section2.1091)
KDB 447498 D01
RF/Wi-Fi *

10
Certification Type
47 CFR FCC Part 15, Subpart E
(Section 15.407)
ANSI C63.10:2013
RF/Wi-Fi *
AS/NZS 4268 RF/Wi-Fi *
JP ARIB STD-T66 (V3.7), MIC notice 88
Appendix 43
JP ARIB STD-T71 (V6.1), MIC notice 88
Appendix 45
RF/Wi-Fi *
Date and Place of Issue: January 2016, Tel Aviv, Israel
Federal Communications Commission (FCC) Statement:
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by