Chiayo COACH PRO User manual

Operation manual
CHIAYO ELECTRONICS CO., LTD.
COACH PRO
Personal Wireless Portable Amplifier

1
COACH PRO Personal Wireless Portable Amplifier
Congratulation and thank you for the purchase of this all-in-one ultra compact portable sound
system. To ensure a trouble-free operation, please read this manual thoroughly to fully
understand its controls and functions.
Configuration
Switch mode power supply
(100-240VAC DC:18V/2.7A)
Operation manual
Shoulder strap
Optional accessories
Receiver/MP3 recorder module
Wireless handheld or bodypack transmitter
Tripod stand (ST-30)
Storage bag (SB-41)
※Manufacturer reserves the rights to change the above combinations without prior notice.
Rear control panel
1.MP3 recorder player
2.IR sensor area
3.Power and volume control of
wireless microphone
4.Channel selector
5.RF signal indicator
6.Echo control
7.Emergency alarm
(2 sounds for selection)
8.Master volume control
9.Tone control
10.Volume control of audio input &
MP3 recorder
11.Power/Battery low indicator:
Normal(GREEN)/battery low(RED)
12.Power / Volume control of wired
microphone
13.Charging indicator: During
charging(RED)/Charging
finished(GREEN)
14.DC in
15.Aux output
16.Aux input
17.Wired microphone input
Recharge its inbuilt Lithium battery before first use
After unpacking the unit for the first time, please recharge the unit for about 4~5 hours before
operation. This is absolutely necessary as the built-in rechargeable battery might have been
discharged naturally due to long shipment and storage time, even though it had been fully
charged in the factory prior to shipment.
To charge the battery, just plug in the DC end of the switch mode power supply into the DC IN
⑭of the unit and charging will start automatically. During the charging process, the charging
indicator LED ⑬will be RED. When this LED turns GREEN, this battery is then fully charged.

2
Instructions
Battery maintenance
Battery should be charged regularly after every use or every month
Do not short, disassemble, heat or put the battery into a fire.
Do not solder a battery directly.
Be sure to use the specified type of battery.
Note the correct polarity when inserting a battery in the unit.
Avoid locations exposed to the direct sunlight, high temperature and high humidity when
storing batteries.
Operating procedures
To operate this portable sound unit, turn on
the main power switch ⑫and the power
indicator ⑪will be GREEN. If it turns RED, its
battery power might be too low and recharging
is necessary. The main power switch does not
switch on the wireless microphone and USB
digital recorder player as each of them has an
individual Power / Volume control.
Operating the built-in wireless microphone system
To use the wireless microphone, first turn on the main power switch
⑫, then turn on the WR power/volume control switch ③. Switch
on the corresponding transmitter and set this system to the same
frequency and RF signal LED ⑤will grow GREEN.
Operating the wired microphone
There is a MIC IN jack ⑰with dedicated volume control ⑫for this portable sound unit. To use
a wired microphone, just insert its phone plug into the MIC IN jack ⑰. Then turn on the
Power/volume control ⑫and rotate it to adjust the volume.
Operating the MP3 recorder player
1.USB 2.0 input
2.LCD display
3.Press to return to previous track, press and hold to fast reverse.
4.Press to play/pause or stop recording.
5.Press to go to next track, press and hold to fast forward.
6.Press to record.
7.Press to switch repeat modes.
8.Press to stop playing or recording.
12
345
678
remote control▲

COACH PRO Personal Wireless Portable Amplifier
Operating functions on the panel and the remote
Note:
Supports FAT and FAT32 file systems only.
Supports MP3, WAV and WMA music formats only
Record track format :MP3; Bit rate: 128kbps; Sampling frequency: 44kHz
Recordable only when USB is detected.
Record files will be stored in the RECORD folder of USB.
The files will be named as FILE_001, FILE_002, FILE_003…etc.
The name of a deleted track won’t be applied to its next one.
Recordable until FILE_999 appears with LCD displaying Num Full.
LCD displays USB FULL when insufficient memory left.
Don’t remove the USB during the recording process in case the interrupted track might be
damaged.
Operating function
On the panel
On the remote
Play/pause
Press
Record
Press to record and or to stop.
Press to record and or to stop.
Skip forward
Press
Press
Fast forward
Press and hold
Press and hold
Skip backward
Press
Press
Fast backward
Press and hold
Press and hold
Next folder
-
Press
Previous folder
-
Press
Track select (#0-9)
-
input track number, then press
Repeat mode switch
(ALL/SINGLE/FOLDER)
Press
Press
Volume control
-
Press or
A-B section play
-
Press to start, again to play section
and again to stop
Delete tracks
-
Press to delete track and again to
confirm your delete
Mute
-
press to mute/recover
CHIAYO ELECTRONICS CO.,LTD.
Http://www.chiayo.com.tw｜Email: [e-mail]
Office: 30, Lane 27, Section 4, Jen-Ai Road, Taipei 10685, Taiwan
Tel: [phone]｜Fax: [phone]
Factory: 88, Chung-Hsiao Street 2, Chiayi 60080, Taiwan
Tel: [phone]｜Fax: [phone]